Icom IC-F11/Sl IC-F21/S Bedienungsanleitung

INSTRUCTION MANUAL

UHF TRANSCEIVER

iF21/S

This device complies with Part 15 of the FCC

Rules. Operation is subject to the condition that

this device does not cause harmful interference.

VHF TRANSCEIVER

iF11/S

IC-F11_F21_S_4.qxd 07.7.24 1:14 PM Page 1 (1,1)

Your Icom radio generates RF electromagnetic

energy during transmit mode. This radio is de-

signed for and classified as “Occupational Use

Only”, meaning it must be used only during the

course of employment by individuals aware of the

hazards, and the ways to minimize such hazards.

This radio is NOT intended for use by the “General Popula-

tion” in an uncontrolled environment.

This radio has been tested and complies with the FCC RF expo-

sure limits for “Occupational Use Only.” In addition, your Icom radio

complies with the following Standards and Guidelines with regard to

RF energy and electromagnetic energy levels and evaluation of

such levels for exposure to humans:

• FCC OET Bulletin 65 Edition 97-01 Supplement C, Evaluating

Compliance with FCC Guidelines for Human Exposure to Radio

Frequency Electromagnetic Fields.

• American National Standards Institute (C95.1 – 1992), IEEE Stan-

dard for Safety Levels with Respect to Human Exposure to Radio

Frequency Electromagnetic Fields, 3 kHz to 300 GHz.

• American National Standards Institute (C95.3 – 1992), IEEE Rec-

ommended Practice for the Measurement of Potentially Hazardous

Electromagnetic Fields – RF and Microwave.

To ensure that your exposure to RF electromag-

netic energy is within the FCC allowable limits for

occupational use, always adhere to the following

guidelines:

•DO NOT operate the radio without a proper antenna attached, as

this may damage the radio and may also cause you to exceed FCC

RF exposure limits. A proper antenna is the antenna supplied with

WARNING

CAUTION

SAFETY TRAINING INFORMATION

IC-F11_F21_S_4.qxd 07.7.24 1:14 PM Page 2 (1,1)

this radio by the manufacturer or an antenna speciﬁcally authorized

by the manufacturer for use with this radio.

•DO NOT transmit for more than 50% of total radio use time (

“

50%

duty cycle”). Transmitting more than 50% of the time can cause

FCC RF exposure compliance requirements to be exceeded. The

radio is transmitting when the “TX indicator” lights red. You can

cause the radio to transmit by pressing the “PTT” switch.

•ALWAYS use Icom authorized accessories (antennas, batteries,

belt clips, speaker/mics, etc). Use of unauthorized accessories can

cause the FCC RF exposure compliance requirements to be ex-

ceeded.

•ALWAYS keep the antenna at least 2.5 cm (1 inch) away from the

body when transmitting and only use the Icom belt-clips, listed in p. 21,

when attaching the radio to your belt, etc., to ensure FCC RF ex-

posure compliance requirements are not exceeded. To provide the

recipients of your transmission the best sound quality, hold the an-

tenna at least 5 cm (2 inches) from mouth, and slightly off to one

side.

The information listed above provides the user with the information

needed to make him or her aware of RF exposure, and what to do to

assure that this radio operates within the FCC RF exposure limits of this

radio.

Electromagnetic Interference/Compatibility

During transmissions, your Icom radio generates RF energy that

can possibly cause interference with other devices or systems. To

avoid such interference, turn off the radio in areas where signs are

posted to do so. DO NOT operate the transmitter in areas that are

sensitive to electromagnetic radiation such as hospitals, aircraft,

and blasting sites.

IC-F11_F21_S_4.qxd 07.7.24 1:14 PM Page 3 (1,1)

iii

FOREWORD

Thank you for purchasing the IC-F11/S, F21/S FM transceiver.

READ ALL INSTRUCTIONS carefully and completely before using

the transceiver.

SAVE THIS INSTRUCTION MANUAL–This instruction manual

contains important operating instructions for the transceiver.

IMPORTANT

RCAUTION! NEVER hold the transceiver so that the antenna is

very close to, or touching exposed parts of the body, especially the

face or eyes, while transmitting. The transceiver will perform best if

the microphone is 2 to 4 in. (5 to 10 cm) away from the lips and the

transceiver is vertical.

RCAUTION! NEVER operate the transceiver with a headset or

other audio accessories at high volume levels.

RCAUTION! NEVER short the terminals of the battery pack.

DO NOT push the PTT when not actually desiring to transmit.

AVOID using or placing the transceiver in direct sunlight or in areas

with temperatures below +14°F (–10°C) or above +122°F (+50°C).

DO NOT modify the transceiver for any reason.

KEEP the transceiver from the heavy rain, and Never immerse it in

the water. The transceiver construction is water resistant, not

water proof.

The use of non-Icom battery packs/chargers may impair transceiver

performance and invalidate the warranty.

FCC caution: Changes or modiﬁcations to this transceiver, not

expressly approved by Icom Inc., could void your authority to op-

erate this transceiver under FCC regulations.

IC-F11_F21_S_4.qxd 07.7.24 1:14 PM Page 4 (1,1)

TABLE OF CONTENTS

SAFETY TRAINING INFORMATION ………………………………… i–ii

FOREWORD……………………………………………………………… iii

IMPORTANT ……………………………………………………………… iii

TABLE OF CONTENTS ………………………………………………… iv

1 PANEL DESCRIPTION …………………………………………… 1–3

‘Switches, controls, keys and connectors ……………………… 1–2

‘LED indicator ………………………………………………………… 3

2 ACCESSORIES………………………………………………………… 4

3 BATTERY PACKS ………………………………………………… 5–11

‘Battery pack replacement ………………………………………… 5

‘Battery cautions……………………………………………………… 6

‘Battery charging ………………………………………………… 7–9

‘ Charging NOTE …………………………………………………… 10

‘ Battery case (Option) ……………………………………………… 11

44 PROGRAMMABLE FUNCTIONS ……………………………… 12–16

‘General ……………………………………………………………… 12

5 CONVENTIONAL OPERATION ……………………………… 17–18

‘Receiving and transmitting ……………………………………… 17

‘Call procedure ……………………………………………………… 18

‘Transmitting notes ………………………………………………… 18

6 CLONING ……………………………………………………………… 20

7 OPTION …………………………………………………………… 21–22

IC-F11_F21_S_4.qxd 07.7.24 1:14 PM Page 5 (1,1)

PANEL DESCRIPTION

‘‘Switches, controls, keys and

connectors

Speaker

Mic

2CH version

CH1↔CH2

16CH version

CH1 to CH16

SP MIC

IC-F11_F21_S_4.qxd 07.7.24 1:14 PM Page 6 (1,1)

PANEL DESCRIPTION

qCHANNEL SELECTOR/SW [CH]

• 2CH version : Toggle the CH switch to select CH1 or CH2.

• 16CH version: Turn the selector knob to select the pro-

grammed operating channel.

wVOLUME CONTROL [OFF/VOL]

Turns power ON and adjusts the audio level.

eDEALER-PROGRAMMABLE KEY [Upper]

Can be programmed for one of several functions by your Icom

dealer.

rPTT SWITCH [PTT]

Push and hold to transmit; release to receive.

tDEALER-PROGRAMMABLE KEY [Lower]

Can be programmed for one of several functions by your Icom

dealer.

yANTENNA CONNECTOR

Connects the supplied antenna.

uTX/RX INDICATOR LED (see p. 3)

• Lights red while transmitting.

• Lights green while receiving a signal, or squelch is open.

i[SP]/[MIC] JACK

Connects optional speaker-microphone.

NOTE: Above functions depend on pre-setting.

DDProgrammable key reference ([Red] depends on version.)

Red

Upper

Lower

IC-F11_F21_S_4.qxd 07.7.24 1:14 PM Page 7 (1,1)

‘‘LED indicator

The TX/RX indicator LED indicates several

more information as follows;

(Ref.; R=Red, G=Green, O=Orange)

PANEL DESCRIPTION

R R R R

R R

O O

R R R R

R R

G G

• TX: Turns Red while transmitting a signal.

• RX: Turns Green while receiving a signal.

• Call LED (ON): When receiving a matched 2/5TONE.

• Call LED (Blink): When receiving a matched 2/5TONE.

• Fast/Slow scan: Blinks while Fast/Slow scan is activated.

•Low BATT1: You should charge the battery. (blinks slowly)

•Low BATT2: You must charge the battery. (blinks fast)

•TX low BATT1: Low BATT1 was detected during TX mode.

•TX low BATT2: Low BATT2 was detected during TX mode.

IC-F11_F21_S_4.qxd 07.7.24 1:14 PM Page 8 (1,1)

ACCESSORIES

‘‘Accessory attachment

DSupplied accessories

The transceiver comes supplied with the following accessories.

qFlexible antenna

wBelt clip (w/screws)

DAntenna

The antenna screws onto the transceiver as

illustrated right.

DBelt clip

Attach the belt clip to the transceiver as illustrated below.

Use the supplied screws only.

IC-F11_F21_S_4.qxd 07.7.24 1:14 PM Page 9 (1,1)

3BATTERY PACKS

‘‘Battery pack replacement

Before replacing the battery pack, the volume control MUST be rotated

fully counterclockwise, until a click is heard, to turn the power OFF.

• Slide the battery release forward, then pull the battery pack upward

with the transceiver facing away from you.

DDBATTERY PACKS

*1BP-211N is not available.

*2Operating period is calculated under the following conditions;

Tx : Rx : standby = 5 : 5 : 90

*3Operating period depends on the alkaline cells used.

*4Output power is automatically reduced to 1 W to retain sufficient

power in case of an emergency, etc.

*5Operating period measured with the 2 W model.

7.2 V 1100 mAh

Battery

pack Voltage Capacity BC-146 Battery life*2

BC-144N*1,

BC-119N or

BC-121N

Charging period

BP-208N*4Battery case for AA

(LR6) ×6 alkaline N/A N/A

12 hrs. 1.5 hrs. 8.5 hrs.

—*3

BP-209N

1800 mAh 14 hrs.2.0 hrs.N/A7.4 V

BP-211N

600 mAh 4.5 hrs.*5

1.0 hrs.6.5 hrs.7.2 V

BP-222N*5

1650 mAh 13 hrs.2.0 hrs.18.5 hrs.7.2 V

BP-210N

IC-F11_F21_S_4.qxd 07.7.24 1:14 PM Page 10 (1,1)

Inhaltsverzeichnis

Andere Icom Transceiver Handbücher

Icom

Icom IC-3220A Bedienungsanleitung

Icom

Icom IC-9700 Montage- und Bedienungsanleitung

Icom

Icom IC-E92D Bedienungsanleitung

Icom

Icom IC-703 Bedienungsanleitung

Icom

Icom IC-F33GT Bedienungsanleitung

Icom

Icom IC-F7000 Bedienungsanleitung

Icom

Icom IC-M35 Bedienungsanleitung

Icom

Icom IC-2800 Bedienungsanleitung

Icom

Icom IC-7800 Bedienungsanleitung

Icom

Icom ID-5100E Bedienungsanleitung

Icom

Icom M802 Bedienungsanleitung

Icom

Icom IC-U18 Bedienungsanleitung

Icom

Icom IC-726 Bedienungsanleitung

Icom

Icom IC-F3162DT Bedienungsanleitung

Icom

Icom IC-F8100 Bedienungsanleitung

Icom

Icom IC-F29SR Bedienungsanleitung

Icom

Icom IC-F3GT Bedienungsanleitung

Icom

Icom IC-M800 Bedienungsanleitung

Icom

Icom IC-M504A Bedienungsanleitung

Icom

Icom IC-756PROIII Bedienungsanleitung

Icom

Icom IC-T22A Bedienungsanleitung

Icom

Icom IC-1201A Bedienungsanleitung

Icom

Icom IC-T70A Bedienungsanleitung

Icom

Icom IC-F6022 Bedienungsanleitung

Beliebte Transceiver Handbücher anderer Marken

Yaesu

Yaesu FT-7B Bedienungsanleitung

Kenwood

Kenwood ProTalk TK-3201 Bedienungsanleitung

Mizuho

Mizuho MX-2 Produkthandbuch

Kenwood

Kenwood TK-3180 Bedienungs- und Wartungshandbuch

Blitz

Blitz MJ-398U Bedienungsanleitung

Utilicom

Utilicom LongRanger 2050 Bedienungsanleitung

Standart

Standart HX290UKA Bedienungsanleitung

Altronix

Altronix Pace1PTM Bedienungsanleitung

Kirisun

Kirisun PT2208 Bedienungsanleitung

ELECRAFT

ELECRAFT KX2 Bedienungsanleitung

Zodiac

Zodiac K3 Bedienungsanleitung

Assa Abloy

Assa Abloy SecureComm HKC GSM-WIFI U Bedienungsanleitung

Kenwood

Kenwood TK-2217 Bedienungsanleitung

Siemens

Siemens PSO 4000 Bedienungsanleitung

Kenwood

Kenwood TS-590SG Bedienungsanleitung

Midland

Midland G8E-BT Handbuch

ComNav

ComNav Mariner X2 Bedienungsanleitung

Uniden

Uniden UH820 Series Bedienungsanleitung