Page9
Warning>Avertissement
1. Please do not disassemble the product if you are not a professional.
>Veuillez ne pas démonter le produit si vous n'êtes pas un professionnel.
2. Be sure that the sensor is not covered with dust as dust may lead to inaccurate
measurements.
>Veillez à ce que le capteur ne soit pas couvert de poussière, car la poussière peut
entraîner des mesures inexactes.
3. Do not use alcohol to clean the sensor.
>Ne pas utiliser d'alcool pour nettoyer le capteur.
FCC Requirement>Exigence FCC
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
>Les changements ou modifications non expressément approuvés par la partie
responsable de la conformité peuvent annuler le droit de l'utilisateur à utiliser
l'équipement. Cet appareil est conforme à la partie 15 des règles FCC. Son
fonctionnement est soumis aux deux conditions suivantes:
(1) cet appareil ne doit pas provoquer d'interférences nuisibles, et
(2) cet appareil doit accepter toute interférence reçue, y compris les interférences
susceptibles de provoquer un fonctionnement indésirable.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy,
and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
