JL Audio Stealthbox SB-J-UNLTD4DR/13TW5v2 Bedienungsanleitung

INSTALLATION GUIDE

for the

SB-J-UNLTD4DR/13TW5v2

SKU# 94418 - 94419

2007 - 2012 Jeep Wrangler Unlimited

Thank you for choosing a JL Audio Stealthbox®for your automotive sound system. With proper installation, your new vehicle-

specific enclosed subwoofer system will deliver years of listening pleasure.

We strongly recommend that you have your new Stealthbox®installed by your authorized JL Audio dealer. The installation

professionals employed by your dealer have the necessary tools and experience to disassemble and reassemble your vehicle

properly. If you prefer to perform your own installation, please read this installation guide completely

before beginning the process.

If you choose to perform the installation yourself, it is absolutely vital that

the Stealthbox®be properly mounted to the vehicle according to these

instructions. Failure to mount the enclosure properly presents two problems:

1) The sub-bass performance will suffer due to the movement of the enclosure

caused by the force exerted by the woofer(s).

2) A loose enclosure presents a serious safety hazard in the event of a collision

or sudden deceleration.

STEP 1

Empty the passengers side rear of the Jeep, remove the 4

screws that secure the tail-light. Unplug the light assembly

and set it aside as you’ll need access into the area behind

where it was mounted.

Continued on Next Page

STEP 2

Place the two wax squares on the inner fender as shown in

the picture (left) measuring from the outside edge of the

tailgate opening forward and, up from the floor.

STEP 3

Thread the 3/8”- 16 studs into the enclosures so that only

3/8” projects from the bosses. Now is also a good time to

verify the performance of the woofer before it’s mounted.

SB-J-UNLTD4DR/13TW5v2 INSTR_SKU# 011276

INSTALLATION

DIFFICULTY:

OUT

ESTIMATED TIME:

23 HOURS

24 3/4”

6 1/2” 6 1/4”

1 1/4”

STEP 9

Once the hardware is started on BOTH the front, and rear

Allen Head Studs, you can tighten the hardware down.

Continued on Next Page

SB-J-UNLTD4DR/13TW5v2 INSTR_SKU# 011276

STEP 6

At each mark in the wax squares, drill a 3/8” hole through the

carpeting and inner fender. Back out the Allen Head Studs in

the Stealthbox® so that Approximately 1” is exposed.

*CAUTION*

Before drilling, always make sure that you are not

going to be drilling into any gas lines, brake lines,

transmission lines, electrical wiring, exhaust systems

or anything else that might cause a reduction in

your weekly pay. Always wear eye protection when

drilling.

DETAIL

Pulling on the center head of the inner fender body fasteners

will allow the fastener to be removed. Re-installation is the

reverse process, push the body of the fastener through the

holes then, push the center head in to expand the body.

STEP 5

Notice the Inner Fender Liner Fasteners, all 12 of these fasten-

ers need to be removed so that the Inner Fender Liner can

be dropped down on the rear tire. This needs to be done so

that you can gain access to the Hole where the Allen Head

Stud will come through the Inner Fender.

STEP 4

Slide enclosure into place and press against the inner fender,

producing indentations in the wax squares where the studs

hit. Remove the enclosure.

Page 2 • JL Audio, Inc 2016

STEP 7

Start the included hardware on the 3/8-16 Allen Head Stud.

There should be a 3/8 x 1-1/2” Fender Washer, Split lock

Washer and Hex Nut on the Allen Head Stud. (see

illustration at STEP 9 for details).

STEP 10

CONGRATULATIONS!

You have completed the installation for this model!

Enjoy your new Stealthbox®!

Please refer to the Power Recommendation section for an

amplifier recommendation and basic set-up help.

STEP 8

Reaching down and around through the hole where the

taillight mounts, you will find the rear Allen Head Stud.

Install included hardware as illustrated above. Re-install

the previously removed Taillight, test the operation of the

taillights.

SB-J-UNLTD4DR/13TW5v2 INSTR_SKU# 011276

Page 5• JL Audio, Inc 2016

All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered

trademarks of JL Audio, Inc.“Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.

For more detailed information please visit us online at www.jlaudio.com.

(954) 443-1100

www.jlaudio.com

10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA

INCLUDED HARDWARE

2) 3”X 3” Wax Square 2) 3/8-16 x 2-1/4” Allen Head Stud

2) 3/8” x 1-1/4” Fender Washer 2) 3/8” Flat Washer

2) 3/8” Split Lock Washer 2) 3/8-16 Hex Nut

SPECIFICATIONS

Enclosure Type: Acoustic Suspension (sealed)

Driver Type: 13T W5v2-2

Nominal Impedance: 2 Ohms

Continuous Power Handling: 600 Watts RMS

POWER RECOMMENDATION

JL Audio recommends using a high quality amplifier such as the JL Audio XD600/1v2. The diagram below shows

the recommended crossover, infrasonic filter and equalizer settings for the XD600/1v2 when being used to power

your Stealthbox®.

The JL Audio XD600/1v2 is a very versatile audio component. Please consult the owner’s manual for even more

detailed information about installing and tuning this amplifier.

MID/HIGH FREQUENCY DRIVER FITMENT

A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.

Front Speaker Size / Location: 6 3/4-inch/ Dash

Fits JL Audio Models: TR650-CSi, TR650-CXi, C2-650, C2-650x, C3-650,

C5-650, C5-650x & ZR650-CSi

Rear Speaker Size / Location: 6 3/4-inch / Roll Bar (Custom Mounting Plate Required)

Fits JL Audio Models: TR650-CSi, TR650-CXi, C2-650, C2-650x, C3-650,

C5-650, C5-650x & ZR650-CSi

Dieses Handbuch passt für folgende Modelle

Andere JL Audio Subwoofer Handbücher

JL Audio

JL Audio 12W1-4 Bedienungsanleitung

JL Audio

JL Audio M12IB6 Bedienungsanleitung

JL Audio

JL Audio 12WX Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-TRKEXT/10W1v2/BK Bedienungsanleitung

JL Audio

JL Audio SB-VW-JETSW/10W3v3 Bedienungsanleitung

JL Audio

JL Audio 15W3v2-D2 Bedienungsanleitung

JL Audio

JL Audio M10IB5 Bedienungsanleitung

JL Audio

JL Audio 12WXv2-4 Bedienungsanleitung

JL Audio

JL Audio 10W6V2-D4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-SLVEXT/10W6v2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-T-4RNR/10W Bedienungsanleitung

JL Audio

JL Audio M121B6 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-GM-SLVCTR2/10W3v3 Bedienungsanleitung

JL Audio

JL Audio 10TW1-4 Bedienungsanleitung

JL Audio

JL Audio e110 Bedienungsanleitung

JL Audio

JL Audio 12W1v2-4 Bedienungsanleitung

JL Audio

JL Audio 10TW1-2 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-N-FRNTCC/10W1v2 Bedienungsanleitung

JL Audio

JL Audio 13W1v2-4 Bedienungsanleitung

JL Audio

JL Audio SB-N-ALT/10W3v3 Bedienungsanleitung

JL Audio

JL Audio 10WXv2 Bedienungsanleitung

JL Audio

JL Audio JL AUDIO 8W1v2-4 Bedienungsanleitung

JL Audio

JL Audio Stealthbox SB-T-TUNDC/8W7 Bedienungsanleitung

JL Audio

JL Audio Fathom f113v2 Bedienungsanleitung

Beliebte Subwoofer Handbücher anderer Marken

Sony

Sony XS-AW8 Bedienungsanleitung

Sony

Sony XS-L836 Bedienungsanleitung

B&C Speakers

B&C Speakers 15 HPL 76W Bedienungsanleitung

Velodyne

Velodyne DD-18+ Bedienungsanleitung

Sonance

Sonance Cinema Series SUB 10-150 Bedienungsanleitung

Hifonics

Hifonics HW-12 Kurzanleitung

Magnat Audio

Magnat Audio ADR 130 BP Bedienungsanleitung

Blitz

Blitz BZP106 Bedienungsanleitung

Technics

Technics SB-AS500 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-2 Bedienungsanleitung

Lyngdorf

Lyngdorf BW-3 Bedienungsanleitung

Pyle Pro

Pyle Pro PYLE PRO PDW15125 Bedienungsanleitung

REL Acoustics

REL Acoustics Q Series Bedienungsanleitung

L-Acoustics

L-Acoustics KIVA SB15M Kurzanleitung

Pioneer

Pioneer Elite S-W1EX Bedienungsanleitung

B&C Speakers

B&C Speakers Woofer 12 HPL 76 Bedienungsanleitung

KEF

KEF KUBE 200 Bedienungsanleitung

Yamaha

Yamaha SW500 Bedienungsanleitung