Inogen One G3 Technisches Dokument
BOC: Living healthcare
Inogen One® G3
portable concentrator.
Equipment guide.
605360-HC Inogen One G3 POC Brochure NHS-03.indd 1 09/06/2017 08:31
02 Inogen One® G3 portable concentrator
3 Introduction
4 Inogen One® G3 overview
6 Filters and connections
7 How to use the Inogen One® G3
10 Battery charging
11 Dos and don’ts
12 Alarms and warnings
17 Troubleshooting
18 Cleaning and maintenance
19 InogenOne®G3specications
Contents.
605360-HC Inogen One G3 POC Brochure NHS-03.indd 2 09/06/2017 08:31
03Inogen One® G3 portable concentrator
Introduction.
The air we breathe is made up of 21% oxygen, 78% nitrogen and
1% other gases.
Your Inogen One® G3 portable oxygen concentrator works by drawing
in air and separating out oxygen from other gases using a lter system.
This lter traps some gases; but allows oxygen to pass through.
This oxygen, now up to 95% pure, is delivered to you via your nasal
cannula to assist in your breathing and ability to get out and about.
It is lightweight, compact, reliable and highly efcient. The Inogen
One® G3 therefore gives you increased mobility whilst using oxygen.
BOC Homecare hopes that this product and the support, training
and education we offer will benet you and that, in turn, you will be
able to get out and about as much as possible so you can live life to
the fullest.
605360-HC Inogen One G3 POC Brochure NHS-03.indd 3 09/06/2017 08:31
04 Inogen One® G3 portable concentrator
ON/OFF button
Press button once to turn the device “ON”.
Press and hold for one second to turn the device
“OFF”.
Audible alarm button
Pressing this button will toggle the Inogen One®
G3’s breath detection audible alert on and off.
See page 12 for more information.
Flow control buttons
Use the ow control buttons (– or +) to change the
setting shown on the display. Depending on device
version, there are four or ve settings (1 to 4, or 1
to 5 pulsed).
Display backlight button
Push this button to turn on the display backlight
for better illumination of the device settings. The
backlight turns off again automatically after 10
seconds.
Inogen One® G3 device overview.
Display
Flow control Alert/alarm light
Audible alarm button
Breath detection light
ON/OFF button
Display back light button
605360-HC Inogen One G3 POC Brochure NHS-03.indd 4 09/06/2017 08:31
05Inogen One® G3 portable concentrator
Display
This screen displays information regarding ow
setting, power status, battery life and errors. In the
picture to the right, the device is at setting 4, with
one hour and 26 minutes of battery life remaining
at this setting.
Indicator lights
A red light indicates a change in operating status or
a condition that may need a priority response.
A ashing light is a higher priority than a solid light.
Audible signals
An audible signal (beep) indicates a change in
operating status or a condition that may need a
priority response (alarm). More frequent beeps
indicate higher priority conditions.
605360-HC Inogen One G3 POC Brochure NHS-03.indd 5 09/06/2017 08:31
06 Inogen One® G3 portable concentrator
InogenOne®G3ltersandconnections.
Particlelters
Particle lters keep out dust, dirt and large
particles. They must be kept in place during
concentrator operation to keep input air clean.
Note: depending on device version, the intake
lters may be at the top or bottom of the device.
Please see the picture on the opposite page.
Cannulatting
Your high-ow nasal cannula connects to this outlet
for oxygen delivery.
Power input
Located at the top of the device to one side, this
is the connection for external power from the AC
power supply or DC power cable.
605360-HC Inogen One G3 POC Brochure NHS-03.indd 6 09/06/2017 08:31
07Inogen One® G3 portable concentrator
How to use the Inogen One® G3.
Important: Please read the important safeguards in the “Dos and
don’ts” section and observe all warnings and cautions in this guide.
Follow all operating instructions. If you have any questions or concerns
please call BOC immediately on 0800 136 603.
1. Device location
Place your Inogen One® G3 device in a well-
ventilated location so the intake and exhaust vents
are clear and unobstructed (the position of these
can vary as pictured alongside). The device should
also be located so auditory alarms can be heard.
2. Filters
Ensure both intake particle lters (those with the
blue plastic surround) are clean and correctly
installed.
3. Battery
Install the Inogen One® G3 battery by sliding it into
place at the bottom of the device until an audible
click is heard and the latch securing the battery to
the device returns to the upper position.
Exhaust
Exhaust
Intake
Intake
605360-HC Inogen One G3 POC Brochure NHS-03.indd 7 09/06/2017 08:31
08 Inogen One® G3 portable concentrator
How to use the Inogen One® G3.
4. Power sources (AC, DC, Battery)
The Inogen One® G3 portable concentrator can
operate from AC, DC or battery power, with the
detachable battery acting as a secondary power
supply in the event of power loss (AC or DC).
Therefore, when operating the device from AC or DC
power, you should always keep a properly-inserted
battery in the unit. This will ensure uninterrupted
operation and continuous oxygen production.
AC operation (mains)
Connect the AC power plug to mains power. Then
connect the AC power output plug into the Inogen
One® G3 device as shown below. The LED on the
power supply will illuminate and a beep will sound
from the concentrator.
DC operation (eg. car 12 volt)
Connect the DC power plug to a 12 volt car power
outlet or auxiliary DC power supply. Then connect
the DC power plug into the Inogen One® G3 device
as shown below.
Battery operation
To operate the device via its detachable battery,
install the battery by sliding it into place at the
bottom of the device until an audible click is heard
and the battery latch returns to the upper position.
5. Connect nasal cannula
The oxygen outlet tting is located at the top of
the device. Push your high-ow nasal cannula
tubing onto this, ensuring a good seal and tight t
between the tubing and oxygen outlet.
6. Turn on device
Turn the device on by pressing the ON/OFF button.
A single, short beep will sound after the logo is
displayed. The display will show the selected ow
setting and power condition. Following this, the
device takes up to 2 minutes to warm up (longer
if stored in a cold environment). During this time,
the oxygen purity of the device is building to – but
may not reach – specication. You should therefore
leave the device to run for at least two minutes
prior to use.
605360-HC Inogen One G3 POC Brochure NHS-03.indd 8 09/06/2017 08:31
09Inogen One® G3 portable concentrator
7.Pulsedowsetting
When powered up, the Inogen One® G3 device
retains the previous setting it was used at. If you
need to change this, use the “+” or “–“ setting
buttons to adjust to the desired setting (1, 2, 3, 4 or
5 pulsed ow). The current setting is viewed on the
display. Note: you should only use the device at the
setting prescribed by your clinician (or only change
as clinically instructed).
8. Oxygen delivery
Position the nasal cannula on your face with the
soft prongs sitting just inside your nostrils and
breathe through your nose. The Inogen One®
G3 device will sense the onset of inhalation and
deliver a pulse of oxygen when you inhale through
your nose. Thereafter, the device senses each
breath and delivers oxygen every time you inhale
through your nose, even if your breathing rate
changes.
Note: A green light will ash on the top of the
unit each time a breath is detected. Make sure the
nasal cannula is properly aligned on your face and
you are breathing through your nose to trigger the
device to deliver pulses of oxygen.
9. Power OFF
When you are nished using the device, press and
hold the ON/OFF button for approximately one
second. Store the Inogen One® G3 unit in a cool,
dry location when not in use.
breath
detection light
605360-HC Inogen One G3 POC Brochure NHS-03.indd 9 09/06/2017 08:31
10 Inogen One® G3 portable concentrator
Battery charging.
When out and about, your Inogen One® G3 device
operates from battery power which will discharge
over time. You therefore need to monitor the device’s
battery status and keep it charged up as required
(the device display indicates the estimated remaining
percentage (%) or minutes of available use).
When the concentrator detects that battery life
is low (<10 mins remaining) a low priority alert
will sound. When the battery is empty, the alert
changes to a high priority. When battery life is low,
do one of the following:
→Plug the Inogen One® G3 into an AC or DC power
source using the AC power supply or DC cable.
→Replace the battery with a charged battery after
turning off the Inogen One® G3 (by pressing
the ON/OFF button). To remove a battery, press
and hold the battery latch button and slide the
battery away from the concentrator.
→If the battery is drained, charge the battery or
remove it from the concentrator.
→If the Inogen One® G3 is being powered by the
AC power supply or DC power, batteries will
charge during operation.
→Note: leaving your Inogen One® G3 device
plugged in past full charge will not harm the
concentrator or battery.
To ensure your battery is properly charging, use
the correct AC or DC power cables and check that
the display shows a battery-charging symbol (see
p12 for examples). To take care of your device, only
use Inogen One® G3 batteries as supplied by BOC
Homecare.
Always:
→Store device batteries in a cool, dry place.
→Keep liquids away from batteries. If batteries
become wet, discontinue use immediately and
dispose of the battery properly.
→If using multiple batteries, make sure that each
battery is rotated-for-use on a regular basis.
Batteries should not be left dormant for more
than 90 days at a time.
605360-HC Inogen One G3 POC Brochure NHS-03.indd 10 09/06/2017 08:31
Andere Handbücher für One G3
12
Inhaltsverzeichnis
Andere Inogen Medizinische Geräte Handbücher
Inogen
Inogen TAV Bedienungsanleitung
Inogen
Inogen One G5 Bedienungsanleitung
Inogen
Inogen TIDAL ASSIST Bedienungsanleitung
Inogen
Inogen One G4 Bedienungsanleitung
Inogen
Inogen One G2 Bedienungsanleitung
Inogen
Inogen One G3 Bedienungsanleitung
Inogen
Inogen One G5 Bedienungsanleitung
Inogen
Inogen One G4 Bedienungsanleitung
Inogen
Inogen Rove 6 Bedienungsanleitung
Inogen
Inogen at home Bedienungsanleitung
Inogen
Inogen One G3 Bedienungsanleitung
Inogen
Inogen One Bedienungsanleitung
Inogen
Inogen One G3 Bedienungsanleitung
Inogen
Inogen One G2 Bedienungsanleitung
Inogen
Inogen One G3 Bedienungsanleitung
Inogen
Inogen One G4 Bedienungsanleitung
Inogen
Inogen One G5 Bedienungsanleitung
Inogen
Inogen One IO-100 Bedienungsanleitung
Inogen
Inogen One G5 Bedienungsanleitung
Inogen
Inogen One G2 Bedienungsanleitung
Beliebte Medizinische Geräte Handbücher anderer Marken
TekTone
TekTone Tek-CARE160 Bedienungsanleitung
NeuroMetrix
NeuroMetrix Quell 2.0 Bedienungsanleitung
AMT
AMT XLR8 Bedienungsanleitung
Medipost-Nutristoma
Medipost-Nutristoma MD300K2 Bedienungsanleitung
EDAN
EDAN SONOTRAX Pro Bedienungsanleitung
Restorative Therapies
Restorative Therapies RT300 Bedienungsanleitung
