Honeywell BW Ultra Bedienungsanleitung

Honeywell BW ™ Ultra

Quick

Reference

Guide

| Gas Detection

Portable Five-gas Detector

with Internal Pump

ENGLISH

For Sales & Service Contact

2650 E. 40th Ave. • Denver, CO 80205

Phone 303-320-4764 • Fax 303-322-7242

1-800-833-7958

www.geotechenv.com

ENGLISH

Introduction

The Honeywell BW ™ Ultra gas detector warns of

hazardous gas at levels above user-deﬁned alarm

setpoints.

The detector is a personal safety device. It is your

responsibility to respond properly to the alarm.

Monitored Gases

The detector can monitor up to ﬁve gases at a time.

Refer to the Honeywell BW ™ Ultra User Manual for the full

list of gases.

What’s in the Box

• Honeywell BW ™ Ultra gas

detector

• Quick Reference Guide

• Battery (factory-installed) • Screwdrivertelescopewithdoubleend

• Charging adapter • 3m PVC tube

• 1 Dust porous ﬁlter 7/16” • 2Fittingmini quick connector to1/8”

• 5 Pump ﬁlters • 2 Fitting male LuerLock to 1/8”

• USB memory stick

containing user manuals

• 1 screen protector (factory-installed)

Safety Information

Use the detector only as speciﬁed in this manual,

otherwise, the protection provided by the detector may be

impaired.

• Only the instrument capable of sounding the alarms and showing readings

on a display should be used for immediate safety critical use. Wireless

communication and infrastructure are only for informational monitoring.

• Useonly HoneywellHUBATbattery pack.Usingany otherbatterycancause

an explosion or ﬁre.

• Deactivatingthedetector by removingthe battery packmay cause improper

operation and harm the detector.

• Use only Honeywell approved battery chargers such as the MultiUnit

Cradle Charger.

• Ifusingthedetector near its upperorloweroperatingtemperature,Honeywell

recommends zeroing or activating the detector in that environment.

• Charge the detector before first-time use. Honeywell recommends the

detector also be charged after every workday.

• Calibrate the device on a regular schedule, depending on use and sensor

exposure to poisons and contaminants. Honeywell recommends calibrating

at least once every six months.

• Foroptimalperformance,periodicallyzerothesensorinanormalatmosphere

(20.9% v/v O) that is free of hazardous gas.

• The combustible sensor is factory calibrated to 50% LEL methane. If

monitoring a different combustible gas in the % LEL range, calibrate the

sensor using the appropriate gas.

• Onlythecombustiblegasdetectionportionof this detector has been assessed

for performance by CSA International.

• Honeywell recommends that the combustiblesensorischeckedwitha known

concentrationofcalibrationgasafter anyexposuretocontaminants/poisons

such as sulfur compounds, silicone vapors, halogenated compounds, etc.

ENGLISH

• Honeywell recommends that the sensors be bump tested before each day’s

usetoconﬁrm their abilityto respond togas.Manually verifythatthe audible,

visual, and vibrator alarms are activated. Calibrate if the readings are not

within the speciﬁed limits.

• Portablesafetygas detectors arelifesafetydevices.The accuracy ofambient

gasreading(s)is dependent uponfactorssuchas accuracy ofthe calibration

gas standard used for calibration and frequency of calibration.

• The detector is designed for use only in potentially explosive atmospheres

where oxygen concentrations do not exceed 20.9% (v/v). Oxygen deﬁcient

atmospheres (<10% v/v) may suppress some sensor outputs.

• Extendedexposureofthe detector tocertainconcentrations of combustible

gases and air may stress the detector element and seriously affect its

performance. If an alarm occurs due to a high concentration of combustible

gases, a calibration should be performed. If necessary, replace the sensor.

• High concentrations of certain toxic gases, for example, H2S, may hurt the

LEL sensor. This effect, known as inhibition, is usually temporary but in

extreme circumstances can impair the sensitivity of the LEL sensor after

any gas exposure that causes alarm in the toxic gas sensors.

• TheHoneywell BW™ Ultra isprovidedwith an antistaticcoatingover the LCD

windowtominimizetheriskof ignition due toelectrostaticdischarge.Periodic

inspectionofthiscoating is requiredtoensurenodegradation, delamination,

abrasions or other deformities to this surface.

• Care must be taken to avoid exposure to excessive heat, harsh chemicals

or solvents, sharp edges and abrasive surfaces. Clean the exterior with a

soft, damp cloth.

• The Canadian Standards Association (CSA) requires the LEL sensor to be

bump tested before each day’s use with calibration gas containing between

25% and 50% LEL. The instrument must be calibrated if the displayed

LEL value during a bump test fails to fall between 100% and 120% of the

expected value for the gas.

aWARNINGS

• Warning: Substitution of components may impair Intrinsic Safety.

• To prevent ignition of ﬂammable or combustible atmospheres, disconnect

power before servicing.

• Protectthecombustiblesensorfrom exposuretolead compounds, silicones,

and chlorinated hydrocarbons. Although certain organic vapors (such as

leaded gasoline and halogenated hydrocarbons) can temporarily inhibit

sensor performance, in most cases the sensor will recover after calibration.

• Caution:Highoff-scaleLELreadingsmayindicateanexplosiveconcentration.

• Any rapid up scaling reading followed by a declining or erratic reading may

indicate a gas concentration beyond the upper scale limit, which can be

hazardous.

• Products may contain materials that are regulated for transportation under

domesticand internationaldangerous goodsregulations. Returnproduct in

compliance with appropriate dangerous goods regulations. Contact freight

carrier for further instructions.

• The lithium battery may present a risk of ﬁre or chemical burn hazard if

misused. Do not disassemble, incinerate, or heat above 212°F (100°C), or

incinerate.Batteries must only be charged in a safe area free of hazardous

gas.Batteries eexposed to heatat 266°F (130°C)for10 minutes cancause

ﬁre and explosion.

• Disposeofused lithium cellsimmediately.Donot mix batterieswith thesolid

waste stream. Spent batteries should be disposed of by a qualiﬁed recycler

or hazardous materials handler.

ENGLISH

a MISES EN GARDE

• Avertissement : Le remplacement d’un composant de l’appareil peut altérer

sa sécurité intrinsèque.

• Pour éviter l’inﬂammation d’atmosphères inﬂammables ou combustibles,

couper l’alimentation électrique avant tout entretien.

• Avertissement: Pour réduire le risque d’ignition dans les atmosphères

inflammables, les piles doivent être chargées in a dans une zone sûre,

exempte de gaz dangereux.

• Protégez le capteur de gaz combustibles contre toute exposition aux

composés de plomb, aux silicones et aux hydrocarbures chlorés. Bien

que certaines vapeurs organiques (comme l’essence au plomb ou les

hydrocarbures halogénés) puissent neutraliser provisoirement les

performances du capteur, dans la plupart des cas, le capteur retrouvera

son fonctionnement normal après l’étalonnage.

• Attention: Des valeursLIE hors échelleélevées peuvent indiquerla présence

d’une concentration explosive.

• Toute mesure en rapide augmentation suivie d’une diminution ou d’une

mesure fantaisiste peut indiquer une concentration de gaz au-delà de la

limite d’échelle supérieure, risquant donc d’être dangereuse.

• Les produits peuvent contenir des matériaux qui sont réglementés pour

le transport en vertu des règlements nationaux et internationaux de

marchandises

• dangereuses. Retourner le produit conformément à la réglementation sur

les marchandises dangereuses appropriées. Contactez transporteur pour

plus d’instructions.

• Avertissement: La batterie au lithiumpeut présenter un risque d’incendieou

de brûlure chimique en cas de mauvaise utilisation. Elle ne doit jamais être

démontée, incinérée ni chauffée au-delà de 100 °C.

• Avertissement: Les pilesau lithiumpolymèreexposéesà une température

supérieure à 130 °C pendant plus de 10 minutes peuvent provoquer un

incendie et/ou une explosion.

• Mettez immédiatement au rebut les batteries au lithium usagées. Ne pas

les mélanger aux autres déchets solides. Les piles usagées doivent être

éliminées par un centre de recyclage agréé ou un centre de traitement

des matières dangereuses.

ENGLISH

Appearance

1. Visual alarm

indicator

2. Exhaust port

3. Screen

4. Button

5. Beeper Aperture

6. Pump inlet

7. Alligator clip

8. Pump assembly

9. Charging

connector and IR

Interface

Screen Icons

Several icons are displayed in the detector’s screen as

conditions dictate.

BW ULTRA

Andere Handbücher für BW Ultra

Inhaltsverzeichnis

Sprachen:

Andere Honeywell Gaswarngerät Handbücher

Honeywell

Honeywell SPM Flex Bedienungsanleitung

Honeywell

Honeywell SEARCHZONE SONIK SZSK-SMG Series Bedienungsanleitung

Honeywell

Honeywell Notifier NCO-10 Bedienungsanleitung

Honeywell

Honeywell BW MaxXT II Bedienungsanleitung

Honeywell

Honeywell FS20X Series Bedienungsanleitung

Honeywell

Honeywell BW Technologies GasAlertMicro 5 Bedienungsanleitung

Honeywell

Honeywell Searchline Excel Open-Path Versionshinweis

Honeywell

Honeywell E3Point Bedienungsanleitung

Honeywell

Honeywell RAEGuard Lite Bedienungsanleitung

Honeywell

Honeywell SEARCHLINE EXCEL PLUS Bedienungsanleitung

Honeywell

Honeywell Searchpoint Optima Plus Benutzerhandbuch

Honeywell

Honeywell BW GasAlertMicro Bedienungsanleitung

Honeywell

Honeywell PHD6 Referenzhandbuch

Honeywell

Honeywell Apex Versionshinweis

Honeywell

Honeywell BW Technologies GasAlertMicro 5 Bedienungsanleitung

Honeywell

Honeywell BW GasAlertMicro 5 Bedienungsanleitung

Honeywell

Honeywell MultiRAE Bedienungsanleitung

Honeywell

Honeywell 04230-A-1001 Versionshinweis

Honeywell

Honeywell AreaRAE Plus Bedienungsanleitung

Honeywell

Honeywell Touchpoint Plus Versionshinweis

Honeywell

Honeywell Searchpoint Optima Plus Bedienungsanleitung

Honeywell

Honeywell Sensepoint XCL Bedienungsanleitung

Honeywell

Honeywell BW Flex Series Bedienungsanleitung

Honeywell

Honeywell BW RigRat Bedienungsanleitung

Beliebte Gaswarngerät Handbücher anderer Marken

Macurco

Macurco GD-6 Bedienungsanleitung

Evikon

Evikon E2632 Bedienungsanleitung

Critical Environment Technologies

Critical Environment Technologies CGAS-A Series Bedienungsanleitung

MSA

MSA altair 5 Bedienungsanleitung

DOD Technologies

DOD Technologies ChemLogic CL96 Bedienungsanleitung

DEGA

DEGA NS III LCD Series Bedienungsanleitung

RKI Instruments

RKI Instruments 35-3001A-08-01 Bedienungsanleitung

Sygonix

Sygonix 2483186 Bedienungsanleitung

Perry

Perry 1GA 50917MET/P Bedienungsanleitung

isweek

isweek AS8900 Bedienungsanleitung

Oldham

Oldham OLC 10 Bedienungsanleitung

Wizmart

Wizmart NB983 Bedienungsanleitung

Beacon

Beacon MEGA Handbuch

RKI

RKI GX-6000 Bedienungsanleitung

Dräger

Dräger PIR 7000 Bedienungsanleitung

GDS

GDS GASMAX EC Bedienungsanleitung

Seitron

Seitron BE COOL R1 Bedienungsanleitung

MSA

MSA ULTIMA X5000 Bedienungsanleitung