Honeywell RTH2410 Series Bedienungsanleitung

RTH2510/RTH2410

Programmable Thermostat

Quick Installation Guide

69-2421ES-03

69-2421ES—03 ii

Quick Installation Guide

Identify System Type

This thermostat is compatible with the following systems:

Gas, oil or electric furnace•

Central air conditioner•

Hot water system with or without pump•

Millivolt system•

Central heating and cooling system•

Heat pump without auxiliary/backup heat•

Heat pump with auxiliary/backup heat•

Do you need assistance?

We are here to help.

Call 1-800-468-1502.

This thermostat cannot be used on multistage systems.

1 69-2421ES—03

RTH2510/RTH2410

1Turn Off Power to Heating/

Cooling System

M28097

69-2421ES—03 2

Quick Installation Guide

M28099

Old thermostat

Cover

Remove old thermostat but leave wallplate with

wires attached.

Remove Old Thermostat

Do not remove

wallplate yet

MERCURY NOTICE

Do not put your old thermostat

in the trash if it contains

mercury in a sealed tube.

Contact your local waste

management authority for

instructions regarding recycling

and proper disposal.

3 69-2421ES—03

RTH2510/RTH2410

If any wires are not attached to your old thermostat or are

attached to a terminal marked Cor C1, they will not be

connected to your new thermostat. Wrap the bare metal

end of each of these wires with electrical tape, so it can-

not touch and short other wires.

Identify Wires

M29988

Disconnect wires and remove the old wallplate only after

all wires are labeled. Wrap the wires around a pencil to

prevent them from falling though the wall opening.

Do not use non-connected

wires.

Do not use C or C1 wires.

Identify and label each wire.

IGNORE WIRE COLORS:

Use terminal screw

designations to identify

wires.

69-2421ES—03 4

Quick Installation Guide

Mount New Wallplate

Loosen the locking screw at the bottom of the1. thermostat. Note that the screw is captive and cannot

be removed from the wallplate.

Separate the thermostat from the wallplate as per2. Figure 1.

Position the wallplate against the wall and mark hole3. positions with a pencil.

NOTE: Levelling is for esthetics only and will not affect

the performance of the thermostat.

Drill holes at the marked positions and insert supplied4. wall anchors.

Pass the wires through the large opening located at5. the bottom center of the wallplate as per Figure 2.

Secure the wallplate to the wall with supplied mounting6. screws as per Figure 3.

Connect the wires to the terminals.7.

Figure 1 Figure 2 Figure 3

5 69-2421ES—03

RTH2510/RTH2410

O/B Y RC R G W/AUX

M32148

REMOVE JUMPER

IF YOU HAVE BOTH

RAND RC WIRES

Match each labeled wire with the terminal having the1. same letter.

Connect Wires:

Conventional Systems

(typical wiring)

Loosen the terminal screws using a screwdriver, insert2. the wires, then tighten the screws.

Push any excess wire back into the wall opening.3.

Labels don’t match? See page 6.

Have a heat pump with auxiliary/backup heat, see pages 7-8.

•Call1-800-468-1502forwiringassistance

69-2421ES—03 6

Quick Installation Guide

Connect Wires:

Conventional Systems

(alternate wiring)

M32149A

REMOVE JUMPER BETWEEN RAND RC IF YOU HAVE

WIRES ON BOTH RAND RC.

DO NOT USE C, C1, OR X WIRE. DO NOT USE B WIRE

IF YOU ALREADY HAVE 0 WIRE. WRAP BARE END OF

WIRE WITH ELECTRICAL TAPE.

PLACE A JUMPER (PIECE OF WIRE) BETWEEN Y AND

W/AUX IF YOU ARE USING A HEAT PUMP WITHOUT

AUXILIARY/BACKUP HEAT.

O/B Y RC R G W/AUX

2 33

7 69-2421ES—03

RTH2510/RTH2410

Match each labeled wire with the terminal having the1. same letter.

Connect Wires: Heat Pump

Systems with Auxiliary/Backup

Heat (typical wiring)

Loosen the terminal screws using a screwdriver, insert2. the wires, then tighten the screws.

Push any excess wire back into the wall opening.3.

Labels don’t match? See page 8.

M32150A

O/B Y RC R G W/AUX

69-2421ES—03 8

Quick Installation Guide

Connect Wires: Heat Pump

Systems with Auxiliary/Backup

Heat (alternate wiring)

M32151A

O/B Y RC R G W/AUX

LEAVE JUMPER IN PLACE, CONNECTING R AND RC.

THIS THERMOSTAT CANNOT BE USED IF YOUR OLD THERMOSTAT

HAD ANY TWO OF THE FOLLOWING WIRES R, RC, V, OR VR.

DO NOT USE C OR X WIRE. DO NOT USE B WIRE IF YOU ALREADY

HAVE O WIRE. WRAP BARE END OF WIRE WITH ELECTRICAL TAPE.

DO NOT USE L WIRE. WRAP BARE END OF WIRE WITH ELECTRICAL

TAPE.

IF YOUR OLD THERMOSTAT HAD SEPARATE O AND B WIRES, WRAP

THE B WIRE IN ELECTRICAL TAPE AND DO NOT CONNECT.

IF YOUR OLD THERMOSTAT HAD Y1, W1 AND W2 WIRES, STOP NOW

AND CONTACT A QUALIFIED CONTRACTOR FOR HELP.

IF YOUR OLD THERMOSTAT HAD E AND AUX WIRES (OR

ALTERNATE WIRES), CONNECT BOTH WIRES TO AUX TERMINAL.

7435

6 7

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Honeywell Thermostat Handbücher

Honeywell

Honeywell PRESTIGE THX9321 Bedienungsanleitung

Honeywell

Honeywell TC500A-N Bedienungsanleitung

Honeywell

Honeywell TRADELINE Q7300H Series Benutzerhandbuch

Honeywell

Honeywell T Series Bedienungsanleitung

Honeywell

Honeywell FocusPRO TH6220D Bedienungsanleitung

Honeywell

Honeywell Lyric T6 Bedienungsanleitung

Honeywell

Honeywell CM927 Bedienungsanleitung

Honeywell

Honeywell T6570 Series Bedienungsanleitung

Honeywell

Honeywell Q682B Bedienungsanleitung

Honeywell

Honeywell T9 Bedienungsanleitung

Honeywell

Honeywell T87F Montageanleitung

Honeywell

Honeywell TROL-A-TEMP Q674B Bedienungsanleitung

Honeywell

Honeywell T8524 Deluxe Bedienungsanleitung

Honeywell

Honeywell T8602C Bedienungsanleitung

Honeywell

Honeywell WebStat T7350 Benutzerhandbuch

Honeywell

Honeywell PROGRAMMABLE THERMOSTAT RTH6350 Bedienungsanleitung

Honeywell

Honeywell T7300F Bedienungsanleitung

Honeywell

Honeywell Y9420H Sundial RF2 Bedienungsanleitung

Honeywell

Honeywell RTH3100C Bedienungsanleitung

Honeywell

Honeywell RTHL2310 series Bedienungsanleitung

Honeywell

Honeywell T8000 Bedienungsanleitung

Honeywell

Honeywell CM61 Bedienungsanleitung

Honeywell

Honeywell EasyStat T8400A1002 Systemhandbuch

Honeywell

Honeywell CMT707 Bedienungsanleitung

Beliebte Thermostat Handbücher anderer Marken

EWELLY

EWELLY EW-181 Bedienungsanleitung

Prolon

Prolon T1100 Montageanleitung

Computherm

Computherm Q20 Bedienungsanleitung

Heatmiser

Heatmiser neoStat Bedienungsanleitung

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Bedienungsanleitung

Saswell

Saswell SAS920XWHB-7-S-RF Leitfaden

Aircalo

Aircalo TFP1-ET85P2 Bedienungsanleitung

Carrier

Carrier DEBONAIR 33CS Bedienungsanleitung

Lennox

Lennox iHarmony Zone Thermostat Montageanleitung

Gemtech

Gemtech GT7000 Bedienungsanleitung

Rollei

Rollei Smartes 45000 Bedienungsanleitung

Sinope

Sinope TH1300RF Bedienungsanleitung

NuTone

NuTone NTBZ48 Original Betriebsanleitung

Stelpro

Stelpro MAESTRO ASMT402AD Bedienungsanleitung

Aube Technologies

Aube Technologies TH305 Bedienungsanleitung

Powtier Controls

Powtier Controls 505MST Bedienungsanleitung

Kanmor

Kanmor Zone Control 369e Bedienungsanleitung

MICROclimate International

MICROclimate International B2 Magic Eye Bedienungsanleitung