IBM Slicestor 2584 Bedienungsanleitung

IBM Cloud Object Storage System™

Version 3.13.1

Slicestor®2584 Installation Guide

IBM

Note

Before using this information and the product it supports, read the following information:

vThe general information in Notices

vThe information in Safety and environmental notices

vThe information in the IBM Environmental Notices and User Guide (provided on a DVD)

This edition applies to IBM Cloud Object Storage System™Slicestor®2584 and is valid until replaced by new

editions.

US Government Users Restricted Rights – Use, duplication or disclosure restricted by GSA ADP Schedule Contract

with IBM Corp.

Contents

Figures ............... v

Tables ............... vii

Safety and environmental notices ... ix

Safety notices .............. ix

Environmental notices........... xii

Declared noise emissions ........ xiii

Support information ........... xiii

Chapter 1. Appliance safety precautions 1

Safe handling .............. 1

Safety................. 1

Rack system precautions .......... 2

Electrostatic discharge (ESD) precautions ..... 3

Product rating .............. 3

Chapter 2. Preparation ........ 5

Before you begin ............. 5

Unpacking the storage system ........ 5

Chapter 3. Installing the appliance into a

rack ................ 7

Mounting the system into a rack........ 7

Enclosure layout ............. 8

Installing and removing disk drives in carriers

(DDICs) ............... 10

Installing and removing cooling modules, power

supply units, and compute modules ...... 11

Battery removal ............. 14

Chapter 4. LED states ........ 17

Compute module LEDs .......... 17

Ops panel LEDs ............. 18

Drawer indicators ............ 19

Power supply unit (PSU) LEDs ........ 20

Cooling module LEDs ........... 21

Notices .............. 23

Trademarks .............. 25

Homologation statement .......... 25

iv Slicestor®2584 Installation Guide

Figures

1. Unpacking the storage system....... 6

2. Mounting the system into a rack (left rail only) 8

3. Drive numbering for drawer 1 (top)..... 9

4. Drive numbering for drawer 2 (bottom) ... 9

5. LED locations ............ 10

6. Installing a DDIC .......... 10

7. Removing a DDIC .......... 11

8. Removing a cooling module (1) ...... 11

9. Removing a cooling module (2) ...... 12

10. Removing a PSU (1).......... 12

11. Removing a PSU (2).......... 13

12. Removing a module (1). (6Gb/s SAS EBOD

module shown) ........... 13

13. Removing a module (2). (6Gb/s SAS EBOD

module shown) ........... 14

14. Remove the battery .......... 15

15. SBB compute module LEDs ....... 17

16. Ops panel LEDs ........... 18

17. Drawer status indicators ........ 19

18. PSU LEDs ............. 20

19. Cooling module LEDs ......... 21

vi Slicestor®2584 Installation Guide

Tables

1. Declared noise emissions in accordance with

ISO 9296(1,2,3) ............ xiii

2. SBB compute module LED descriptions 17

3. Ops module LED states ........ 18

4. Drawer LED states .......... 19

5. PSU LED states ........... 20

6. Cooling module LED states ....... 21

viii Slicestor®2584 Installation Guide

Safety and environmental notices

Review the safety notices, environmental notices, and electronic emission notices for IBM®Cloud Object

Storage System before you install and use the product.

Suitability for telecommunication environment - This product is not intended to connect directly or

indirectly by any means whatsoever to interfaces of public telecommunications networks.

Examples of a caution and a danger notice. Numbers in parentheses refer to message numbers in the IBM

Safety Notices publication G229-9054, which is included with your product.

CAUTION:

A caution notice indicates the presence of a hazard that has the potential of causing moderate or

minor personal injury. (C001)

DANGER

A danger notice indicates the presence of a hazard that has the potential of causing death or serious

personal injury. (D002)

Safety notices

Safety notices for this product.

Familiarize yourself with the IBM Safety Notices publication G229-9054, which is included with your

product.

DANGER: When working on or around the system, observe the following precautions:

Electrical voltage and current from power, telephone, and communication cables are hazardous. To

avoid a shock hazard:

• , connect power to this unit only with the IBM provided powerIf IBM supplied a power cord(s)

cord. Do not use the IBM provided power cord for any other product.

• Do not open or service any power supply assembly.

• Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration

of this product during an electrical storm.

• The product might be equipped with multiple power cords. To remove all hazardous voltages,

disconnect all power cords.

• Connect all power cords to a properly wired and grounded electrical outlet. Ensure that the outlet

supplies proper voltage and phase rotation according to the system rating plate.

• Connect any equipment that will be attached to this product to properly wired outlets.

• When possible, use one hand only to connect or disconnect signal cables.

• Never turn on any equipment when there is evidence of fire, water, or structural damage.

• Do not attempt to switch on power to the machine until all possible unsafe conditions are corrected.

• Assume that an electrical safety hazard is present. Perform all continuity, grounding, and power

checks specified during the subsystem installation procedures to ensure that the machine meets

safety requirements.

• Do not continue with the inspection if any unsafe conditions are present.

• Disconnect the attached power cords, telecommunications systems, networks, and modems before

you open the device covers, unless instructed otherwise in the installation and configuration

procedures.

• Connect and disconnect cables as described in the following procedures when installing, moving,

or opening covers on this product or attached devices.

To disconnect:

1. Turn off everything (unless instructed otherwise).

2. Remove the power cords from the outlets.

3. Remove the signal cables from the connectors.

4. Remove all cables from the devices.

To connect:

1. Turn off everything (unless instructed otherwise).

2. Attach all cables to the devices.

3. Attach the signal cables to the connectors.

4. Attach the power cords to the outlets.

5. Turn on the devices.

• Sharp edges, corners and joints may be present in and around the system. Use care when handling

equipment to avoid cuts, scrapes and pinching. (D005)

DANGER: Heavy equipment — personal injury or equipment damage might result if mishandled.

(D006)

xSlicestor®2584 Installation Guide

Inhaltsverzeichnis

Andere IBM Lagerung Handbücher

IBM

IBM 2310 Bedienungsanleitung

IBM

IBM 4mm DDS-2 Tape Autoloader Bedienungsanleitung

IBM

IBM System Storage TS2900 Bedienungsanleitung

IBM

IBM System Storage DS3524 Express Bedienungsanleitung

IBM

IBM Storwize V7000 Betriebsanleitung

IBM

IBM DR550 V3.0 Bedienungsanleitung

IBM

IBM 129 Bedienungs- und Montageanleitung

IBM

IBM 1402 Bedienungsanleitung

IBM

IBM TotalStorage DS300 Bedienungsanleitung

IBM

IBM OPTIONS 12/24 GB Bedienungsanleitung

IBM

IBM TotalStorage SAN256N Director 2045-N16 Produkthandbuch

IBM

IBM SAN128B-7 Handbuch

IBM

IBM 10/20 GB TR-5 Bedienungsanleitung

IBM

IBM DCXA-210000 Bedienungsanleitung

IBM

IBM 3581 Bedienungsanleitung

IBM

IBM TotalStorage DS5100 Betriebsanleitung

IBM

IBM ESS 3000 Technisches Handbuch

IBM

IBM SAN768B Handbuch

IBM

IBM IC35L020 - Deskstar 20 GB Hard Drive Bedienungsanleitung

IBM

IBM Ultrastar 73LZX Bedienungsanleitung

IBM

IBM 3409-S03 Bedienungsanleitung

IBM

IBM DS8000 - ADDITIONAL INFORMATION Bedienungsanleitung

IBM

IBM SAN384B-2 Handbuch

IBM

IBM DTCA-23240 - Travelstar 3.2 GB Hard Drive Bedienungsanleitung

Beliebte Lagerung Handbücher anderer Marken

QNAP

QNAP TS 32PXU Series Bedienungsanleitung

LaCie

LaCie RUGGED RAID Bedienungsanleitung

Freecom

Freecom CLS DOCK Bedienungsanleitung

PNY

PNY Attache P-FD64MBATT3 Bedienungsanleitung

HP StorageWorks MSL2024 Bedienungsanleitung

OLT

OLT 6x6 Maximizer Bedienungsanleitung

Transcend

Transcend JetFlash 160 Bedienungsanleitung

LaCie

LaCie RUGGED MINI Bedienungsanleitung

Thunderbolt

Thunderbolt 600 Bedienungsanleitung

Panasonic

Panasonic LB-DH8 series Handbuch

Intel

Intel RAID High Availability Bedienungsanleitung

LaCie

LaCie 12big Thunderbolt 3 Bedienungsanleitung

Spectra Logic

Spectra Logic T-Series Spectra T50e Bedienungsanleitung

Panasonic

Panasonic LKM-F931-1 Bedienungsanleitung

Tabernus

Tabernus Enterprise Erase E2400 Bedienungsanleitung

Rocstor

Rocstor COMMANDER 3F series Bedienungsanleitung

HP P9000 Bedienungsanleitung

Western Digital

Western Digital Ultrastar Data60 Bedienungsanleitung