JFM Engineering SuperMasterCharger Betriebsanleitung
Tutorial
SuperMasterCharger
Battery Charger-Analyzer
Preliminary –V0.9
1SMC Tutorial
Receiving –Inspection
1. Unpacking the unit
1. Caution! Heavy equipment.
2. Verify that the following are in the package:
•Charger-Analyzer
•Accessory Kit containing:
–Battery Cable
–Temp-Plate
–Single Cell Adaptor
–Spare Parts
•Operator Manual, Commands Sheet, and various certificates
3. Inspect the equipment
4. Save the carton –It will be needed if the equipment has
to be sent out for calibration/repair.
2SMC Tutorial
Installation
1. Place the Charger-Analyzer on a suitably strong
bench
1. Caution! Heavy equipment (175 lb. –79.3 Kg)
2. Connect to a dedicated (not shared) outlet with
208V/230V/240V with 30A capability (with motor load
rated circuit breaker)
1. In the US, use a NEMA-630R receptacle
2. Very that the unit is wired for the proper line (mains) voltage
3SMC Tutorial
Installation (continued)
3. Connect the Battery Cable to the Front Panel and
connect the Temp-Plate sensing cable
4. Connect the Temp-Plate sensing cable extension to the
Temp-Plate
•Note that there are two DB9 cables in the Temp-Plate. Connect to
either one (the other one is used by the BTAS-16)
5. Connect the extension Cable to the Rear Panel
Connector
4SMC Tutorial
Installation (continued)
6. Turn Power ON
7. Observe the following:
•Meters and Timer indicators are ON
•Ammeter reads zero and Voltmeter reads about 0.2V
•Status indicators show RESET (green)
5SMC Tutorial
Operating Introduction
1. Tutorial for the operation of the SMC Battery
Charger-Analyzer
2. Refer to the Operator’s Manual for complete details
on the operation of the instrument
Section 5 –Controls and Displays
Section 6 –Modes of Operation
Section 7 –Keypad Functions
Command Instructions (separate sheet)
6SMC Tutorial
Warnings (general)
1. This tutorial is intended for professional personnel
experienced in the testing of aircraft batteries
2. Refer to the Operator’s Manual for complete details
on the operation of the instrument
3. Information provided on battery testing is solely as
an operational reference - Refer to the
manufacturer’s battery manual and/or CMM for
battery specific information
SMC Tutorial 7
Warnings (specific)
1. Observe precautions when handling batteries
1. Batteries are heavy
2. Batteries will generate extremely high currents if shorted
•Tools can easily be dropped shorting several cells
2. Follow battery test procedures as outlined in the
CMMs and OMMs provided by the manufacturers.
3. The Operator is ultimately responsible for the
correct and proper analysis of the batteries under
test.
SMC Tutorial 8
Basic Information
1. The SMC Battery Charger-Analyzer operates based
on programmed battery test profiles
2. A battery test profile is based on the following
parameters:
Test Mode (type of test)
Time Duration (s)
Current (s)
Voltage (s)
3. Consult the CMMs for battery specific test
parameters
SMC Tutorial 9
Keypad Functions
1. Numeric Keys
0 through 9 for the entry of parameters
2. Other Keys
VIEW
•For the review of programmed information
FUNCTION
•For special operations such as different Timer Speed and other (see the
Commands sheet)
•Note: FUNCTIONS revert to default values when power is turned off
MODE
•Battery Test Mode
BATTERY
•For stored Battery Test Profiles
OPTION
•Special operational selections as number of batteries and other (see the
Commands sheet)
•Note: OPTIONS are maintained in non volatile memory (selections remain
after power is turned off)
SMC Tutorial 10
Inhaltsverzeichnis
Andere JFM Engineering Messgerät Handbücher
