Honeywell RP2B Bedienungsanleitung

RP2B/RP2D/RP4B/RP4D

Multi-Bay Battery Charger

Instructions

RP234MBC-EN-IN Rev C

5/18

Introduction

Honeywell’s Multi-Bay Battery Charger can fully charge up to

four lithium-ion batteries in less than eight hours. An RP2 bat-

tery typically takes 4 hours to fully charge, and an RP4 battery

takes 7 hours.

Multi-Bay Battery Charger Operation and Indicators

1. Connect the right angle power adapter to the Multi-Bay

Battery Charger. Then plug the power supply into an AC

power outlet. Make sure the AC power outlet voltage is the

same as the power supply.

Note: Use only a UL/cUL listed power supply with output rated

12Vdc. Contact your supplier for the appropriate power

supply for your location.



We recommend use of Honeywell approved power

adapters. Use of any non-Honeywell approved power

adapters may cause damage not covered by the warranty.

2. Place a battery into a cradle to charge with the battery

contacts facing the contacts on the charger.

3. When a battery is inserted, the solid red LED appears. If the

red LED does not appear or is flashing, check to make sure

the battery pack is seated completely in the charger with the

battery contacts facing the contacts on the charger.

4. When the battery is completely charged, the LED turns

green.

Operational temperature for charging the battery is 32° to

104°F (0° to 40°C). The storage temperature is -22° to 149°F (-

30° to 65°C).

About the Battery

Battery Recommendations

• Batteries are shipped approximately 30% charged or less and

should be fully charged for maximum charge capacity.

• The battery is a lithium ion cell and can be used without a full

charge, and can also be charged without fully discharging

without impacting the battery life. There is no need to perform

any charge/discharge conditioning on this type of battery.

• Do not disassemble the battery. There are no user-serviceable

parts in the battery.

• Do not allow metallic conductive objects to contact battery

terminals. Do not short-circuit a battery or throw it into a fire;

it can explode and cause severe personal injury.

• Improper battery use may result in a fire, explosion, or other

hazard.

• Although your battery can be recharged many times, it will

eventually be depleted. Replace it after the battery is unable to

hold an adequate charge.

• If you are not sure if the battery or charger is working properly,

send it to Honeywell International Inc. or an authorized service

center for inspection. Refer to Technical Assistance for

additional information.

Use only Honeywell Li-ion battery packs 50133975-

001 or 550053-000 in this device. Use of any non-

Honeywell battery may result in damage not covered

by the warranty.

Proper Disposal of the Battery

When the battery has reached the end of its useful life,

the battery should be disposed of by a qualified recy-

cler or hazardous materials handler. Do not incinerate

the battery or dispose of the battery with general waste

materials. You may send the scanner’s battery to us.

(postage paid). The shipper is responsible for complying with all

federal, state, and local laws and regulations related to the

packing, labeling, manifesting, and shipping of spent batteries.

Contact Product Service and Repair for recycling or disposal

information. Since you may find that your cost of returning the

batteries significant, it may be more cost effective to locate a

local recycle/disposal company.

Cleaning the Multi-Bay Battery Charger

Unplug the Multi-Bay Battery Charger from the power supply

before cleaning.

Clean the housing of the Multi-Bay Battery Charger with a soft

cloth or tissue dampened with water (or a mild detergent- water

solution). If a detergent solution is used, rinse with a clean tis-

sue dampened with water only.

Never use solvents (e.g., alcohol or acetone) on the

housing. Solvents may damage the finish.

Disclaimer

Honeywell International Inc. (“HII”) reserves the right to make

changes in specifications and other information contained in

this document without prior notice, and the reader should in all

cases consult HII to determine whether any such changes have

been made. The information in this publication does not repre-

sent a commitment on the part of HII.

HII shall not be liable for technical or editorial errors or omis-

sions contained herein; nor for incidental or consequential

damages resulting from the furnishing, performance, or use of

this material. HII disclaims all responsibility for the selection

and use of software and/or hardware to achieve intended

results.

This document contains proprietary information that is pro-

tected by copyright. All rights are reserved. No part of this docu-

ment may be photocopied, reproduced, or translated into

another language without the prior written consent of HII.

Web Address: www.honeywellaidc.com

Customer Support

Technical Assistance

To search our knowledge base for a solution or to log in to the

Technical Support portal and report a problem, go to

www.hsmcontactsupport.com.

Product Service and Repair

Honeywell International Inc. provides service for all of its prod-

ucts through service centers throughout the world. To obtain

warranty or non-warranty service, you must first obtain a Return

Material Authorization number (RMA #) and then return your

product to Honeywell (postage paid) with a copy of the dated

purchase record.

To learn more, go to www.honeywellaidc.com and select Service

& Repair at the bottom of the page.

Limited Warranty

For warranty information, go to www.honeywellaidc.com and

click Get Resources > Product Warranty.

Andere Handbücher für RP2B

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Honeywell Akkuladegerät Handbücher

Honeywell

Honeywell Impact Series Gebrauchsanweisung

Honeywell

Honeywell Marathon Bedienungsanleitung

Honeywell

Honeywell QuadCharger Bedienungsanleitung

Honeywell

Honeywell MB4-BAT-SCN02 Bedienungsanleitung

Honeywell

Honeywell ChargeBase CT40-CB Bedienungsanleitung

Honeywell

Honeywell COB01 Bedienungsanleitung

Honeywell

Honeywell 012168 Gebrauchsanweisung

Honeywell

Honeywell MX9 Bedienungsanleitung

Honeywell

Honeywell Dolphin 7900 Bedienungsanleitung

Honeywell

Honeywell 70e-BTSC Bedienungsanleitung

Honeywell

Honeywell Dolphin 9500 Bedienungsanleitung

Honeywell

Honeywell M5-C01 Series Bedienungsanleitung

Honeywell

Honeywell CT50-HB Bedienungsanleitung

Honeywell

Honeywell Captuvo SL22 Bedienungsanleitung

Honeywell

Honeywell CX80-NB Bedienungsanleitung

Honeywell

Honeywell HomeBase D7900 Bedienungsanleitung

Honeywell

Honeywell Xenon Ultra 196 Series Bedienungsanleitung

Honeywell

Honeywell 010690.01 Gebrauchsanweisung

Honeywell

Honeywell PEHA 1602/2 Handbuch

Honeywell

Honeywell Intermec AC18 Bedienungsanleitung

Honeywell

Honeywell Dolphin CT40 Bedienungsanleitung

Honeywell

Honeywell CT50-QBC Bedienungsanleitung

Honeywell

Honeywell 057530.10 Gebrauchsanweisung

Honeywell

Honeywell 8670 Bedienungsanleitung

Beliebte Akkuladegerät Handbücher anderer Marken

AA Portable Power Corp

AA Portable Power Corp Universal Smart Charger Bedienungsanleitung

Enelion

Enelion Vertica Bedienungsanleitung

RCA

RCA CHU6 Bedienungsanleitung

ANSMANN

ANSMANN ALCT 6/24-10 Bedienungsanleitung

Hitachi

Hitachi UC 18YRSL Fehlerbehebungshandbuch

Olympus

Olympus B-20 LPC Bedienungsanleitung

Exibel

Exibel ZH1708143 Bedienungsanleitung

Lenmar

Lenmar Mach 1 Bedienungsanleitung

CTEK

CTEK MXS 5.0 Bedienungsanleitung

ABB

ABB HT842379 Bedienungsanleitung

Nitecore

Nitecore Superb Charger SC4 Bedienungsanleitung

Renogy

Renogy RBC2125DS-21W Bedienungsanleitung

Braun

Braun BWC02M Bedienungsanleitung

CTEK

CTEK MXS 3.6 Bedienungsanleitung

Black & Decker

Black & Decker BDV090 Bedienungsanleitung

Trinity

Trinity DPD Bedienungsanleitung

Hulkman

Hulkman Sigma 1 Bedienungsanleitung

IKEA

IKEA koppla Bedienungsanleitung