JL Audio Stealthbox SB-GM-EQNX/10W1v3 Bedienungsanleitung

INSTALLATION GUIDE

for the

SB-GM-EQNX/10W1v3

SKU#94503

2010-2017 Chevrolet Equinox / GMC Terrain

Thank you for choosing a JL Audio Stealthbox®for your automotive sound system. With proper installation, your new vehicle-

specific enclosed subwoofer system will deliver years of listening pleasure.

We strongly recommend that you have your new Stealthbox®installed by your authorized JL Audio dealer. The installation

professionals employed by your dealer have the necessary tools and experience to disassemble and reassemble your vehicle

properly. Also, keep in mind that your warranty coverage extends to 2 years if your system is installed or approved by your

authorized JL Audio dealer. If you prefer to perform your own installation, please read this installation guide completely

before beginning the process.

If you choose to perform the installation yourself, it is absolutely vital that

the Stealthbox®be properly mounted to the vehicle according to these

instructions. Failure to mount the enclosure properly presents two problems:

1) The sub-bass performance will suffer due to the movement of the enclosure

caused by the force exerted by the woofer(s).

2) A loose enclosure presents a serious safety hazard in the event of a collision

or sudden deceleration.

STEP 1

Empty out the trunk of the vehicle so that you have a clean

area to work in.

Continued on Next Page

STEP 2

Remove the trunk floor, as well as the rear sill panel, by

pulling up on the panel to release the clips.

STEP 3

Lift up on the covers of each tie down hook to expose the

screws, and remove both screws and hooks.

SB-GM-EQNX/10W1v3/BK INSTR_SKU# 011318

INSTALLATION

DIFFICULTY:

OUT

ESTIMATED TIME:

1 HOUR

Continued on Next Page

SB-GM-EQNX/10W1v3/BK INSTR_SKU# 011318

STEP 7

Remove the two nuts holding the top of the enclosure in

place. Continue by removing the two nuts holding the

bottom of the enclosure in place. Disconnect the sub wiring

and remove the factory sub enclosure. Retain all four nuts

for the installation of the Stealthbox®.

STEP 6

With the side panel out of the vehicle, the factory sub

enclosure can now be removed.

STEP 5

Pictured is the weatherstripping removed from the side

panel. Starting here, begin unclipping the side panel and

continue toward the rear of the vehicle, and remove the

panel.

STEP 4

Open the rear passenger side door. Pull up the

weatherstripping to allow access to the sill panel and side

panel. Remove the sill panel by pulling up on the panel to

release the clips.

Page 2 • JL Audio, Inc 2017

STEP 9

Attach the two Upper Brackets to the Stealthbox® as shown

using a 1/4” Flat Washer, 1/4” Lock Washer, and 1/4 - 20 x

1” Bolt on each. Hand tighten to allow the brackets to be

adjusted later.

STEP 11

Set the Stealthbox® in place by sliding the bottom of the

enclosure behind the Lower Brackets, and aligning the Upper

Brackets with the upper threaded studs. Hand tighten the

factory nuts on the threaded studs, and mark the location of

the Upper Brackets on the top of the enclosure. Firmly press

the enclosure toward the side of the vehicle, slide the Lower

Brackets into place, and mark the location of the Lower

Brackets on the floor of the vehicle.

Remove the Stealthbox®, align the Upper Brackets with the

marks on the enclosure, and firmly tighten. Align the Lower

Brackets with the marks in the vehicle, and firmly tighten.

STEP 10

Attach the two Lower Brackets to the threaded studs using

the factory nuts, as shown. The smaller, angled bracket goes

on the stud closest to the rear of the vehicle. Hand tighten

to allow the brackets to be adjusted later.

STEP 8

Pictured without the factory sub enclosure are the threaded

studs that held the bottom of the enclosure in place. It is not

necessary to remove the bracket for the foam floor support.

SB-GM-EQNX/10W1v3/BK INSTR_SKU# 011318

STEP 15

Reinstall the side panel, tow hooks, sill panels,

weatherstripping, and floor.

STEP 14

Pictured is the Stealthbox® mounted in place.

STEP 13

Attach the two Lower Brackets to the Stealthbox® as shown

using a 1/4” Flat Washer, 1/4” Lock Washer, and a 1/4 - 20 x 1”

Bolt on each, and firmly tighten.

STEP 12

Attach the speaker wire to the Stealthbox®, set the enclosure

back in place, and firmly tighten the factory nuts on the

upper threaded studs.

Page 3 • JL Audio, Inc 2017

STEP 16

CONGRATULATIONS!

You have completed the installation for this model!

Enjoy your new Stealthbox®!

Please refer to the Power Recommendation section for an

amplifier recommendation and basic set-up help.

Continued on Next Page

SB-GM-EQNX/10W1v3/BK INSTR_SKU# 011318

Page 4• JL Audio, Inc 2017

INCLUDED HARDWARE

(4) 1/4” Flat Washer (4) 1/4 - 20 x 1” Bolt (2) Lower Bracket

(4) 1/4” Lock Washer (2) Upper Bracket

SPECIFICATIONS

Enclosure Type: Acoustic Suspension (sealed)

Driver Type: 10W1v3-2

Nominal Impedance: 2 ohm

Continuous Power Handling: 300 watts

POWER RECOMMENDATION

JL Audio recommends high quality amplifiers such as the XD300/1v2. The diagram below shows the

recommended crossover settings for the XD300/1v2. If another amplifier is being used, please reference this

illustration and use similar settings on that amplifier.

All JL Audio amplifiers are very versatile audio components. Please consult the owner’s manual for even more

detailed information about installing and tuning your amplifier.

CONNECTIONS

Using quality power, signal and speaker wire is essential in ensuring the performance of your Stealthbox®.

JL Audio recommends using a 4 AWG power kit such as the XD-PCS4-1B for your Stealthbox® amplifier, other

kits are available should you be using more than one amplifier. Signal wire such as the JL Audio Premium

Audio Interconnect Cables should be used that will provide signal for both channels of the amplifier. JL Audio

recommends using 12AWG speaker wire for subwoofers such as our XC-BCS12-25.

MID/HIGH FREQUENCY DRIVER FITMENT

A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.

Front Speaker Size / Location: 6-1/2”- Front Doors

Fits JL Audio Models: C1-650, C1-650x, C2-650, C2-650x, C3-650,

C5-650, C5-650x, & C7-650cw

Rear Speaker Size / Location: 6-1/2”- Rear Door

Fits JL Audio Models: C1-650, C1-650x, C2-650, C2-650x, C3-650,

C5-650, C5-650x, & C7-650cw

All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered

trademarks of JL Audio, Inc.“Ahead of the Curve”and its respective logo is a trademark of JL Audio, Inc.

For more detailed information please visit us online at www.jlaudio.com.

(954) 443-1100

www.jlaudio.com

10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA

Dieses Handbuch passt für folgende Modelle

Andere JL Audio Subwoofer Handbücher

JL Audio

JL Audio 10WIZJv3·4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-SC-XB/12W3v3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-J-JK2DR/10W1v3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-POL-RXPC/10TW3 Bedienungsanleitung

JL Audio

JL Audio 10IB4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-N-TTCRW/10W3v2 Bedienungsanleitung

JL Audio

JL Audio 10W6v2-D4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-N-370/10W3v3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-BURBCNSL/10W3v2 Bedienungsanleitung

JL Audio

JL Audio 12W3v3-2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-SC-XBG1/10W1v2 Bedienungsanleitung

JL Audio

JL Audio ACP1 08LG-W3v3 Bedienungsanleitung

JL Audio

JL Audio 12WX Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-KW-TRX4/10TW3 Bedienungsanleitung

JL Audio

JL Audio 12TW3 Bedienungsanleitung

JL Audio

JL Audio 15W3v2-D4 Bedienungsanleitung

JL Audio

JL Audio 94657 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-SLVCNSL/10W3-D6 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-D-5GRAMCCF/12TW3 Bedienungsanleitung

JL Audio

JL Audio 12W3v3-2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-MIN-COOP/8W7 Bedienungsanleitung

JL Audio

JL Audio 10W3 Bedienungsanleitung

JL Audio

JL Audio 8W1v2-4 Bedienungsanleitung

JL Audio

JL Audio 12W6v3-D4 Bedienungsanleitung

Beliebte Subwoofer Handbücher anderer Marken

Sony

Sony XS-AW8 Bedienungsanleitung

Sony

Sony XS-L836 Bedienungsanleitung

B&C Speakers

B&C Speakers 15 HPL 76W Bedienungsanleitung

Velodyne

Velodyne DD-18+ Bedienungsanleitung

Sonance

Sonance Cinema Series SUB 10-150 Bedienungsanleitung

Hifonics

Hifonics HW-12 Kurzanleitung

Magnat Audio

Magnat Audio ADR 130 BP Bedienungsanleitung

Blitz

Blitz BZP106 Bedienungsanleitung

Technics

Technics SB-AS500 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-2 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-3 Bedienungsanleitung

Pyle Pro

Pyle Pro PYLE PRO PDW15125 Bedienungsanleitung

REL Acoustics

REL Acoustics Q Series Bedienungsanleitung

L-Acoustics

L-Acoustics KIVA SB15M Kurzanleitung

Pioneer

Pioneer Elite S-W1EX Bedienungsanleitung

B&C Speakers

B&C Speakers Woofer 12 HPL 76 Bedienungsanleitung

KEF

KEF KUBE 200 Bedienungsanleitung

Yamaha

Yamaha SW500 Bedienungsanleitung