JGR RL1 Bedienungsanleitung
Getting Started with the RL1
www.jgroptics.com
Getting Started with the RL1
www.jgroptics.com
M12 Cable
Communications and
charging cable for the RD-S
RD-S
Remote-head detector
with Gen.2 integrating
cavity
SD01
Slide FC detector adapter
SD00
Slide detector cap
RL1
Automated return loss meter
Getting Started with the RL1
www.jgroptics.com
•Press once: power on
or reset the wireless
connection
•Press and hold for 7
seconds: power off
M12 input (from 2nd RD-S) M12 output (to RL1)
Micro-USB charging port
•Press once: reset
network settings
•Do NOT press and
hold for > 5 seconds
M12 input (from RD-S)
USB-B to PC USB-A to peripherals
ex: SX1 switch, barcode scanner, etc
Ethernet port
Getting Started with the RL1
www.jgroptics.com
Use the M12 cable to connect the RD-S from the output port (with the RL1 diagram) to the RL1 input
port. Connect a power cable to the RL1 and turn on the unit.
Getting Started with the RL1
www.jgroptics.com
Swipe left and right on the front panel touchscreen to access the various pages. Swipe all the way to the
right to access the Detectors page. Make sure the RD-S is turned on.
Press the wireless button
to turn on the RD-S. The
red LED will light up.
Getting Started with the RL1
www.jgroptics.com
•Press X on an item in the Paired list to unpair a detector.
•Press and hold on the touchscreen to rescan for wired detectors.
Getting Started with the RL1
www.jgroptics.com
To pair a new detector, press on an item in the Pair New list.
Wired device
Wireless device
Getting Started with the RL1
www.jgroptics.com
Battery indicator Ready to use
Wireless signal strength
Getting Started with the RL1
www.jgroptics.com
Swipe two pages left to access the Setup page.
RL acquisition speed
DUT length
Acquisition mode
Andere Handbücher für RL1
2
Andere JGR Messgerät Handbücher
