HUNTER INDUSTRIES | Built on Innovation®
1940 Diamond Street, San Marcos, CA 92078 USA
hunterindustries.com
RC-137 IG US 10/22
© 2022 Hunter Industries™. Hunter, the Hunter logo, and all other trademarks are property of Hunter Industries, registered in the U.S. and other countries.
ST-IBS-1600 Installation Guide
7. Carefully lower the logo cap and cup
assembly. Take care not to disengage
the cup from the logo cap. Make sure
the cup and ring are aligned.
Fit and Finish
Aer installation for non-inll type material or to create a smoother transition to the playing eld, follow these additional steps.
1. Use a sharp blade or shears to trim/remove the inll barrier vertical walls.
2. Cut a round 14⁄"diameter piece of the synthetic material being used for the project.
3. Use a Hunter-approved adhesive (ST-ADH-K) to attach it to the Inll Barrier System.
6. Aer all retaining segments have
been positioned, recheck to make
sure they are completely under the
logo cap.
https://hunter.help/st1600
SCAN
for help
