Ikan LBX8 Bedienungsanleitung
LBX8 / LWX8
Quick Start Guide
Lyra Low Profile Soft Panel Light w/ DMX
What’s Included
1 x Lyra Light Fixture
1 x Power supply
1 x Yoke Mount
1 x Power Cord
General Information
Thank you for buying the Ikan Lyra DMX LED Lights. This fixture has been designed to perform
reliably for years when the guidelines in this booklet are followed. Please read and understand the
instructions in this manual carefully and thoroughly before attempting to operate this unit. These
instructions contain important information regarding safety during use and maintenance.
Every fixture has been throughly tested. Carefully check the shipping carton for damage that may
have occurred during shipping. If the carton appears to be damaged, carefully inspect your unit for
damage and be sure all accessories necessary to operate the unit have arrived intact. In the event
damage has been found or parts are missing, please contact our customer support team for further
instructions. Please do not discard the shipping carton in the trash. Please recycle whenever possible.
Safety Instructions
This fixture is an extremely sophisticated piece of electronic equipment. To guarantee a smooth
operation, it is important to follow the guidelines in this manual. The manufacturer of this device will
not accept responsibility for damages resulting from the misuse of this fixture due to the disregard of
the information printed in this manual.
This device falls under PROTECTION CLASS 1. It’s essential this device be grounded properly. Only
qualified personnel should perform all electrical connections.
For proper operation, follow the Installation guidelines described in this manual. Only qualified and
certified personnel should perform installation of this fixture and only the original rigging parts (yoke)
included with this fixture should be used for installation. Any modifications will void the original
manufacturer’s warranty and increase the risk of damage and/or personal injury.
Never look directly into the light source of this fixture to prevent risk of injury to your retina, which
may induce blindness.
Always disconnect from main power source before performing any type of service and/or cleaning
procedure. Only handle the power supply by the plug end, never pull out the plug by tugging the wire
portion of the cord.
Do not operate this fixture if the power cord has become frayed, crimped and/or damaged. If the
power cord is damaged, replace it immediately with a new one of similar power rating.
INDOOR USE ONLY!
DO NOT EXPOSE TO RAIN AND/OR MOISTURE!
DO NOT PLUG FIXTURE INTO A DIMMER PACK!
DMX Channel
The DMX512 channel selection can be made from the back of the fixture using the large yellow knob
to dial in the correct DMX number. When a DMX signal is detected on the fixture, all other controls are
closed down and only DMX channel control can be selected on the rear of the fixture.
Depending on the model, the DMX channel selected will require different channels for use on the
DMX board. LBX8 will require two channels, one for brightness and one for color temperature. LWX8
will require one channel for brightness.
Cleaning & Maintenance
CAUTION! Disconnect power before cleaning or maintenance.
CLEANING
Frequent cleaning is recommended to insure proper function, optimized light output, and an extended
life. The frequency of cleaning depends on the environment in which the fixture operates: damp,
smoky, or particularly dirty environments can cause greater accumulation of dirt on the fixture.
Never use alcohol, solvents, or ammonia- based cleaners
MAINTENANCE
Regular inspections are recommended to insure proper function and extended life. There are no user
serviceable parts inside this fixture. Please refer all other service issues to an authorized ikan service
technician. Should you need any spare parts, please order genuine parts from your local ikan dealer.
Light Channel Brightness Color
LBX8 (Bi-Color) 5 Ch 5 Ch 6
LWX8 (Daylight) 5 Ch 5 N/A
Fixture Menu
ON-BOARD SYSTEM MENU
The fixture comes with an easy to navigate system menu. The next section will detail the functions of
each command in the system menu.
LCD MENU CONTROL KNOB
The control knob allows for local control as well as control from DMX board. The local control gives
the user adjustment from 10%-100% in brightness. The user can also adjust the DMX channels 1
thru 512 by pressing down on the large yellow dial.
General Guidelines
NEVER OPEN THIS FIXTURE WHEN IN USE!
Please make sure there are NO FLAMMABLE MATERIALS close to the fixture while operating, to
prevent any fire hazard.
The fixture must be installed in a location with adequate ventilation, at least 1.5 feet (.5m) from
adjacent surfaces. Be sure no air ventilation slots are blocked.
DO NOT attempt installation and/or operation without knowledge of how to do so.
DO NOT permit operation by persons who are not qualified to operate this type of fixture. Most
damages are the result of operations by nonprofessionals. Consistent operational breaks may ensure
the fixture will function properly for many years to come.
DO NOT shake fixture and avoid using brute force when installing and/or operating the fixture.
Always install the fixture with an appropriate safety cable. When installing the fixture in a suspended
environment, always use correct mounting hardware that can be inserted into the Baby 1/8 in. or
Junior 1-1/8 combo pin adapter.
Use the original packaging and materials to transport the fixture in for service.
Cleaning & Maintenance continued...
Please refer to the following points during routine inspections:
- Be sure all screws and fasteners are securely tightened at all times. Lose screws may fall out during
normal operation resulting in damage or injury as larger parts could fall.
- Check for any deformations on the housing, rigging hardware and rigging points (ceiling, suspension,
trussing). Deformations in the housing could allow for dust to enter into the fixture. Damaged rigging
points or unsecured rigging could cause the fixture to fall and seriously injure a person(s). Electric
power supplies and cables must not show any damage or fraying. Never remove the ground prong
from the power cable.
LBX8 Specifications
LBX8 Photometrics
Beam Angle 110 Degree
Head Type Bi-Color 3200K-5600K
Lens ½ Stop Soft DIffusion
Cooling System Passive Cooling
Control/Dimming Knob Control or DMX
Build Material Heavy Duty Resin Plastic, Aluminum
Yoke Baby 5/8" -- Junior 1 1/8" Combo Pin
Fixture Size 24 x 6.8 x 1.75 in.
Fixture Weight 2.8lbs
Power Supply Input: 110-220VAC
Output: 24VDC 2.75A; 66W
Power Consumption 50W
DISTANCE FC LUX
5ft. / 1.5m 65 695.5
10ft. / 3m 19 204
15ft. / 4.5m 9 101.5
DISTANCE FC LUX
5ft. / 1.5m 64 685.8
10ft. / 3m 18 195.5
15ft. / 4.5m 9 97.6
DISTANCE FC LUX
5ft. / 1.5m 57 609
10ft. / 3m 17 178.3
15ft. / 4.5m 8 88.4
5600K CRI: 97 TLCI: 98
4400K CRI: 96 TLCI: 98
3200K CRI: 96 TLCI: 98
Optional Accessories
Some other products that work well with the Lyra Lights available from Ikan include:
KCP-703
ROLLR-STND10
SW-04
IDX-096
Stage Clamp with 16mm Stud
2-Stage Roller Stand 10 ft 6 in
Safety Wire
96 Channel DMX Console
LWX8 Specifications
LWX8 Photometrics
Beam Angle 110 Degree
Head Type Daylight 5600K
Lens ½ Stop Soft DIffusion
Cooling System Passive Cooling
Control/Dimming Knob Control or DMX
Build Material Heavy Duty Resin Plastic, Aluminum
Yoke Baby 5/8" -- Junior 1 1/8" Combo Pin
Fixture Size 24 x 6.8 x 1.75 in.
Fixture Weight 2.8lbs
Power Supply Input: 110-220VAC
Output: 24VDC 2.75A; 66W
Power Consumption 50W
DISTANCE FC LUX
5ft. / 1.5m 67 721.1
10ft. / 3m 20 215.3
15ft. / 4.5m 10 107.6
5600K CRI: 97 TLCI: 98
Learn More
More dynamic information at official website: www.ikancorp.com
Support
CONDITIONS OF WARRANTY SERVICE
• Free service for one year from the day of purchase if the problem is caused by manufacturing
errors.
• The components and maintenance service fee will be charged if the warranty period is
expired.
Free Service will not be Provided in the Following Situations:
(Even if the product is still within the warranty period.)
• Damage caused by abuse or misuse, dismantling, or changes to the product not made by the
company.
• Damage caused by natural disaster, abnormal voltage, and environmental factors, etc.
©2022 Ikan International. All rights reserved.
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Ikan Beleuchtungsausrüstung Handbücher
Ikan
Ikan RS-F100 Bedienungsanleitung
Ikan
Ikan LSP-004 Bedienungsanleitung
Ikan
Ikan LS-4000E Bedienungsanleitung
Ikan
Ikan IB508-v2 Bedienungsanleitung
Ikan
Ikan MYLO MB-2H1Q Bedienungsanleitung
Ikan
Ikan LW10-3PT-KIT Bedienungsanleitung
Ikan
Ikan LightStar LSKT-004 Bedienungsanleitung
Ikan
Ikan Piatto Lights PL60 Bedienungsanleitung
Ikan
Ikan LS-575PE Bedienungsanleitung
Ikan
Ikan ID500-KIT-v2 Bedienungsanleitung
Ikan
Ikan Rayden Bedienungsanleitung
Ikan
Ikan LW5-5PT-KIT Bedienungsanleitung
Ikan
Ikan LW5-3PT-KIT Bedienungsanleitung
Ikan
Ikan S series Bedienungsanleitung
Ikan
Ikan LEDLITE-300-DMX Bedienungsanleitung
Ikan
Ikan Lightstar LSC-008 Bedienungsanleitung
Ikan
Ikan IDMX36T Bedienungsanleitung
Ikan
Ikan RS-F350 Bedienungsanleitung
Ikan
Ikan RB10-3PT-KIT Bedienungsanleitung
Ikan
Ikan ID 400 Bedienungsanleitung
Beliebte Beleuchtungsausrüstung Handbücher anderer Marken
Qazqa
Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung
Commercial Electric
Commercial Electric 54568141 Bedienungsanleitung
CREE LIGHTING
CREE LIGHTING 304 Series Bedienungsanleitung
Goobay
Goobay 49867 Bedienungsanleitung
ECOMAN ITALIA
ECOMAN ITALIA LED T8 Bedienungsanleitung
Alkalite
Alkalite Krypton KT-81 Bedienungsanleitung
