JL Audio Stealthbox SB-H-CIVCPE/12W3v2 Bedienungsanleitung

➔

Stealthbox®

INSTALLATION GUIDE

SB-H-CIVCPE2/12W3v2, JL AUDIO, Inc 2004 Sheet SKU#011158 Revision 9/17/2004Page 1

for the

SB-H-CIVCPE/12W3v2

(Fits 2001-2003 Honda Civic Coupe,

2-door)

This Stealthbox is a product which

requires professional installation skills and

tools.

Please read this installation guide thor-

oughly before beginning the project. It

will guide you step by step through the

installation. Several of the steps in this

process may require two people to

accomplish.

It is absolutely vital that the enclosure

be properly mounted to the vehicle

according to these instructions. Failure

to mount the enclosure properly pres-

ents two problems: 1) The sub-bass

performance will suffer due to the

movement of the enclosure caused by

the force exerted by the woofer(s) and

2) A loose enclosure presents a serious

safety hazard in the event of a collision

or sudden deceleration.

Please enjoy your JL Audio Stealthbox

responsibly.

STEP 1:

Remove the factory cargo net, net

hooks and the flooring.

STEP 2:

Cut the passenger’s side wood floor-

boards ear. Do this outside of the vehicle.

Using a straight edge and marking a line will

help in cutting a straight line.

STEP 3:

Only remove this cargo net hook.

This is on the passenger side of the trunk.

*In the next two steps ,you need to plot

two marked locations from measure-

ments. This is to find the proper loca-

tion of the placement of the supplied

wax square.*

STEP 4:

Measuring 5.0” (127mm) from the

floor, up to the mark from STEP 4.Mark

location.

STEP 5:

Measuring 8” (203.22mm) from the

rear of the back rear to the trunk opening,

mark location.

STEP 6:

This placement of the wax square is

not going to allow for good adhesion. Using a

heavy duty style tape will help the wax square

to stay into place.

*You do not want the wax square to

move, when placing the Stealthbox

into place, in STEP 9.*

START

HERE

Continued on Next Page ➔

www.jlaudio.com

➔

➔➔➔

➔

➔➔

➔➔➔

STEP 7:

Place the second supplied wax

square, between the second and the third

indentation starting from the front of the vehi-

cle(shown with arrows in above

picture).

The edge of this second supplied wax square

should be flush with the edge of the factory

trunk linear.

STEP 11: *CAUTION*

Before drilling, make sure that you are not going to

be drilling into any gas lines, brake lines, transmission

lines, electrical wiring or anything else that might

cause a reduction in your weekly pay. Always wear

eye protection when drilling.

With the use of a 1/2” drill bit and drill. Drill out the

floor at the impressions on the wax squares.

Cont.

From

Page

Continued on Next Page ➔

➔

STEP 8: Place the pair of supplied socket cup set

screws into the Stealthbox. Leaving about 1/4”

exposed.

The insert can be located by flipping the Stealthbox

upside down.

STEP 12: Replace the flooring, that was removed

in STEP 1. Using a utility knife, cut a slit that is lined

up with this location’s mounting hole.This is to allow

the socket cup set screw to pass through the car-

peting to the mounting hole.

STEP 13: Replace the factory cargo net and

hooks, that were removed in STEP 1.

Run speaker wire to the Stealthbox location and

attach to the terminal, on the back of the

Stealthbox.

*Double check the woofer for proper opera-

tion.*

STEP 9: Place the Stealthbox into place and

press firmly. When pulled away, the wax squares

should have the socket sup set screw markings. If

not you need to back out the set screws, for proper

marking.

The upper wax square didn’t move? You did tape it,

right?

STEP 10: Pull the Stealthbox out of location.

*CAUTION*

Before drilling, make sure that you are not going to

be drilling into any gas lines, brake lines, transmission

lines, electrical wiring or anything else that might

cause a reduction in your weekly pay. Always wear

eye protection when drilling.

With the use of a 1/2” drill bit and drill. Drill out the

floor at the impressions on the wax squares.

SB-H-CIVCPE2/12W3v2, JL AUDIO, Inc 2004 Sheet SKU#011158 Revision 9/17/2004Page 2

www.jlaudio.com

➔

Specifications:

Enclosure Type: Sealed

Driver Type: 12W3v2-D2

Nominal Impedance: 4Ω

Cont. Power Handling: 300 Watts

JL Audio recommends using a high quality amplifier such as the JL Audio 250/1. The diagram below shows the recommended

crossover, infrasonic filter and equalizer settings for the 250/1 when being used to power your Stealthbox®.

Included Hardware:

(2) 3/8-16 x 2-1/4” Socket Cup Set Screws

(2) 3/8” x 1-1/4” Fender Washer

(2) 3/8” Flat Washer

(2) 3/8” Split Lock Washer

(2) 3” x 3”Wax Squares

10369 N. Commerce Pkwy, Miramar, Florida 33025-392 Phone: 954.443.1100 Fax: 954.443.1111

JL AUDIO 250/1

monoblock subwoofer amplifier

Amplifier Input Section

Input Sens.

Input Voltage

Low/High

Left Ch. Right Ch.

Signal Sensing

Off/On

Output Mode

Full-Range/Low-Pass/High-Pass

Left Ch. Right Ch.

Amp LP Filter

Mode/Slope

Off/12dB/24dB

Filter Freq. (Hz)

Bass Control

LF Boost (dB)

Off/30Hz

Infrasonic Filter

+1 +13

+10

Preamp Output Section

+12VDC Ground Remote

The JL Audio 250/1 is a very versatile audio component. Please consult the owner’s manual for detailed information

about installing and tuning this amplifier.

➔

STEALTHBOX WALL THREADED INSERT

VEHICLE SHEET METAL

FENDER WASHER SOCKET CUP SET SCREW

LOCK WASHER

FLAT WASHER

HEX NUT

STEP 14: Back out the pair of socket cap set

screws that were threaded in, from STEP 8. Expose

1-1/2” of the threads, outside the Stealthbox.

Place the Stealthbox into location, carefully guiding

the pair of socket cup set screws through the drilled

holes.

Using the supplied hardware, place in order as

shown n above illustration.

➔

SB-H-CIVCPE2/12W3v2, JL AUDIO, Inc 2004 Sheet SKU#011158 Revision 9/17/2004Page 3

www.jlaudio.com

Mid/High Frequency Driver Information:

CONGRATULATIONS!

INSTALL COMPLETE.

VR600-CSi

TR690-CXi

Front Location Driver Size:

6.0”

Applicable JL Audio Products:

TR,VR 600-CSi

Rear Location Driver Size:

6.0” or 6”x9”

Applicable JL Audio Products:

TR,VR 600-CSi

TR690-TXi,VR690-CXi

Cont.

From

Page

Difficulty Of Installation:

Dieses Handbuch passt für folgende Modelle

Andere JL Audio Subwoofer Handbücher

JL Audio

JL Audio 12W3v2 Series Bedienungsanleitung

JL Audio

JL Audio Stealthbox 5 Series Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-T-TUNDCMAX/13TW5v2 Bedienungsanleitung

JL Audio

JL Audio MX10IB3 Bedienungsanleitung

JL Audio

JL Audio gotham v2 Bedienungsanleitung

JL Audio

JL Audio 10W0 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-M-3-SPD/10W3v3 Bedienungsanleitung

JL Audio

JL Audio 94643 Bedienungsanleitung

JL Audio

JL Audio 12WOv3-4 Bedienungsanleitung

JL Audio

JL Audio 12TW3-D4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-SMRT-4-2/8W3v3 Bedienungsanleitung

JL Audio

JL Audio JL AUDIO 8W1v2-4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-T-TACDCG3/10TW3 Bedienungsanleitung

JL Audio

JL Audio 8W1v3-4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-H-RIDGLNE/10W3v3 Bedienungsanleitung

JL Audio

JL Audio 10W6AE Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-BURB/10W3 Bedienungsanleitung

JL Audio

JL Audio 300/2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-CFMINI/10W3v2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-TAHOCNSL/10W1v3 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-T-4RNR/10W Bedienungsanleitung

JL Audio

JL Audio 12W1v2-4 Bedienungsanleitung

JL Audio

JL Audio 6W3v3-4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-H-PIO1K/10TW3 Bedienungsanleitung

Beliebte Subwoofer Handbücher anderer Marken

Sony

Sony XS-AW8 Bedienungsanleitung

Sony

Sony XS-L836 Bedienungsanleitung

B&C Speakers

B&C Speakers 15 HPL 76W Bedienungsanleitung

Velodyne

Velodyne DD-18+ Bedienungsanleitung

Sonance

Sonance Cinema Series SUB 10-150 Bedienungsanleitung

Hifonics

Hifonics HW-12 Kurzanleitung

Magnat Audio

Magnat Audio ADR 130 BP Bedienungsanleitung

Blitz

Blitz BZP106 Bedienungsanleitung

Technics

Technics SB-AS500 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-2 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-3 Bedienungsanleitung

Pyle Pro

Pyle Pro PYLE PRO PDW15125 Bedienungsanleitung

REL Acoustics

REL Acoustics Q Series Bedienungsanleitung

L-Acoustics

L-Acoustics KIVA SB15M Kurzanleitung

Pioneer

Pioneer Elite S-W1EX Bedienungsanleitung

B&C Speakers

B&C Speakers Woofer 12 HPL 76 Bedienungsanleitung

KEF

KEF KUBE 200 Bedienungsanleitung

Yamaha

Yamaha SW500 Bedienungsanleitung