Impex COMPETITOR CB-359 Bedienungsanleitung

NOTE:

Please read all instructions

carefully before using this

product

Table of Contents

Safety Notice

Hardware Identifier

Assembly Instruction

Parts List

Warranty

Ordering Parts

Model

CB 359

Retain This

Manual for

Reference

08-06-04

OWNER'S

MANUAL

COMPETITOR BENCH

CB-359

IMPEX FITNESS PRODUCTS

14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746

Tel: (800) 999-8899 Fax: (626) 961-9966

www.impex-fitness.com

[email protected]

TABLE OF CONTENTS

BEFORE YOU BEGIN...................................................................................... 1

IMPORTANT SAFETY NOTICE....................................................................... 2

HARDWARE PACK…….......…........................................................................ 3

ASSEMBLY INSTRUCTIONS........................................................................... 4

EXPLODED DIAGRAM.........................................................................………. 8

PARTS LIST…………………………………………………………………………. 9

WARRANTY.................................................................................................…. 10

ORDERING PARTS.......................................................................................… 10

BEFORE YOU BEGIN

Thank you for selecting the Competitor Bench CB359 by IMPEX FITNESS

PRODUCTS. For your safety and benefit, read this manual carefully before

using the machine. As a manufacturer, we are committed to provide you

complete customer satisfaction. If you have any questions, or find there are

missing or damaged parts, we guarantee you complete satisfaction through

direct assistance from our factory. To avoid unnecessary delays, please call

our TOLL-FREE customer service number. Our Customer Service Agents will

provide immediate assistance to you.

Toll-Free Customer Service Number

1-800-999-8899

Mon. - Fri. 9 a.m. - 5 p.m. PST

www.impex-fitness.com

[email protected]m

IMPORTANT SAFETY NOTICE

PRECAUTIONS

This exercise machine is built for optimum safety. However, certain precautions apply

whenever you operate a piece of exercise equipment. Be sure to read the entire manual

before you assemble or operate your machine. In particular, note the following safety

precautions:

1. Keep children and pets away from the machine at all times. DO NOT

leave children unattended in the same room with the machine.

2. Only one person at a time should use the machine.

3. If the user experiences dizziness, nausea, chest pain, or any other abnormal

symptoms, STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.

4. Position the machine on a clear, leveled surface. DO NOT use the machine

near water or outdoors.

5. Keep hands away from all moving parts.

6. Always wear appropriate workout clothing when exercising. DO NOT wear

robes or other clothing that could become caught in the machine. Running

or aerobic shoes are also required when using the machine.

7. Use the machine only for its intended use as described in this manual. DO

NOT use attachments not recommended by the manufacturer.

8. Do not place any sharp object around the machine.

9. Disabled person should not use the machine without a qualified person or

physician in attendance.

10. Before using the machine to exercise, always do stretching exercises to

properly warm up.

11. Never operate the machine if the machine is not functioning properly.

12. A spotter is recommended during exercise.

WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR

PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE

AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL

INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX INC.

ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY

DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.

SAVE THESE INSTRUCTIONS.

HARDWARE PACK

ASSEMBLY INSTRUCTION

Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen

Wrenches

NOTE: It is strongly recommended two or more people assembling this machine to

avoid possible injury.

STEP 1 (See Diagram 1)

A.) Connect the Left Upright Beam (#1) and Right Upright Beam (#2) by a Cross Brace

(#3) in the mid-span. Align the holes and secure each end of the Cross Brace with one

4 ¾” x 2” Bracket (#16), two M10 x 3 ½” Carriage Bolts (#33), two ∅¾” Washers

(#43), and two M10 Aircraft Nuts (#47).

B.) Place the Backrest Adjustment Bar (#5) in between the two Upright Beams on the

selected bar holder to obtain desired incline of Backrest Board.

C.) Insert two Crutches (#7) into the top openings on the Upright Beams. Push down the

Plastic Sleeve (#31) until it locks in place. Secure the Crutches with two Lock Knobs

(#30) through selected holes to obtain desired height of the Supports.DIAGRAM 1

STEP 2 (See Diagram 2)

A.) Attach the Main Stabilizer (#13) to the Cross Brace (#3). Secure it with a 4 3/8” x 1 ½”

Bracket (#15), two M10 x 2 1/8” Carriage Bolts (#35), ∅¾” Washers (#43), and M10

Aircraft Nuts (#47).

B.) Attach the Front Support (#10) to the Main Stabilizer (#13). Secure it with one M10 x 2

3/8” Allen Bolt (#38) and ∅¾” Washer (#43).

C.)Attach one end of Man Seat Support (#4) to the Main Stabilizer (#13). Secure it with two

M10 x 2 ½” Carriage Bolts (#34), ∅¾” Washers (#43), and M10 Aircraft Nuts (#47).

D.)Attach the other end of Main Seat Support (#4) to the Front Support (#10). Secure it

with two M10 x 1” Carriage Bolts (#36), ∅¾” Washers (#43), and M10 Aircraft Nuts

(#47). DIAGRAM 2

STEP 3 (See Diagram 3)

A.) Attach the hole-side of Backrest Supports (#9) to the pivot on the Main Seat Support

(#4). Secure it with one M12 x 6” Hex Bolt (#40), two Ø1” Washers (#42), and one

M12 Aircraft Nut (#46). Place the other end of Backrest Supports rest against the

Backrest Adjustment Bar.

B.) Place the Backrest Board (#17) onto the Backrest Supports (#9). Secure it with four

M6 x 1 3/8” Hex Bolts (#41) and ∅½” Washers (#45).

C.)Place the Seat (#18) onto the Main Seat Support (#4). Secure it with four M6 x 1 3/8”

Hex Bolts (#41) and ∅½” Washers (#45).

DIAGRAM 3

STEP 4 (See Diagram 4)

A.) Attach the Leg Developer (#6) to the open bracket on the Front Support (#10).

Secure it with one M10 x 2 7/8” Allen Bolt (#37), two ∅¾” Washers (#43), and one

M10 Aircraft Nut (#47). Do not over tighten the Nut and Bolt. Make sure the Leg

Developer is able to swivel.

B.) Insert two Foam Tubes (#8) halfway through the holes on the Leg Developer. Push

four Foam Rolls (#20) onto the Foam Tubes.

C.) Attach the Bar Holder (#12) to the Leg Developer (#6). Secure it with a L-shaped

Pin (#48). Remove the Bracket when using the Leg Developer.

D.) Attach the Arm Curl Pad (#19) to the Arm Curl Stand (#11) then secure it with two

M8 x 5/8” Allen Bolts (#39) and two ∅5/8” Washers (#44).

E.) Insert the Arm Curl Stand (#11) into the top opening on the Front Support (#10).

Secure it with a Lock Knob (#30). Use the Lock Knob to select the Arm Curl height.

F.) Attach a Spring Clip (#49) to the weight post on the Leg Developer. Attach two

Spring Clips (#49) to the Curl Bar (#14). DIAGRAM 4

PARTS LIST

KEY NO. DESCRIPTION Q’ty

1 Left Upright Beam 1

2 Right Upright Beam 1

3 Cross Brace 1

4 Main Seat Support 1

5 Backrest Adjustment Bar 1

6 Leg Developer 1

7 Crutch 2

8 Foam Tube 2

9 Backrest Support 2

10 Front Support 1

11 Arm Curl Stand 1

12 Bar Holder 1

13 Main Stabilizer 1

14 Curl Bar 1

15 4 3/8” x 1 ½” Bracket 1

16 4 ¾” x 2” Bracket 2

17 Backrest Board 1

18 Seat 1

19 Arm Curl Pad 1

20 Foam 4

21 1 ¾” Square End Cap 2

22 1 ½” Square End Cap 2

23 1” Square End Cap 2

24 ∅1” End Cap 1

25 ∅1” Cone-shape End Cap 3

26 ∅¾” Cone-shape End Cap 4

27 2 ¾” x 2” End Cap 4

28 1 ¾” x 1 ½” Sleeve 1

29 Plastic Bushing 2

30 Lock Knob 3

31 3” x 2 ¼” Sleeve 2

32 Crutch End Cap 2

33 M10 x 3 ½” Carriage Bolt 4

34 M10 x 2 ½” Carriage Bolt 2

35 M10 x 2 1/8” Carriage Bolt 2

36 M10 x 1” Carriage Bolt 2

37 M10 x 2 7/8” Allen Bolt 1

38 M10 x 2 3/8” Allen Bolt 1

39 M8 x 5/8” Allen Bolt 2

40 M12 x 6” Hex Bolt 1

41 M6 x 1 3/8” Hex Bolt 8

42 Ø 1” Washer 2

43 Ø ¾” Washer 13

44 Ø 5/8” Washer 2

45 Ø ½” Washer 8

46 M12 Aircraft Nut 1

47 M10 Aircraft Nut 11

48 L-shaped Pin 1

49 Spring Clip 3

50 Philips Screw 4

Inhaltsverzeichnis

Andere Impex Heim-Fitnessstudio Handbücher

Impex

Impex MARCY SM 4000 Bedienungsanleitung

Impex

Impex Marcy SB-1315 Bedienungsanleitung

Impex

Impex Iron Grip Strength IGS-412 Bedienungsanleitung

Impex

Impex MARCY DELUXE MD-5191 Bedienungsanleitung

Impex

Impex TSA-42 Bedienungsanleitung

Impex

Impex Marcy MWB-4360 Bedienungsanleitung

Impex

Impex MARCY PRO 5 Bedienungsanleitung

Impex

Impex Powerhouse Club PHC 750 Bedienungsanleitung

Impex

Impex MARCY SM 2000 Bedienungsanleitung

Impex

Impex MARCY MD-9010 Bedienungsanleitung

Impex

Impex Iron Grip Strength IGS-43 Bedienungsanleitung

Impex

Impex COMPETITOR WM-1505 Bedienungsanleitung

Impex

Impex MARCY MCB-880M Bedienungsanleitung

Impex

Impex MARCY SB-222 Bedienungsanleitung

Impex

Impex MARCY PRO TC-4699 Bedienungsanleitung

Impex

Impex MARCY MWM-1860 Bedienungsanleitung

Impex

Impex WM PRO Bedienungsanleitung

Impex

Impex IRON GRIP STRENGTH TSA-5761 Bedienungsanleitung

Impex

Impex MARCY PRO SM-7409 Bedienungsanleitung

Impex

Impex PLATINUM MARCY PM-3000 Bedienungsanleitung

Impex

Impex Marcy MWM-8150 Bedienungsanleitung

Impex

Impex Marcy Diamond Elite MD-MXM6 Bedienungsanleitung

Impex

Impex MARCY MWB-2001 Bedienungsanleitung

Impex

Impex MARCY PLATINUM MP-3500 Bedienungsanleitung

Beliebte Heim-Fitnessstudio Handbücher anderer Marken

Horizon Fitness

Horizon Fitness OXFORD 6 Bedienungsanleitung

Energetics

Energetics Multi Trainer 5.1 Bedienungsanleitung

Matrix

Matrix MG-PL Series Bedienungsanleitung

Reebok

Reebok Tbr2i Bedienungs- und Wartungshandbuch

Weider

Weider 8300 Hard Drive Bedienungsanleitung

Pure Fitness

Pure Fitness 8526HE Bedienungsanleitung

Weider

Weider 8700 I Kurzanleitung

Bowflex

Bowflex Sport 001-6961 Bedienungsanleitung

NordicTrack

NordicTrack E8200 Competition Bench Kurzanleitung

Weider

Weider WEMC10161 Bedienungsanleitung

Body Solid

Body Solid GHYP-345 Bedienungsanleitung

Evo

Evo TAHOE 5105 Bedienungsanleitung

cardiobull

cardiobull RA17 Bedienungsanleitung

ParaBody

ParaBody 40 Bedienungsanleitung

JLL

JLL Ventus Pro Air Power Bedienungsanleitung

Trojan

Trojan Colorado 370 Bedienungsanleitung

Octane Fitness

Octane Fitness xRide xR650 Bedienungsanleitung

Precor

Precor Discovery Series Bedienungsanleitung