JL Audio Stealthbox SB-GM-CLDRO/10W3v3 Bedienungsanleitung

➔

Stealthbox®

INSTALLATION GUIDE

SB-GM-CLDRO/10W3v3, JL AUDIO, Inc 2006 Sheet SKU#011189 Revision 3/8/2006Page 1

for the

SB-GM-CLRDO/10W3v3

(2004-Up Chevrolet Colorado & GMC

Canyon Crew Cab)

This Stealthbox is a product which

requires professional installation skills and

tools.

Please read this installation guide thor-

oughly before beginning the project. It

will guide you step by step through the

installation.Several of the steps in this

process may require two people to

accomplish.

It is absolutely vital that the enclosure

be properly mounted to the vehicle

according to these instructions. Failure

to mount the enclosure properly pres-

ents two problems: 1)The sub-bass

performance will suffer due to the

movement of the enclosure caused by

the force exerted by the woofer(s) and

2) A loose enclosure presents a serious

safety hazard in the event of a collision

or sudden deceleration.

Please enjoy your JLAudio Stealthbox

responsibly.

STEP 1:

With an 18mm deep socket,

remove the two front mounting nuts.

Also remove the jack out of the metal holder.

STEP 2:

There are two rear mounting nuts

that need to be removed.With a long exten-

sion and the 18mm deep socket.Remove the

rear mounting nuts.

STEP 3:

With the rear mounting nuts

removed,tilt the rear seat forward,off the

mounting studs.

STEP 4:

With the rear seat tilted forward,

locate the middle passenger’s shoulder safety

belt.Follow the belt down to the latch.With a

flat blade screw driver, push the red button.

This will disengage the shoulder belt.Pull the

belt through the crease of the seat and up to

the return pocket, located on the back wall.

STEP 5:

Remove the rear seat out of the

vehicle.You should use a second person to

help out.

Also remove the metal jack holder.

*At this time run speaker wire from the

amplifier area to the Stealthbox area. Double

check the woofer for proper working order.*

STEP 6:

Place the middle of the supplied wax

square, in the middle of the mounting studs

and 3-3/4”from the point of the floor as it

starts to elevate up. Remember to remove

the paper backing.

If the Stealthbox is mounted to far to the rear,

the rear seat will not fit.If the Stealthbox is

mounted to far forward,it will hit the front

center console.

START

HERE

Continued on Next Page ➔

www.jlaudio.com

➔

X3-3/4”

18-1/16”

36-1/8”

➔

STEP 7:

(A) Thread the supplied socket cup

screw into the Stealthbox.Leave 1/2”exposed.

(B) Place the Stealthbox into position and line

up the curved corners of the Stealthbox, that

are between the woofer and the square shape

of the Stealthbox.These corners need to line

up with the curvature of the transmission

hump floor as it goes to the rear and jets to

the right and left of the truck. Once into place,

push down with force.

(C)With a 1/2” drill bit, drill at the impression that

was left by the Stealthbox in STEP6.

Cont.

From

Page

Continued on Next Page ➔

➔

STEALTHBOX WALL THREADED INSERT

VEHICLE SHEET METAL

FENDER WASHER SOCKET CUP SET SCREW

LOCK WASHER

FLAT WASHER

HEX NUT

STEP 8: With the drilled out hole in the floor.

Expose the socket cup set screw 2” out of the

Stealthbox.Place the Stealthbox into position and

guide the socket cup set screw through the drilled

hole.

From under the vehicle, place the supplied fender

washer, flat washer, lock washer and hex nut onto

the socket cup screw.

STEP 9: Place the jack back into the holder and

then place the jack assembly to the floor(same area

it was removed from) with the yellow knob facing

the passenger’s side rear door.With one factory

mounting bolt. Secure the assembly with to the dri-

ver’s side mounting threads. Use the second factory

mounting bolt to plug up the passenger’s side

mounting threads.

STEP10: With a second person, place the rear

seat back into position.Wrap the shoulder belt in

front of the seat and through bottom crease of the

seat.

SB-GM-CLDRO/10W3v3, JL AUDIO, Inc 2006 Sheet SKU#011189 Revision 3/8/2006Page 2

www.jlaudio.com

*CAUTION*

Before drilling, make sure that you are not going to be

drilling into any gas lines, brake lines, transmission lines,

electrical wiring, transfer case(4x4 vehicles) or anything

else that might cause a reduction in your weekly pay.

Always wear eye protection when drilling.

With the use of a 1/2” drill bit and drill. Drill out the

floor at the impression on the wax square.

After the hole is drilled, remove the wax square

➔

Specifications:

Enclosure Type: Sealed

Driver Type: 10W3v3-4

Nominal Impedance: 4Ω

Cont. Power Handling: 300Watts

JLAudio recommends using a high quality amplifier such as the JLAudio 250/1. The diagram below shows the recommended

crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power your Stealthbox®.

Included Hardware:

(1) Wax Square

(1) 2-14”Socket Cup Set Screw

(1) FenderWasher

(1) FlatWasher

(1) LockWasher

(1) Hex Nut

10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111

JL AUDIO 250/1

monoblock subwoofer amplifier

Amplifier Input Section

Input Sens.

Input Voltage

Low/High

Left Ch. Right Ch.

Signal Sensing

Off/On

Output Mode

Full-Range/Low-Pass/High-Pass

Left Ch. Right Ch.

Amp LP Filter

Mode/Slope

Off/12dB/24dB

Filter Freq. (Hz)

Bass Control

LF Boost (dB)

Off/30Hz

Infrasonic Filter

+1 +13

+10

Preamp Output Section

+12VDC Ground Remote

The JLAudio 250/1 is a very versatile audio component. Please consult the owner’s manual for detailed information

about installing and tuning this amplifier.

➔➔

STEP 11: With the shoulder belt through the bot-

tom crease. Snap the belt back into the latch. STEP 12: Flip the rear seat back into the up-right

position.

➔

SB-GM-CLDRO/10W3v3, JL AUDIO, Inc 2006 Sheet SKU#011189 Revision 3/8/2006Page 3

www.jlaudio.com

Mid/High Frequency Driver Information:

CONGRATULATIONS!

INSTALL COMPLETE.

XR650-CSi

VR650-CXi

Front Location Driver Size:

6.5” separates

Applicable JL Audio Products:

VR, XR,VR &TR 650-CSi

*with 1/2” spacer

Rear Location Driver Size:

6.5”

Applicable JL Audio Products:

XR,VR &TR 650-CXi

*with 1.0” spacer

Cont.

From

Page

Difficulty Of Installation:

Dieses Handbuch passt für folgende Modelle

Andere JL Audio Subwoofer Handbücher

JL Audio

JL Audio Stealthbox SB-S-IMPRZA/10W6v2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-J-UNLTD4DR/13TW5-3 Bedienungsanleitung

JL Audio

JL Audio 10W0v3-4 Bedienungsanleitung

JL Audio

JL Audio 12W1v2-4 Bedienungsanleitung

JL Audio

JL Audio 12W6v3-D4 Bedienungsanleitung

JL Audio

JL Audio 12TW1-4 Bedienungsanleitung

JL Audio

JL Audio 13TW5v2-2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-EQNX/10W1v3 Bedienungsanleitung

JL Audio

JL Audio 10W6v2-D4 Bedienungsanleitung

JL Audio

JL Audio MX10IB3-SG (LED) Bedienungsanleitung

JL Audio

JL Audio Fathom IWSv2-SYS-113 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-SC-XB/10W3v3-4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox Series Bedienungsanleitung

JL Audio

JL Audio 10W1v2-4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-CAM12W6v2 Bedienungsanleitung

JL Audio

JL Audio 94606 Bedienungsanleitung

JL Audio

JL Audio 15W3v2-D2 Bedienungsanleitung

JL Audio

JL Audio 10W0 Bedienungsanleitung

JL Audio

JL Audio Fathom IWS Bedienungsanleitung

JL Audio

JL Audio 10WXv2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-ESCESV/10W1v3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-H-RIDGLNE/10W3v3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-POL-RNGR/SYS Bedienungsanleitung

JL Audio

JL Audio 15W1-4 Bedienungsanleitung

Beliebte Subwoofer Handbücher anderer Marken

Sony

Sony XS-AW8 Bedienungsanleitung

Sony

Sony XS-L836 Bedienungsanleitung

B&C Speakers

B&C Speakers 15 HPL 76W Bedienungsanleitung

Velodyne

Velodyne DD-18+ Bedienungsanleitung

Sonance

Sonance Cinema Series SUB 10-150 Bedienungsanleitung

Hifonics

Hifonics HW-12 Kurzanleitung

Magnat Audio

Magnat Audio ADR 130 BP Bedienungsanleitung

Blitz

Blitz BZP106 Bedienungsanleitung

Technics

Technics SB-AS500 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-2 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-3 Bedienungsanleitung

Pyle Pro

Pyle Pro PYLE PRO PDW15125 Bedienungsanleitung

REL Acoustics

REL Acoustics Q Series Bedienungsanleitung

L-Acoustics

L-Acoustics KIVA SB15M Kurzanleitung

Pioneer

Pioneer Elite S-W1EX Bedienungsanleitung

B&C Speakers

B&C Speakers Woofer 12 HPL 76 Bedienungsanleitung

KEF

KEF KUBE 200 Bedienungsanleitung

Yamaha

Yamaha SW500 Bedienungsanleitung