3
Safety Warnings & Advice continued
Periodically check the power cord and plug for any damage. If it is
damaged, do not use.
If the power cord and plug is damaged, it must be exclusively replaced by
the manufacturer or a similarly qualified electrician in order to avoid a hazard.
Keep the power cord away from hot surfaces and sharp edges.
Do not open the Motor Unit or attempt to change or repair it.
Unauthorised repairs will invalidate the warranty and could result in injury.
The Motor Unit may become hot during use. NEVER touch any metal
parts as they may cause burns to the skin.
Ensure that the area around the DriBuddi is kept clear.
Ensure that the holes on top of the Cover are not covered during operation.
Keep DriBuddi away from water or other liquids. Do not plug in if it is
resting on a wet surface.
DriBuddi should only be used in a well-ventilated area. If ventilation is
lacking, it can also be used near an open window. Do not push directly
up against a wall; leave at least a gap of an inch so air can circulate
around it.
Please regularly inspect your DriBuddi to make sure clothes have not
fallen off their hangers.
Always use the DriBuddi in a clean environment to avoid any ingress of
dust or debris into the DriBuddi unit.
Customers should always attach the plastic grey cover over the motor.
Clothes should never be dripping when placed inside the unit.
Long clothes that may obstruct the warm air vent need to be placed
correctly so there is no obstruction that may cause overheating of the motor.
The feet should always be attached.
The vent on the underside should be checked for any sign of dust/fluff
and this should be removed where possible.
The unit should not be used for any other means – i.e. as a warm
heater (without the canvas bag).
