Honeywell Silent Knight IDP-Monitor-2 Bedienungsanleitung

Mounting

Mounts directly to 4˝ square electrical boxes (see Figure

2A). The box must have a minimum depth of 21/8˝.

Surface mounted electrical boxes (SMB500) are available

from Silent Knight.

Wiring

NOTE: All wiring must conform to applicable local

codes, ordinances, and regulations. This module is in-

tended for power limited wiring only.

1. Install module wiring in accordance with the job draw-

ings and appropriate wiring diagrams.

2. Set the address on the module per job drawings.

Note: Monitor module L (using terminals 6 and 7) re-

sponds at the address set on the code switches. Monitor

module H (using terminals 8 and 9) will automatically

respond at the next higher address. For example, if the

code switches are set to 76, module L will respond at

address 76 and module H will respond at address 77.

Use caution to avoid duplicate addressing of modules

on the system.

3. Secure module to electrical box (supplied by installer),

as shown in Figure 2A.

TENS

ONES ADDRESS

LOOP

K200-13-00 1 I56-2730-002

IDP-Monitor-2

Dual Monitor Module

INSTALLATION AND MAINTENANCE

INSTRUCTIONS

Before Installing

This information is included as a quick reference instal-

lation guide. Refer to the control panel installation man-

ual for detailed system information. If the modules will

be installed in an existing operational system, inform the

operator and local authority that the system will be tem-

porarily out of service. Disconnect power to the control

panel before installing the modules.

NOTICE: This manual should be left with the owner/

user of this equipment.

General Description

The Dual Monitor Module is intended for use in intel-

ligent, two wire systems. It provides two independent

2-wire initiating device circuits (IDC), at two separate,

consecutive addresses. It is capable of monitoring nor-

mally open contact fire alarm and supervisory devices, or

either normally open or normally closed security devices.

The module has a single panel controlled red LED.

Compatibility Requirements

To ensure proper operation, this module shall be con-

nected to a compatible Silent Knight system control panel

(list available from Silent Knight).

Figure 2A.

Module mounting:

Figure 2B:

Specifications

Normal Operating Voltage: 15 to 32 VDC

Maximum Current Draw: 5.7 mA (LED on)

Average Operating Current: 750µA (LED flashing)

EOL Resistance: 47K Ohms

Max. IDC wiring resistance: 1,500 Ohms

Temperature Range: 32˚F to 120˚F (0˚C to 49˚C)

Humidity: 10% to 93% Non-condensing

Dimensions: 41/2˝ H x 4˝ W x 11/4˝ D

(Mounts to a 4˝ square by

21/8˝ deep box.)

Accessories: SMB500 Electrical Box

Figure 1. Controls and Indicators:

C0157-00

C0156-00

C0218-01

56789

TENS

ONES

ADDRESS

LOOP

ONES

ADDRESS

TENS

789

7 8

FROM PANEL OR

(+)

(–)

TO NEXT

(+)

(–)

DEVICE

(+)

(–)

MONITOR

CONNECT MODULESTO LISTED COMPATIBLE

32 VDC MAX.

SHIELDED-TWISTED PAIR

IS RECOMMENDED

SILENT KNIGHT CONTROL PANELS ONLY

PREVIOUS DEVICE

SIGNAL LINE CIRCUIT (SLC)

MONITOR A (TERMINALS 6 & 7) RESPONDS AT ADDRESS

SET ON CODE SWITCHES. MONITOR B (TERMINALS 8 & 9)

RESPONDS AT NEXT HIGHER ADDRESS.

ANY NUMBER OF UL LISTED CONTACT CLOSURE

DEVICES MAYBE USED. DO NOT MIX FIRE

ALARM INITIATING, SUPERVISORY

, OR SECURITY

DEVICES ON THE SAME INITIATING DEVICE CIRCUIT.

INSTALL CONTACT CLOSURE DEVICES PER

MANUFACTURER'S INSTALLATION INSTRUCTIONS.

47 K EOL

RESISTOR

ELR-47K

MODULE

47 K EOL

RESISTOR

ELR-47K

5 4

TENS

ONES

ADDRESS

LOOP

TWO INITIATING DEVICE CIRCUITS (L & H),

EACH POWER LIMITED TO 230 A @ 12VDC MAX.

ALL WIRING SHOWN IS SUPERVISED AND POWER LIMITED

K200-13-00 2 I56-2730-002

Figure 3. Typical 2-wire initiating circuit configuration, NFPA Style B:

C0809-01

7550 Meridian Circle

Maple Grove, MN 55369-4927

763-493-6455; 800-328-0103

Fax: 763-493-6475

http://www.silentknight.com

Andere Honeywell Steuereinheit Handbücher

Honeywell

Honeywell V800 Bedienungsanleitung

Honeywell

Honeywell NOTIFIER M701E Bedienungsanleitung

Honeywell

Honeywell 7800 SERIES Bedienungsanleitung

Honeywell

Honeywell VR8305 Installationsanleitung

Honeywell

Honeywell R7795A Bedienungsanleitung

Honeywell

Honeywell BSM Montageanleitung

Honeywell

Honeywell MAXON 8730 Series Bedienungsanleitung

Honeywell

Honeywell S7800A1167 Bedienungsanleitung

Honeywell

Honeywell BA295I Bedienungsanleitung

Honeywell

Honeywell D22 Bedienungsanleitung

Honeywell

Honeywell BA295D-3WH Bedienungsanleitung

Honeywell

Honeywell RV283P Bedienungsanleitung

Honeywell

Honeywell RV181 Bedienungsanleitung

Honeywell

Honeywell 7800 SERIES Bedienungsanleitung

Honeywell

Honeywell SK-Mon-10 Bedienungsanleitung

Honeywell

Honeywell 7800 SERIES Bedienungsanleitung

Honeywell

Honeywell SILENT KNIGHT SK-FML Bedienungsanleitung

Honeywell

Honeywell JADE W7220 Bedienungs- und Wartungshandbuch

Honeywell

Honeywell SILENT KNIGHT SK-Control-6 Bedienungsanleitung

Honeywell

Honeywell V5055A Bedienungsanleitung

Honeywell

Honeywell R7140G Bedienungsanleitung

Honeywell

Honeywell D05T Bedienungsanleitung

Honeywell

Honeywell V5004TF Bedienungsanleitung

Honeywell

Honeywell V4295A,S Bedienungsanleitung

Beliebte Steuereinheit Handbücher anderer Marken

Festo

Festo Compact Performance CP-FB6-E Stücklistenhandbuch

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung

JS Automation

JS Automation MPC3034A Bedienungsanleitung

JAUDT

JAUDT SW GII 6406 Series Kurzanleitung

Spektrum

Spektrum Air Module System Bedienungsanleitung

BOC Edwards

BOC Edwards Q Series Bedienungsanleitung

KHADAS

KHADAS BT Magic Bedienungsanleitung

Etherma

Etherma eNEXHO-IL Bedienungsanleitung

PMFoundations

PMFoundations Attenuverter Bedienungsanleitung

GEA

GEA VARIVENT Bedienungsanleitung

Walther Systemtechnik

Walther Systemtechnik VMS-05 Bedienungsanleitung

Altronix

Altronix LINQ8PD Montageanleitung

Eaton

Eaton Powerware Series Bedienungsanleitung

WAGO

WAGO 750-407/040-000 Bedienungsanleitung

Sony

Sony CCU-590 Bedienungsanleitung

Graco

Graco 25D614 Bedienungsanleitung

Task Force Tips

Task Force Tips YE-RF-900 Programmierhandbuch

Shini

Shini SPV-U Series Bedienungsanleitung