Hubbell Laredo LMC Bedienungsanleitung

WARNING!

LUMINAIRES require high current and voltage.

WARNING!

Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes. Failure to

do so may increase the

RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH.

Install and use so product does not

cause a hazard and use only in environments for which the product is specifically marked.

WARNING!

This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other reproductive

harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.

CAUTION!

Follow ALL luminaire manufacturer's recommendations, product markings, instructions, restrictions and warnings

regarding lumninaire operation, burning position, cycling and lamp replacement. Luminaire label shows electrical and environmental

requirements.

All electrical work must be done by a qualified electrician.

Turn off electric power to all affected circuits and allow to cool before servicing.

A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat retention. Dusting

with a soft, clean, dry cloth is normally sufficient for the optical assembly. Any accumulation of dust or dirt should be removed regularly.

Carefully read these instructions before installing product. If you do not understand these instructions, before starting any work, contact

your Hubbell Lighting distributor or [email protected] or (864) 678-1000

Give instructions to facility owner/manager for future reference.

LAREDO LMC LED INSTALLATION INSTRUCTIONS (PG 1/2)

SAVE THESE INSTRUCTIONS

701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000 www.hubbelloutdoor.com

STEP I

MOUNTING PREPARATION

CAUTION: FIXTURE WEIGHS ABOUT 15 POUNDS

• Using mounting bracket (A) as a template, align slots in

bracket with mounting holes in junction box (B) on the

wall.

Mark hole locations (4) 4.5” square. (See Fig.1)

• Drill wall for the hardware appropriate for the type wall.

Use 1/4 diameter bolt (supplied by others) and attach

bracket to wall.

• Pull the supply wires (C) from junction box (B).

• Apply caulking sealant (supplied by others) around the

top and two sides of the bracket where it meets the wall.

4.500

93029166 Rev C - Page 1 of 2

CAULKING

FIG. 1

NOTE: DO NOT OPEN THIS PRODUCT UNLESS INSTRUCTED BY STEPS INCLUDED IN

THESE INSTRUCTIONS OR BY HUBBELL LIGHTING TECHNICAL SUPPORT PERSONNEL.

FIXTURE HAS BEEN DESIGNED WITH EASY TO INSTALL MOUNTING BRACKETS.

TOOLS REQUIRED: FLAT BLADE SCREWDRIVER OR 5/16” NUT DRIVER, DRILL, ANY

ADDITIONAL TOOLS NEEDED FOR APPROPRIATE WALL FASTENERS

PARTS REQUIRED: (SUPPLIED BY OTHERS) SILICONE CAULK, 1/4” WALL ANCHORS

AND FASTENERS APPROPRIATE FOR WALL CONSTRUCTION TYPE

CAUTION: SHOCK HAZARD! IF YOUR PRODUCT IS EQUIPPED WITH A –BOC OPTION, DO

NOT CONNECT BATTERY BACKUP RED AND WHITE WIRES UNTIL INSTRUCTED TO IN

THESE INSTRUCTIONS (SEE STEP III)

LAREDO LMC LED INSTALLATION INSTRUCTIONS (PG 2/2)

SAVE THESE INSTRUCTIONS

701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000 www.hubbelloutdoor.com

STEP I

FIXTURE MOUNTING

(See Fig.

)

• Hold fixture at a slight angle, slide over mounting plate and

rotate downward to capture plate.

• Tighten screw (G) securely.

• Check to ensure secure mount.

⊕For –BOC equipped product, open the door frame

by loosening door frame closure screws and allow

the door to swing open. Locate RED and WHITE

leads for inverter connector located at front fixture.

Connect red and white wires located inside door.

⊕Close door frame by swinging back into position

ensuring wires are not pinched under door mounted

reflector. Tighten door frame screws until snug.

• Energize product.

Step

WIRING

(See Fig.

)

POWER MUST BE OFF.

(WIRING MUST BE PERFORMED BY A QUALIFIED

ELECTRICIAN)

CAUTION! SHOCK HAZARD, DO NOT CONNECT RED AND

WHITE WIRES TOGETHER UNTIL ALL OTHER

CONNECTIONS HAVE BEEN MADE.

• Wire service leads to fixture power leads according to local

and National Electric Codes.

• Luminaire is equipped with a universal voltage driver capable of

120V-277V input.

• For direct wire connections, connect ground wire to green

wire. Connect

black to black and white to neutral then push

connections back inside J-box.

⊕For –BOC equipped product, make connections to

product per the supplemental Battery Backup Installation

Instructions included with the fixture.

FIG. 2

FIG. 3

NOTE: DO NOT OPEN THIS PRODUCT UNLESS INSTRUCTED BY STEPS INCLUDED IN

THESE INSTRUCTIONS OR BY HUBBELL LIGHTING TECHNICAL SUPPORT PERSONNEL.

FIXTURE HAS BEEN DESIGNED WITH EASY TO INSTALL MOUNTING BRACKETS.

93029166 Rev C - Page 2 of 2

Inhaltsverzeichnis

Andere Hubbell Beleuchtungsausrüstung Handbücher

Hubbell

Hubbell DUAL LITE PG Series Bedienungsanleitung

Hubbell

Hubbell Dual-Lite UFO-LP1 Bedienungsanleitung

Hubbell

Hubbell WPH Series Bedienungsanleitung

Hubbell

Hubbell KIM LIGHTING LIGHTVAULT LTV55 Bedienungsanleitung

Hubbell

Hubbell homeSELECT RMS100 Bedienungsanleitung

Hubbell

Hubbell Kim Lighting Lightvault LTV59 Bedienungsanleitung

Hubbell

Hubbell Dual Lite CVEC15 Bedienungsanleitung

Hubbell

Hubbell DUAL LITE LN4X Series Betriebsanleitung

Hubbell

Hubbell SAVVANO Bedienungsanleitung

Hubbell

Hubbell Prescolite LBSLEDA Bedienungsanleitung

Hubbell

Hubbell LITEFRAME LC4 Bedienungsanleitung

Hubbell

Hubbell KILLARK VSQ Series Betriebsanleitung

Hubbell

Hubbell M-7679 R-PAC Bedienungsanleitung

Hubbell

Hubbell NutriLED Series Bedienungsanleitung

Hubbell

Hubbell Dual-Lite EV4D-02WAL Series Handbuch

Hubbell

Hubbell Laredo Bedienungsanleitung

Hubbell

Hubbell PRS Bedienungsanleitung

Hubbell

Hubbell Dual Lite EV Series Handbuch

Hubbell

Hubbell Dual-Lite DYNC C1D2 Series Bedienungsanleitung

Hubbell

Hubbell KIM LIGHTING VRB1 Bedienungsanleitung

Hubbell

Hubbell ExpressLine Miniliter IV MHSY Series Bedienungsanleitung

Hubbell

Hubbell Laredo LMC Bedienungsanleitung

Hubbell

Hubbell VSLT-UP Bedienungsanleitung

Hubbell

Hubbell ALFW-6LU-5KBZ Series Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung