Huawei EG8247Q Bedienungsanleitung
EG8247Q
Quick Start
Issue 03
Date 2020-02-26
HUAWEI TECHNOLOGIES CO., LTD.
Copyright © Huawei Technologies Co., Ltd. 2020. All rights reserved.
No part of this document may be reproduced or transmitted in any form or by any means without prior
written consent of Huawei Technologies Co., Ltd.
Trademarks and Permissions
and other Huawei trademarks are trademarks of Huawei Technologies Co., Ltd.
All other trademarks and trade names mentioned in this document are the property of their respective
holders.
Notice
The purchased products, services and features are stipulated by the contract made between Huawei and
the customer. All or part of the products, services and features described in this document may not be
within the purchase scope or the usage scope. Unless otherwise specied in the contract, all statements,
information, and recommendations in this document are provided "AS IS" without warranties, guarantees
or representations of any kind, either express or implied.
The information in this document is subject to change without notice. Every eort has been made in the
preparation of this document to ensure accuracy of the contents, but all statements, information, and
recommendations in this document do not constitute a warranty of any kind, express or implied.
Huawei Technologies Co., Ltd.
Address: Huawei Industrial Base
Bantian, Longgang
Shenzhen 518129
People's Republic of China
Website: https://www.huawei.com
Email: [email protected]
Issue 03 (2020-02-26) Copyright © Huawei Technologies Co., Ltd. i
Contents
1 Placing the Device................................................................................................................... 1
2 Connecting Cables................................................................................................................... 3
3 Indicator Description.............................................................................................................. 5
4 Technical Specications......................................................................................................... 7
5 FAQs............................................................................................................................................ 8
EG8247Q
Quick Start Contents
Issue 03 (2020-02-26) Copyright © Huawei Technologies Co., Ltd. ii
1 Placing the Device
● Do not install the ONT outdoors or in an outdoor cabinet.
● The ONT can be mounted onto a wall or placed on a desk. Do not install the ONT in
other modes, such as ceiling.
● Keep 10 cm clearance on all sides to ensure adequate ventilation.
● It is recommended that the computer and ONT be put far away from electric appliances
that generate strong magnetic or electric elds, such as microwave ovens.
Mounting an ONT on the desk
The gure below shows an ONT that is horizontally placed on a desk.
The appearance shown in this document may be dierent from the actual appearance of
the product. The actual product prevails.
Mounting an ONT onto the wall
1. Mark two positions with the same spacing as that between the two mounting
holes of the ONT using a marker on a wall.
EG8247Q
Quick Start 1 Placing the Device
Issue 03 (2020-02-26) Copyright © Huawei Technologies Co., Ltd. 1
2. Select a proper drill bit according to the outer diameter of the screws. Use a
hammer drill to drill the marked positions on the wall. Then clean the holes
and install two expansion bolts.
3. Use a screwdriver to fasten the screws into the expansion bolts, reserving 5
mm ends out of the wall, and mount the ONT onto the screws.
It is recommended that the screw be about 4 mm in diameter and longer than 20 mm.
EG8247Q
Quick Start 1 Placing the Device
Issue 03 (2020-02-26) Copyright © Huawei Technologies Co., Ltd. 2
2 Connecting Cables
● The ber connector connected to the optical port on the wall varies depending on
actual conditions.
● To ensure normal use of bers, make sure that the ber bending radius is larger than 30
mm.
EG8247Q
Quick Start 2 Connecting Cables
Issue 03 (2020-02-26) Copyright © Huawei Technologies Co., Ltd. 3
No. Item Description
1On/O Powers the ONT on or o.
2 Power Connects to a power adapter.
3 TEL1-TEL2 Connects to the ports on a telephone or fax machine.
4 LAN1-
LAN4
Connects to PCs or IP set-top boxes (STBs).
5 USB1-USB2 Connects to USB storage devices.
6 CATV Connects to a TV.
7 Optical
port
The optical port is equipped with a rubber plug and
connected to a ber for upstream transmission.
The type of the optical connector connected to the optical
port can be SC/APC.
8 Reset Press the button for a short time to reset the device; or
press the button for a long time (longer than 10s) to
restore the device to the default settings and reset the
device.
NOTE
Reset Huawei ONTs with caution. Otherwise, the ONTs may fail to
access the Internet. If an ONT cannot access the Internet after a
reset, contact your Internet service provider.
9 WPS When the WLAN is on, press the WPS button (> 3s) and
release the button to start Wi-Fi protected setup (WPS)
negotiation.
10 WLAN Used to enable or disable the WLAN function
- When the WLAN is disabled, press the WLAN button (>
3s) and release the button to enable the WLAN.
- When the WLAN is enabled, press the WLAN button (> 3s)
and release the button to disable the WLAN.
11 Light It is used to turn on/o indicators.
●On: Indicators can be lit properly.
●O: Indicators are o.
NOTE
You are advised to turn on indicators to identify abnormalities in
time.
EG8247Q
Quick Start 2 Connecting Cables
Issue 03 (2020-02-26) Copyright © Huawei Technologies Co., Ltd. 4
3 Indicator Description
Indicator Status Description
Power Steady on The ONT is powered on.
O The power supply is cut o.
PON/LOS See the following table .
LAN1-LAN4 Steady on The Ethernet connection is in the normal state.
Blinking Data is being transmitted over the Ethernet
port.
O The Ethernet connection is not set up.
TEL1-TEL2 Steady on The ONT is registered with the softswitch but
no service ows are transmitted.
Blinks twice a
second
The ONT is registered with the softswitch, and
data is being transmitted on the port.
Blinks once
every 2 seconds
The ONT fails to be registered with the
softswitch.
O The POTS port is disabled.
USB Steady on The USB port is connected and working in the
host mode, but no data is transmitted.
Blinking Data is being transmitted on the USB port.
O The system is not powered on or the USB port
is not connected.
WLAN Steady on The WLAN function is enabled.
Blinking Data is being transmitted over the WLAN port.
EG8247Q
Quick Start 3 Indicator Description
Issue 03 (2020-02-26) Copyright © Huawei Technologies Co., Ltd. 5
Indicator Status Description
O The WLAN function is disabled.
WPS Steady on The WPS function is enabled.
Blinking A Wi-Fi terminal is accessing the system.
O The WPS function is disabled.
CATV Steady on The CATV function is enabled and CATV
signals are received.
O The CATV function is disabled or CATV signals
are not received.
Status
No.
PON Status LOS Status Description
1O O The ONT is prohibited by the upper-
layer device or blinks abnormally.
Contactontact the service provider for
help.
2 Blinks twice
a second
Blinks twice
a second
3 Blinks twice
a second
O The ONT attempts to set up a
connection with its upper-layer device.
4 Steady on O A connection is set up between the
ONT and its upper-layer device.
5O Blinks once
every 2
seconds
The ONT is not connected to bers or
does not receive optical signals.
6 Blinks once
every 2
seconds
Blinks once
every 2
seconds
The hardware is faulty.
EG8247Q
Quick Start 3 Indicator Description
Issue 03 (2020-02-26) Copyright © Huawei Technologies Co., Ltd. 6
4 Technical Specications
Product Function
EG8247Q ● 4 Ethernet ports
● 2 POTS ports
● 2 USB ports
● 1 CATV port
● 2.4 GHz & 5 GHz Wi-Fi
● Power adapter input: See the nameplate on the adapter.
● System power supply: See the nameplate on the device.
● Ambient temperature: 0ºC to +40ºC
● Ambient humidity: 5%–95% (non-condensing)
● Dimensions (H x W x D): 32 mm x 219 mm x 159 mm (without external
antenna and pads)
● Weight: About 400g
● Maximum system power consumption: 24 W
EG8247Q
Quick Start 4 Technical Specications
Issue 03 (2020-02-26) Copyright © Huawei Technologies Co., Ltd. 7
Inhaltsverzeichnis
Andere Huawei Netzwerk-Router Handbücher
Huawei
Huawei AR1200 Series Bedienungsanleitung
Huawei
Huawei Quidway S3500 Series Bedienungsanleitung
Huawei
Huawei AR2200 Series Bedienungsanleitung
Huawei
Huawei EG8143A5 Bedienungsanleitung
Huawei
Huawei A280 Bedienungsanleitung
Huawei
Huawei B320-323 Bedienungsanleitung
Huawei
Huawei B535-232 Technische Daten
Huawei
Huawei Vodafone AR1220 Bedienungsanleitung
Huawei
Huawei SmartAX MT880a Bedienungsanleitung
Huawei
Huawei HG531s Bedienungsanleitung
Huawei
Huawei S3700 Series Bedienungsanleitung
Huawei
Huawei InZone E960 Bedienungsanleitung
Huawei
Huawei WiFi AX3 Bedienungsanleitung
Huawei
Huawei EG8120L5 Bedienungsanleitung
Huawei
Huawei WS7001 Bedienungsanleitung
Huawei
Huawei B310 LTE CPE Bedienungsanleitung
Huawei
Huawei EchoLife HG8245A Technische Daten
Huawei
Huawei 3 Prime Bedienungsanleitung
Huawei
Huawei PTN Series Bedienungsanleitung
Huawei
Huawei Quidway S9300 Bedienungsanleitung
Beliebte Netzwerk-Router Handbücher anderer Marken
NETGEAR
NETGEAR FS526T - Switch Bedienungsanleitung
Korenix
Korenix JetNet 5710G Series Bedienungsanleitung
Automated Logic
Automated Logic ZN551 Betriebsanleitung
Cisco
Cisco ASR 1000 Series Bedienerhandbuch
EnGenius
EnGenius ESR-9710 Bedienungsanleitung
Cisco
Cisco 805 Series Bedienungs- und Sicherheitshinweise