Idex KNIGHT UDP-100S Bedienungsanleitung

Page 1 of 80901017 Rev:C (05/01)

UDP-100S / UPP-100S

Instruction Manual

0901017 Rev:C (05/01)Page 2 of 8

TABLE OF CONTENTS

UDP-100S Installation ...............................................................................2

UDP-100S Pump Connections..................................................................2

UDP-100S Operation.................................................................................2

UPP-100S Installatiion...............................................................................3

UPP-100S Pump Connections..................................................................3

UPP-100S operation..................................................................................3

Wiring Diagram..........................................................................................9

Assembly Diagram ..................................................................................10

Warranty Information.................................................................................6

Knight Locations........................................................................................6

CAUTION: The UDP /UPP Series system has high voltage connected to the transformeralwaysdisconnect

main power when servicing the unit.

Page 3 of 80901017 Rev:C (05/01)

UDP-100S INSTALLATION

(1) Mount the unit on a wall in a convenient location near the dishwasher, the DataPlus unit that will control the

UDP-100S, and not more than three feet from the final rinse line.

Ensure that the distance from the bottom

of the UDP-1000S to the top of the chemical container will be at least 12"

. A mounting bracket is

available for mounting the unit on top of the dishwasher if desired. NOTE: Mounting the unit on the side, on

the back, or on the vents of the dishwasher may cause thermal overload and damage or hinder the

performance of the unit. Do NOT mount the unit in the direct path of steam. This can short circuit and

permanently damage the unit.

(2) Remove power from the DataPlus unit that will control the UDP-100S.

(3) Install the 4-conductor cable from the UDP-100S to the DataPlus circuit board (see installation drawing).

UDP-100S PUMP CONNECTIONS

(1) Install 1/4" tube injection fitting into the side or bottom of the dishwasher rinse line between the rinse solenoid

valves and the rinse jets. Drill a 11/32" hole and tap to 1/8" NPT. Use of a saddle clamp may be desired on

copper rinse line for better support. Saddle clamps can be used if required.

(2) Install 1/4" O.D. poly tubing between the discharge (right) tube side of the peristaltic pump and the injection

fitting using the 1/4" poly compression nuts.

(3) Install 1/4" O.D. poly tubing between the suction (left) tube side and the pickup tube provided. Be sure to

draw tubing through the end of the pickup tube.

UDP-100S OPERATION

Control of the pump will be performed by the DataPlus unit that the pump is connected to — refer to the DataPlus

Programming Manual for detailed implementation instructions of the UDP-100S.

As a reminder, remember to remove the jumper over the LOW SAN terminals on the DataPlus board or the low

level lights and alarms will NOT activate.

0901017 Rev:C (05/01)Page 4 of 8

UPP-100S INSTALLATION

(1) Mount the unit on a wall in a convenient location near the dishwasher, the device that will control the UPP-

100S, and not more than three feet from the final rinse line. A mounting bracket is available for mounting the

unit on top of the dishwasher if desired. NOTE: Mounting the unit on the side, on the back, or on the vents of

the dishwasher may cause thermal overload and damage or hinder the performance of the unit. Do NOT

mount the unit in the direct path of steam. This can short circuit and permanently damage the unit.

(2) Check the voltage of the device that will control the UPP-100S.; the variable speed pump motor requires a 0-

24 VDC source. Application of incorrect voltage will permanently damage the unit and is not covered under

warranty.

(3) Remove power from the device that will control the UPP-100S.

(4) Connect the motor leads to the device that will be controlling the UPP-100S.

UPP-100S PUMP CONNECTIONS

(1) Install 1/4" tube injection fitting into the side or bottom of the dishwasher rinse line between the rinse solenoid

valves and the rinse jets. Drill a 11/32" hole and tap to 1/8" NPT. Use of a saddle clamp may be desired on

copper rinse line for better support. Saddle clamps can be used if required.

(2) Install 1/4" O.D. poly tubing between the discharge (right) tube side of the peristaltic pump and the injection

fitting using the 1/4" poly compression nuts.

(3) Install 1/4" O.D. poly tubing between the suction (left) tube side and the pickup tube provided. Be sure to

draw tubing through the end of the pickup tube.

UPP-100S OPERATION

Control of the pump will be performed by the device that the pump is connected to — refer to the instructions

provided for the device for detailed implementation instructions of the UPP-100S.

Page 5 of 80901017 Rev:C (05/01)

WIRING DIAGRAM UDP-100S

0901017 Rev:C (05/01)Page 6 of 8

WIRING DIAGRAM UPP-100S

Page 7 of 80901017 Rev:C (05/01)

NOTE

0901017 Rev:C (05/01)Page 8 of 8

World Headquarters:

20531 Crescent Bay Dr.

Lake Forest, CA

92630-8825 USA

TEL: (949) 595-4800

FAX: (949) 595-4801

Atlanta Branch:

8111 Technology Dr. NE

Covington, GA

30014 USA

TEL: (770) 787-9400

FAX: (770) 787-1155

Toronto Branch:

2880 Argentia Road, Unit 6

Mississauga, Ontario

L5N 7X8 Canada

TEL: (905) 542-2333

FAX: (905) 542-1536

London Branch:

#15 Brunel Centre

Newton Road, Crawley

West Sussex UK RH102UB

TEL: (44) 1293-615570

FAX: (44) 1293-615585

Sydney Branch:

Unit 28, 317-321

Woodpark Rd., Smithfield

NSW Australia 2164

TEL: 61-29-725-2588

FAX: 61-29-725-2025

Amsterdam Branch:

Marssteden 68

7547 TD Enschede

The Netherlands

TEL: 31-53-428-58-00

FAX: 31-53-428-58-09

.1,*+7 ,1&

A Unit of IDEX Corporation

DISCLAIMER

Kni

ht Inc. does not accept responsibilit

for the mishandlin

, misuse, or non-performance of the described items

when used for purposes other than those specified in the instructions. For hazardous materials information consult

label, MSDS, or Kni

ht Inc.

WARRANTY

All Kni

ht controls and pump s

stems are warranted a

ainst defects in material and workmanship for a period of

ONE

ear. All electronic control boards have a TWO

ear warrant

. Warrant

applies onl

to the replacement or

repair of such parts when returned to factor

with a Kni

ht Return Authorization

(

KRA

)

number, frei

ht prepaid, and

found to be defective upon factor

authorized inspection. Bearin

s and pump seals or rubber and s

nthetic rubber

parts such as “O” rin

s, diaphra

ms, s

ueeze tubin

, and

askets are considered expendable and are not covered

under warrant

. Warrant

does not cover liabilit

resultin

from performance of this e

uipment nor the labor to

replace this e

uipment. Product abuse or misuse voids warrant

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Idex Wasserpumpe Handbücher

Idex

Idex VIKING PUMP 4124B Series Betriebsanleitung

Idex

Idex Sandpiper Signature Series Stücklistenhandbuch

Idex

Idex TREBOR MAGNUM 620D PUMP Handbuch

Idex

Idex Corken Coro-Vac CPS1X Installationsanleitung

Idex

Idex Gast 8R Series Handbuch

Idex

Idex TREBOR Purus 20 Bedienungsanleitung

Idex

Idex GAST 67 Series Handbuch

Idex

Idex Banjo 150P-3 Bedienungsanleitung

Idex

Idex WARREN RUPP SandPIPER EB1/2-A Bedienungsanleitung

Idex

Idex Wright Flow Technologies RTPe Series Bedienungsanleitung

Idex

Idex HALE FYR-PAK Betriebsanleitung

Idex

Idex Godiva Prima PC1 2010 Bedienungsanleitung

Idex

Idex BEDU POMPEN VERSA-MATIC PUMP Elima-Matic E1PP5 5T... Bedienungsanleitung

Idex

Idex Warren Rupp SandPIPER SB1 1/2-H Bedienungsanleitung

Idex

Idex Warren Rupp MARATHON M20 Stücklistenhandbuch

Idex

Idex HALE SmartCAFS Bedienungsanleitung

Idex

Idex ISMATEC REGLO-Z Digital Bedienungsanleitung

Idex

Idex TREBOR 110R Handbuch

Idex

Idex Knight Control Guard ACCS Bedienungsanleitung

Idex

Idex Corken Z-Series Gebrauchsanweisung

Idex

Idex Gast DOA Series Handbuch

Idex

Idex Trebor MAGNUM 620R Handbuch

Idex

Idex WARREN RUPP SandPIPER PB1-A Bedienungsanleitung

Idex

Idex Wright Flow Technologies RTP Series Bedienungsanleitung

Beliebte Wasserpumpe Handbücher anderer Marken

Neptun

Neptun NPHW 5500 Bedienungsanleitung

Sensidyne

Sensidyne Gilian BDX-II Montage- und Bedienungsanleitung

Draper

Draper 47808 Bedienungsanleitung

Trolla

Trolla 12820 Bedienungsanleitung

Sunfab

Sunfab SVH Series Bedienungsanleitung

WilTec

WilTec 50740 Bedienungsanleitung

Fieldmann

Fieldmann FVC 5015 EK Bedienungsanleitung

Everbilt

Everbilt EFSUB5-122HD Bedienungsanleitung

Graco

Graco Husky 3300e Bedienungsanleitung

esotec

esotec 101018 Bedienungsanleitung

Becker

Becker BASIC VASF 2.80/1-0.AC230 Bedienungsanleitung

Sykes AmeriPumps

Sykes AmeriPumps GP100M Fehlerbehebungshandbuch

DUROMAX

DUROMAX XP WX Series Bedienungsanleitung

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Bedienungsanleitung

Franklin Electric

Franklin Electric IPS Bedienungsanleitung

Xylem

Xylem e-1532 Series Bedienungsanleitung

Milton Roy

Milton Roy PRIMEROYAL Bedienungsanleitung

STA-RITE

STA-RITE ST33APP Bedienungsanleitung