HP Z200 - Small Form Factor Workstation Bedienungsanleitung

PCI Express graphics card installation

Introduction

This document describes how to install a PCI Express (PCIe) graphics expansion card.

Kit contents

●Graphics card ●Low-profile bracket (for select graphics cards)

●Graphics driver CD ●Support bracket (for select graphics cards)

●Warranty information ●DVI-VGA video cable adapter (for select graphics cards)

●Regulatory information ●Display port to DVI cable adapters (for select graphics cards)

●Installation instructions ●High-density graphics cable adapter (for select graphics cards)

●Card guide (for select graphics cards)

Your responsibilities

You are responsible for determining whether the product is appropriate for your use and will interface

with other equipment without malfunction or damage. You are also responsible for backing up data

before installing any product and for regularly backing up data after installing the product. HP is not

liable for any damage to equipment or data loss resulting from the use of any product. To determine

the compatibility of this product with your computer or workstation, view QuickSpecs at

http://www.hp.com/go/productbulletin.

U.S.

ENWW Introduction 1

Warnings and cautions

WARNING! Any surface or area of the equipment marked with this symbol indicates the

presence of a hot surface or hot component. If this surface is contacted, the potential for injury exists.

To reduce the risk of injury from a hot component, enable the surface to cool before touching.

WARNING! Any surface or area of the equipment marked with this symbol indicates the

presence of an electrical shock hazard. To reduce the risk of injury from electrical shock, do not open

any enclosed area marked with this symbol.

WARNING! To reduce the risk of electric shock or damage to your equipment:

— Do not disable the power cord grounding plug. The grounding plug is an important safety feature.

— Plug the power cord in a grounded (earthed) outlet that is easily accessible at all times.

— Disconnect power from the equipment by unplugging the power cord from the electrical outlet.

WARNING! To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes

proper computer setup, posture, health, and work habits for computer users, and provides important

electrical and mechanical safety information. This guide is located at http://www.hp.com/ergo and on

the documentation CD (if one is included with the product).

WARNING! If a product is shipped in packaging marked with this symbol, , the product must

always be lifted by two persons to avoid personal injury due to product weight.

CAUTION: Static electricity can damage the electronic components of the computer. Before

beginning these procedures, be sure you discharge static electricity by briefly touching a grounded

metal object.

CAUTION: To prevent damage to the computer, observe the following Electrostatic Discharge

(ESD) precautions while performing the system parts removal and replacement procedures:

— Work on a static-free mat.

— Wear a static strap to ensure that any accumulated electrostatic charge is discharged from your

body to the ground.

— Create a common ground for the equipment you are working on by connecting the static-free mat,

static strap, and peripheral units to that piece of equipment.

NOTE: HP accessories are for use in HP computer products. They have been extensively tested for

reliability and are manufactured to high quality standards.

2 PCI Express graphics card installation ENWW

Step 1—Preparing for component installation

NOTE: Computer models vary. All illustrations are examples only.

Download and install updates

1. Check for available system BIOS updates specified for your HP computer model and operating

system at http://www.hp.com/support.

2. Install the system BIOS updates, if available.

Accessing the internal components of the computer

1. If you need help preparing the computer for this installation, consult the removal and

replacement procedures in the service guide for your computer at http://www.hp.com/support/

manuals.

2. Power down the computer, and then disconnect the power cord.

3. Power down all external devices, and then disconnect them from the computer.

4. Remove the side access panel.

Removing components

1. If present, remove the card support to enable access to the expansion slots and system board

connectors.

2. Select an appropriate PCIe expansion slot and remove the slot cover. For optimum

performance, HP recommends installing the card in the primary PCIe graphics expansion slot of

the computer. Some cards occupy two expansion slots.

NOTE: To identify an available PCIe expansion slot, see the service label on the side access

panel.

Figure 1 Removing the expansion slot cover

ENWW Step 1—Preparing for component installation 3

Step 2—Installing the graphics card

To install the graphics card:

NOTE: If the computer has a card guide integrated into the chassis, omit the first step.

1. (Optional) If a card guide was included with the kit, lower it into the chassis and snap it into

place. The following figure shows two graphics card guide types.

Figure 2 Installing the card guide (Optional)

2. If your computer requires a low profile card, replace the full-height bracket on the card with the

supplied low-profile bracket.

3. To install the PCIe graphics expansion card:

a. If the PCIe graphics expansion card fits in a card guide, lower the card into the chassis and

align the card in the groove of the card guide.

NOTE: For long cards, rotate the graphics card bulkhead under the rear chassis lip, and

then align the card extender with the card guide, while lowering it into the slot.

Figure 3 Aligning and installing a long graphics card

b. Verify that the keyed components of the card align with the slot (1).

c. Close the expansion slot retention clamp (2).

4 PCI Express graphics card installation ENWW

d. If the graphics card requires additional power, locate the computer auxiliary graphics power

supply cable and connect it (3).

NOTE: See the service guide to locate the auxiliary graphics power supply cable.

Figure 4 Installing the graphics expansion card

4. Reinstall the card support, if removed previously. Otherwise, if the PCIe graphics card has a

support bracket, install the support bracket to limit the movement of the card.

Figure 5 Installing the support bracket

Step 3—Reassembling the computer

1. Reinstall the side access panel.

2. Reconnect power to the computer and all external devices.

3. Restore power to the computer and all external devices.

ENWW Step 3—Reassembling the computer 5

Step 4—Configuring the software

1. After restoring power to the computer, install the graphics drivers from the CD included in the kit.

NOTE: At the time of component installation, look for device firmware and driver updates,

designated for your computer model and operating system. Obtain updates from

http://www.hp.com/support.

2. Using a supplied video cable adapter appropriate for the monitor, attach one end of the cable

adapter to the interface connector on the graphics card, and the other end to the monitor.

Japanese 日本語

This document is available in Japanese. See http://www.hp.com/support/manuals, then select your

product and select Japanese from the drop down Manual Language menu.

このドキュメントは日本語版が用意されています。http://www.hp.com/support/manuals にアクセス

し、ご使用のワークステーション製品を選択し、Manual Language ドロップダウンメニューから

Japanese を選択してください。

6 PCI Express graphics card installation ENWW

Andere Handbücher für Z200 - Small Form Factor Workstation

Inhaltsverzeichnis

Andere HP Desktop Handbücher

HP Pavilion a200 - Desktop PC Bedienungsanleitung

HP Brio BA200 Handbuch

HP VISUALIZE X-Class Bedienungsanleitung

HP 200 G4 22 Handbuch

HP Pro 3000 Series Einrichtungshandbuch

HP Compaq d228 MT Handbuch

HP Kayak XU 04xx Betriebsanleitung

HP Compaq Presario Handbuch

HP Kayak XU800 Series Bedienungsanleitung

HP Compaq Presario Handbuch

HP Compaq 6000 Pro SFF Gebrauchsanweisung

HP s3330f - Pavilion - Slimline Gebrauchsanweisung

HP 8000f - Elite Ultra-slim Desktop PC Bedienungsanleitung

HP A6300f - Pavilion - 2 GB RAM Montageanleitung

HP Workstation xw8000 Betriebsanleitung

HP Neoware c50 - Thin Client Montageanleitung

HP D7171A - NetServer - LPr Referenzhandbuch

HP Workstation xw4000 Series Bedienungs- und Wartungshandbuch

HP Sprout Pro G2 Montageanleitung

HP Kayak XA-s Series 02 Handbuch

HP Compaq Elite 8000 CMT Gebrauchs- und Pflegehandbuch

HP 512n - Pavilion - 128 MB RAM Bedienungsanleitung

HP Media Center Bedienungsanleitung

HP Pavilion p7-1200 Gebrauchs- und Wartungshandbuch

Beliebte Desktop Handbücher anderer Marken

Asus

Asus E210 Series Bedienungsanleitung

Dell

Dell Inspiron 600m Bedienungsanleitung

Dell

Dell Inspiron 3662 Bedienungsanleitung

TotalFlow

TotalFlow uFLO Bedienungsanleitung

Logitech

Logitech MK320 Bedienungsanleitung

Dell

Dell XPS 730 H2C Bedienungsanleitung

Sony

Sony Vaio Series Bedienungsanleitung

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Bedienungsanleitung

Alto

Alto MD 250 Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-7800 Series Bedienungsanleitung

Sony

Sony VAIO VGX-TP1 Series Bedienungsanleitung

Asus

Asus Eee Box B204 Bedienungsanleitung

Dell

Dell Optiplex 9010 All In One Bedienungsanleitung

Everex

Everex eXplora Bedienungsanleitung

Lenovo

Lenovo ThinkCentre M75e Bedienungsanleitung

Dell

Dell Alienware Area-51 R4 Bedienungsanleitung

Compaq

Compaq iPAQ Internet Device Bedienungsanleitung

Parker

Parker PA Series Bedienungsanleitung