HearthStone Morgan 8470 Bedienungsanleitung

©HearthStone Quality Home Heating Products, Inc.

www.hearthstonestoves.com

Revised: 10/6/2008 Page 1 of 7

Preparing the Morgan 8470 Wood Insert for Installation

(Refer to Owner’s Manual for the complete installation instructions)

1. Remove the contents within the firebox (owner’s manual, baffle and soapstone

refractory box) Remove the hang tag on the front door and place in the owner’s

manual). Note: Lift the baffle straight up while another person removes the box of

refractory stone then tip the baffle to remove it.

2. Using a ½” and 7/16” wrench, remove the left and right pallet

mounting clips. (Keep the ¼-20 bolt with a 7/16” head, as it will

be used to install the surround bracket), discard the pallet clips

and lag screws.

3. Remove the flue collar, which is installed upside down for

shipping.

4. Remove the ash lip assembly by loosening (NOT REMOVING)

the forward Phillips head screw on both sides of the assembly.

Pull the ash lip 3 or 4 inches away from the unit and disconnect

the wires from the snap disc. Ensure you do not damage the

blower

(

or its wirin

which is

re-installed under the ash li

Ash lip clamping

screw

©HearthStone Quality Home Heating Products, Inc.

www.hearthstonestoves.com

Revised: 10/6/2008 Page 2 of 7

Forward position Aft position

5. Remove the front façade by lifting and pulling away from the unit.

6. Open the large cardboard box

containing the surround kit. Locate

the left and right surround brackets.

Start the ¼-20 bolt through the

slotted opening on the surround

brackets, and attach to the sides of

the unit. Set the surround brackets in

the approximate position that the

surround will be in.

Surround bracket

(Right)

7. Determine the forward/aft position of the flue collar and remove the circle on the top heat shield

(shipped in the surround box) that will allow the flue collar to connect to the liner. (TIP: Ensure that the

connector you are using will fit through the opening in the top heat shield before installing the insert).

8. Install the top heat shield

Front facade

Flue collar shown in the aft position (you

will install it later

©HearthStone Quality Home Heating Products, Inc.

www.hearthstonestoves.com

Revised: 10/6/2008 Page 3 of 7

9. Place the unit in position, within the fireplace

10. Level the unit using a 9/16” and 7/16” wrench or ratchet on the three leveling bolts. (To level the rear

bolt, you must first loosen the jam nut at the base of the bolt)

Leveling bolts

©HearthStone Quality Home Heating Products, Inc.

www.hearthstonestoves.com

Revised: 10/6/2008 Page 4 of 7

11. Attach the liner (See Owner’s Manual for complete instructions)

a. Pull the flue liner into the firebox through the flue opening on top of the insert and

attach to the flue collar.

b. Locate the hardware kit in the firebox. Once attached to the liner, push the flue collar

up and attach to the under side of the top castings. Mount the flue collar with the four

¼-20 nuts and washers provided in the hardware kit.

Reversable Flue

(Front-Back)

This end up !

3/8"

Medium

density

gasket

12. Attach the surround to the unit. (The Owner’s Manual contains full instructions on how to install)

©HearthStone Quality Home Heating Products, Inc.

www.hearthstonestoves.com

Revised: 10/6/2008 Page 5 of 7

13. Mount the baffle in place

Note: The baffle material is a high temperature ceramic material. It will last for

years under normal use; however it can be easily damaged by impact or force.

BE CAREFUL IN HANDLING, TO APPLY PRESSURE TO THE TUBES AND CAST

IRON ONLY!

a. Place the baffle inside the stove with the ceramic board facing up, and the stainless

steel shelf tabs forward.

b. Lift the baffle and slide the baffle sleeves, on the rear of the baffle, into the slots on

the rear of the unit.

c. Push in until the sleeves are completely in the slots.

d. Gently lower the front of the baffle until the shelf tabs are resting on the side wall.

e. To verify that the baffle is in correct position, gently tug down on the front of the

baffle. If it does not come down. It is in the place.

Shelf tabs

Baffle

sleeves

14. Locate and mount the front door handle using the 3” bolt and lock washers provided.

©HearthStone Quality Home Heating Products, Inc.

www.hearthstonestoves.com

Revised: 10/6/2008 Page 6 of 7

15. Install the soapstone firebrick

a. LOCATE THE SIDE STONE RATAINER CLIPS (in the hardware kit) AND

REMOVE THE REAR STONE RETAINER CLIP FROM THE BACK (inside)

OF THE STOVE. (The rear clip is not shown below)

b. Put the four side stones in place and attach the retainer clips.

c. Put the three rear stones and reattach the long rear retainer clip.

d. Place the remaining stones on the floor of the unit referring to the figure

below.

Reference# Qty Size____

1 6 9” x 4-1/2”

2 5 9” x 4”

3 2 8-1/2” x 1-1/2”

Stone retainer

clips

1 1 1

2 2

3 3

©HearthStone Quality Home Heating Products, Inc.

www.hearthstonestoves.com

Revised: 10/6/2008 Page 7 of 7

16. The door to the Morgan is reversible. It can be opened from the left hand side, or the right. It will be

shipped from Hearthstone opening on the left hand side. To switch the door to open from the right, simply

remove the ash lip assembly and front facade.

a) Remove the ash lip assembly by loosening (NOT REMOVING) the forward Phillips head screw on

both sides of the assembly. Pull the ash lip 3 or 4 inches away from the unit and disconnect the

wires from the snap disc. Ensure you do not damage the blower (or its wiring) which is pre-

installed under the ash lip.

b) Remove the front façade by lifting and pulling away from the unit.

c) Remove the two Phillips head screws holding the door hinges on (use caution, once the last

screw is removed the door will be loose in your hands) be careful not to lose the two hinge

rivets. Using a Phillips head screwdriver, remove the door catch (There may be a spacer washer

behind the catch to provide an adequate seal. Remove the two screws where the hinges will go

on the left side. Rotate the door 180 degrees, put the hinges in place and mount them. Reattach

the door catch on the opposite side of the front, using the same screws and spacer washers if

necessary.

17. Replace the front façade by simply lifting it over the opened door and ash lip and setting it back in

place.

18. Replace the ash lip assembly. NOTE: Prior to replacing the ash

lip assembly, you must first ensure that the air control handle is

centered in its motion and that the blower’s snap disc wires are

reconnected. Lift and slide the assembly back on to the ash lip

clamping screws. Take care to avoid damaging the blower and its

wiring (ensure the blower’s power cord passes through the notch in the

ash lip casting). The ash lip is on when the back is tight to the front

façade. Once on, tighten the ash lip clamping screws.

Air control handle

Andere Handbücher für Morgan 8470

Inhaltsverzeichnis

Andere HearthStone Kamin im Innenbereich Handbücher

HearthStone

HearthStone CELESTE 60 Bedienungsanleitung

HearthStone

HearthStone Santa Fe Bedienungsanleitung

HearthStone

HearthStone WFP-75 Bedienungsanleitung

HearthStone

HearthStone 8491 Bedienungsanleitung

HearthStone

HearthStone Santa Fe 8761 Bedienungsanleitung

HearthStone

HearthStone DVI 44 Bedienungsanleitung

HearthStone

HearthStone Clydesdale II 8492 Bedienungsanleitung

HearthStone

HearthStone 8890 Bedienungsanleitung

HearthStone

HearthStone hase-Bari 8180 Bedienungsanleitung

HearthStone

HearthStone Morgan 8470 Bedienungsanleitung

HearthStone

HearthStone Stowe DX 8322 Bedienungsanleitung

HearthStone

HearthStone Morgan 8470 Bedienungsanleitung

HearthStone

HearthStone Hergom Clydesdale Bedienungsanleitung

HearthStone

HearthStone AURORA 8906 Series Sicherheitsleitfaden

HearthStone

HearthStone TUCSON Bedienungsanleitung

HearthStone

HearthStone 8323 Bedienungsanleitung

HearthStone

HearthStone Morgan 8470 Bedienungsanleitung

HearthStone

HearthStone CARINA Bedienungsanleitung

HearthStone

HearthStone Tucson (8700) Bedienungsanleitung

HearthStone

HearthStone Morgan 8470 Bedienungsanleitung

HearthStone

HearthStone ARIES 26 Bedienungsanleitung

HearthStone

HearthStone AURORA ECLIPSE VF 8906 Series Bedienungsanleitung

HearthStone

HearthStone 8491 Bedienungsanleitung

HearthStone

HearthStone Clydesdale 8490 Bedienungsanleitung

Beliebte Kamin im Innenbereich Handbücher anderer Marken

Brigantia

Brigantia 35-DVRS31N-2 Betriebsanleitung

Nordpeis

Nordpeis Bergen Bedienungsanleitung

Superior

Superior BCT2536TMN Bedienungsanleitung

Quadra-Fire

Quadra-Fire 5100I-GD-B Bedienungsanleitung

Renaissance

Renaissance RUMFORD 1000 Bedienungsanleitung

Lacunza

Lacunza IV-800 Bedienungsanleitung

Baxi

Baxi 940 Gebrauchsanweisung

Dru

Dru Maestro 60/2 Tall RCH Bedienungsanleitung

Diamond Fireglass

Diamond Fireglass SS-O22 Bedienungsanleitung

Napoleon

Napoleon ASCENT B42 Bedienungsanleitung

Enviro

Enviro E33GI Bedienungsanleitung

Smeg

Smeg L30 FABE Montageanleitung

KEDDY

KEDDY K700 Bedienungsanleitung

Godin

Godin 3451 Bedienungsanleitung

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Bedienungsanleitung

Desa

Desa CCFPDFT Bedienungsanleitung

Miles Industries

Miles Industries Vogue 1300IRN Handbuch

Regency Fireplace Products

Regency Fireplace Products Pro Series Kurzanleitung