Hunter 44050 Bedienungsanleitung

Owner’s Manual

File: 511/41251/book p. 1-15 Created: 5-28-98 r

Folder: 511/hunter/for 41251 Alt: 6-24-98 db

Prints black

42999, 44050

SINCE 1 8 8 6

511/41251/book p. 1-15 2/8/01 2:24 PM Page 1

Other Quality Products from Hunter

Fans

Air Purifiers Hu idifiers

511/41251/book p. 1-15 2/8/01 2:24 PM Page 2

Installation

Operation

Table Of Contents

Features 6

Re ove Old Ther ostat 8

Labeling Wires 10

Connecting Wires and Mounting Ther ostat 14

Syste Selector Switches 14

Start-Up 16

Reviewing Current Te perature Setting 16

Setting New Te perature 17

Filter Monitor 18

Resetting Filter Counter To Zero 19

Te perature Span 19

Backlighting 19

Trouble Shooting 20

Typical Wiring Diagra s 22

We are pleased you have selected one of our broad line of ho e co fort products. Our

products are anufactured to high quality standards and are designed for years of service.

We hope you will be satisfied and thank you for buying a Hunter product.

511/41251/book p. 1-15 2/8/01 2:24 PM Page 3

Read This Before Installing Thermostat

IMPORTANT

Read the entire installation section of this

Owner’s Manual thoroughly before you begin

to install or operate your Hunter Ther ostat.

• Re ove the ylar label fro the display

window.

INSTALLATION

All installation is nor ally perfor ed at your

ther ostat.

PROGRAMMING

You can practice progra ing before

installing your ther ostat by inserting and

connecting the batteries and following the

instructions on page 14. This can be done while

you relax in your favorite chair and is a very

good way to fa iliarize yourself with all the

functions of your Hunter Ther ostat.

OPERATION

Your Hunter Ther ostat is designed to

operate with ost gas, oil, electric or 2-wire

hot water heating, and air conditioning syste s

that have 24-volt or illivolt control.

This Hunter Ther ostat will not control ulti-

stage heating or cooling syste s, 110/220 V

syste s, or 3 wire zone syste s.

COMPRESSOR PROTECTION

The ther ostat provides a 4- inute delay

after shutting off the co pressor before it

can be restarted. This feature will prevent

da age to your air conditioner co pressor

caused by rapid cycling. It does not provide a

delay when there are power outages.

511/41251/book p. 1-15 2/8/01 2:24 PM Page 4

TEMPERAT RE RANGE

Your ther ostat can be progra ed between

40°F and 95°F (5°C and 35°C). However, it will

display roo te peratures fro 32°F to 99°F (0°C

to 37°C).

POWER FAIL RE

Whenever the ain power is interrupted or

fails, the battery power retains the progra s

and current ti e.

BATTERY WARNING

When the batteries are low the “LOW BATT”

indicator on the display will flash. When this

happens, install new batteries i ediately.

Once the “LOW BATT” indicator appears, the

ther ostat will continue to operate for

approxi ately 30 days. (Only alkaline batteries

should be used in your ther ostat.

Rechargeable batteries have different properties

which ay cause the ther ostat to not operate

properly. Do not use old batteries.) The batteries

should last one year.

CA TION: The batteries are the only source

of power used to operate your system. If you

do not replace the batteries, the display will

dim and your heating and cooling system will

stop operation.

NOTE: If you plan to be away from the

premises over 30 days, we recommend that

you replace the old batteries with new

alkaline batteries prior to leaving.

511/41251/book p. 1-15 2/8/01 2:24 PM Page 5

FILTER

HEAT OFF COOL A TO FAN RESET

Features (Model 42999)

■Function

Switch

For turning

on heating

and cooling

syste .

■Fan ON

and

AUTO

Selector

Switch.

■Reset Button

For resetting

ther ostat.

■Easy access battery co part ent.

■Easy-To-Read

Digital Display

Liquid crystal

display shows

roo

te perature, set

te perature,

filter indicator,

low battery

indicator, heat

and cool syste

indicator.

■Unique Filter

Monitor

Auto atically

re inds you to

clean or

replace your

heating and air

conditioning

filters.

■For raising

te perature.

■For lowering

te perature.

TEMP

SET TEMP

FILTER

LO BAT

HOLD HEAT COOL

■To reset filter

counter back

to zero.

6-7

511/41251/book p. 1-15 2/8/01 2:24 PM Page 6

Features (Model 44050)

■Function

Switch

For turning

on heating

and cooling

syste .

■Fan ON

and AUTO

Selector

Switch.

■Reset Button

For resetting

ther ostat.

■Easy access battery co part ent.

■Easy-To-Read

Digital Display

Liquid crystal

display shows

roo

te perature, set

te perature,

filter indicator,

low battery

indicator, heat

and cool syste

indicator.

■Unique Filter

Monitor

Auto atically

re inds you to

clean or

replace your

heating and air

conditioning

filters.

■For raising

te perature.

■For lowering

te perature.

TEMP

SET TEMP

FILTER

LO BAT

HOLD HEAT COOL

■Display

backlight for

viewing in

the dark.

■To reset filter

counter back

to zero.

FILTER

LIGHT

HEAT OFF COOL A TO FAN RESET

511/41251/book p. 1-15 2/8/01 2:24 PM Page 7

8-9

Installation

This ther ostat co es with two #8 slotted screws and two wall anchors for ounting. To

install your unit, you should have the following tools and aterials.

■Slotted screwdriver ■Electric drill and 3/16" bit

■Ha er ■Two 1.5V (AA) Size Alkaline batteries

CA TION: Do not remove any wiring from existing thermostat before reading the

instructions carefully. Wires must be labeled prior to removal.

■IMPORTANT! Turn off the power to the furnace at the ain power panel or at the furnace.

■Re ove existing ther ostat cover and ther ostat. See Figure 1. So e ther ostats will have

screws or other locking devices that ust first be re oved. Once wall ounting plate is

exposed, look for wires.

■If wires are not visible, they ay be connected to the back of the wallplate. Again, look for

screws, tabs, etc. So e odels have doors that open to expose wires and ounting screws.

(See Figure 1).

What You Need

Remove Old Thermostat

511/41251/book p. 1-15 2/8/01 2:24 PM Page 8

Wall Mounting Plate Ther ostat Cover

TYPICAL HOME THERMOSTATS

FIG RE 1

511/41251/book p. 1-15 2/8/01 2:24 PM Page 9

10-11

Installation

■Each wire co ing fro the wall to the existing ther ostat is connected to a ter inal point on

that ther ostat. Each of these ter inal points is usually arked with a code letter as shown in

Table A on page 9.

■The nu ber of wires in your syste can be as few as two (for heat only syste s), as any as

eight, or any nu ber in between. If you follow the labeling procedures correctly, you do not

have to be concerned about how any wires there are.

■There is often no ter inal arking on the existing ther ostat of two wire, heat only syste s.

Do not worry, just connect either of the wires to the RH ter inal, then connect the other wire

to the W ter inal to co plete the circuit.

■IMPORTANT! BEFORE DISCONNECTING ANY WIRES, APPLY THE SELF-ADHESIVE LABELS

PROVIDED TO THE WIRE AS SHOWN IN TABLE A ON PAGE 11. (For exa ple, attach the

label arked W to the wire which goes to the W or H ter inal on your existing ther ostat.)

IGNORE THE COLOR OF THE WIRES since these do not always co ply with the standard.

■After labeling wires, disconnect the fro the existing

ther ostat ter inals.

■Re ove existing wallplate. To ake sure wires do not fall back

into wall opening, you ay want to tape the to the wall.

■If hole in wall is larger than necessary for wires, seal this hole so

that no hot or cold air can enter the back of the ther ostat

fro the wall. This air could cause a false ther ostat reading.

Label Wires

WGYRH

511/41251/book p. 1-15 2/8/01 2:24 PM Page 10

Dieses Handbuch passt für folgende Modelle

Andere Hunter Thermostat Handbücher

Hunter

Hunter 42122 Benutzerhandbuch

Hunter

Hunter 40120 Bedienungsanleitung

Hunter

Hunter Set & Save 47250A Bedienungsanleitung

Hunter

Hunter 47550 Bedienungsanleitung

Hunter

Hunter 40135 Bedienungsanleitung

Hunter

Hunter 44428 Originalbetriebsanleitung

Hunter

Hunter 42999 Bedienungsanleitung

Hunter

Hunter JustRight Bedienungsanleitung

Hunter

Hunter 42122 Bedienungsanleitung

Hunter

Hunter 42122 Bedienungsanleitung

Hunter

Hunter 44132 Bedienungsanleitung

Hunter

Hunter 44760 Bedienungsanleitung

Hunter

Hunter Set 'n Save I 42204 Bedienungsanleitung

Hunter

Hunter Set & Save 47200A Bedienungsanleitung

Hunter

Hunter 42177 Benutzerhandbuch

Hunter

Hunter 40020 Bedienungsanleitung

Hunter

Hunter Internet Thermostat Bedienungsanleitung

Hunter

Hunter 44550 Bedienungsanleitung

Hunter

Hunter Set & Save 47110A Bedienungsanleitung

Hunter

Hunter 44100 Bedienungsanleitung

Hunter

Hunter 44660 Bedienungsanleitung

Hunter

Hunter Set & Save 47300A Bedienungsanleitung

Hunter

Hunter 44377 Benutzerhandbuch

Hunter

Hunter 40080 Bedienungsanleitung

Beliebte Thermostat Handbücher anderer Marken

EWELLY

EWELLY EW-181 Bedienungsanleitung

Prolon

Prolon T1100 Montageanleitung

Computherm

Computherm Q20 Bedienungsanleitung

Heatmiser

Heatmiser neoStat Bedienungsanleitung

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA Bedienungsanleitung

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat Bedienungsanleitung

Saswell

Saswell SAS920XWHB-7-S-RF Leitfaden

Aircalo

Aircalo TFP1-ET85P2 Bedienungsanleitung

Honeywell

Honeywell CM721 Bedienungsanleitung

Carrier

Carrier DEBONAIR 33CS Bedienungsanleitung

Lennox

Lennox iHarmony Zone Thermostat Montageanleitung

Gemtech

Gemtech GT7000 Bedienungsanleitung

Rollei

Rollei Smartes 45000 Bedienungsanleitung

Sinope

Sinope TH1300RF Bedienungsanleitung

Honeywell

Honeywell RLV4305 Bedienungsanleitung

Honeywell

Honeywell Prestige 2.0 THX9421 Bedienungsanleitung

NuTone

NuTone NTBZ48 Original Betriebsanleitung

Stelpro

Stelpro MAESTRO ASMT402AD Bedienungsanleitung