JVC KD-R223 Leitfaden
1
KD-R223
Installation/Connection Manual
0211DTSMDTJEIN
EN
© 2011 Victor Company of Japan, Limited
GET0736-005A
[B]
Bracket *
Pocket
Flat head screws (M5 × 8 mm)*
INSTALLATION
When installing the unit without using the sleeve
In-dash mounting
WARNINGS
Removing the unit
Release the rear section first...
Do the required electrical connections.
Bend the appropriate tabs to hold the sleeve
firmly in place.
Install the unit at an angle of
less than 30˚.
* Not supplied for this unit.
Part list
A
Control panel (×1)
B
Sleeve (×1)
C
Trim plate (×1)
D
Power cord (×1)
E
Handles (×2)
• You need the installation kits which corresponds to your car.
• If you have any questions or require information regarding installation kits, consult your JVC IN-CAR ENTERTAINMENT dealer or a company supplying kits.
• The unit can only be installed in a car with a 12 V DC power supply, negative ground.
• Disconnect the battery’s negative terminal and make all electrical connections before installing the unit.
• Connect speakers with a maximum power of more than 50 W (impedance of 4 Ω to 8 Ω). Otherwise, change the <AMP GAIN> setting. (See page 11 of the INSTRUCTIONS.)
• Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals.
• If the fuse blows, first make sure the wires are not touching to cause a short circuit, then replace the old fuse with one that has the same rating.
• Install this unit in the console of your vehicle.
• Mount the unit so that the mounting angle is 30° or less.
• Be sure to ground this unit to the car's chassis again after installation.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly.
• Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the heat sink and enclosure become hot.
PRECAUTIONS on power supply and speaker connections
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car.
Install_KD-R223_005A_1.indd 1Install_KD-R223_005A_1.indd 1 1/31/11 3:16:14 PM1/31/11 3:16:14 PM
2
*1Not supplied for this unit.
*2Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint.
ELECTRICAL CONNECTIONS
• The fuse blows.
]
Are the red and black leads connected correctly?
• Power cannot be turned on.
]
Is the yellow lead connected?
• No sound from the speakers.
]
Is the speaker output lead short-circuited?
• “MISWIRING CHK WIRING THEN RESET UNIT” / “WARNING CHK WIRING THEN RESET UNIT”
appears on the display and no operation can be done.
]
Is the speaker output lead short-circuited or touches the
chassis of the car/head unit? ; Have you reset your unit?
• Sound is distorted.
]
Is the speaker output lead grounded? ; Are the “–” terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
]
Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
• This unit becomes hot.
]
Is the speaker output lead grounded? ; Are the “–” terminals of L and R speakers grounded in common?
• This unit does not work at all.
]
Have you reset your unit?
TROUBLESHOOTING
Reset the unit.
Rear ground terminal
10 A fuse
Aerial input
For some VW/Audi or Opel (Vauxhall) automobiles
You may need to modify the wiring of the supplied power cord as illustrated.
• Contact your authorized car dealer before installing this unit.
Original wiring
Modified wiring 1
Use modified wiring 2if the unit does not turn on.
ISO connector
Y: Yellow
R: Rede
Modified wiring 2
IMPORTANT: A custom wiring harness (separately purchased) which is suitable for your car is recommended for connection between the unit and your car.
Consult your JVC IN-CAR ENTERTAINMENT dealer or a company supplying kits for details about connection.
(A) If your car has an ISO terminal (B) If your car does NOT have an ISO terminal
Custom wiring harness (separately purchased) Custom wiring harness (separately purchased)
B1/B2 Rear speaker, right (Purple/Purple, black stripe) (+/–)
B3/B4 Front speaker, right (Gray/Gray, black stripe) (+/–)
B5/B6 Front speaker, left (White/White, black stripe) (+/–)
B7/B8 Rear speaker, left (Green/Green, black stripe) (+/–)
A4 Car battery 12 V (Yellow)
A5 Remote lead/power aerial, 200 mA max. (Blue, white stripe)
A6 To car light control switch (Orange, white stripe)
A7 Accessory terminal (Red)
A8 Metallic body/chassis of the car (Black)
DPower cord (supplied)
DPower cord (supplied) DPower cord (supplied)
ISO connector
Install_KD-R223_005A_1.indd 2Install_KD-R223_005A_1.indd 2 1/31/11 3:16:14 PM1/31/11 3:16:14 PM
Andere Handbücher für KD-R223
1
Inhaltsverzeichnis
Andere JVC Autoempfänger Handbücher
JVC
JVC KD-APD49 - CD/AM/FM/MP3/WMA Receiver Leitfaden
JVC
JVC KW-ADV792 - Arsenal 2-DIN 7" TouchScreen DVD/MP3/CD... Bedienungsanleitung
JVC
JVC KD-AR480 Bedienungsanleitung
JVC
JVC KW-XR611 Bedienungsanleitung
JVC
JVC KD-G207 Leitfaden
JVC
JVC KD-AVX40 - DVD Player With LCD monitor Leitfaden
JVC
JVC CD Receiver KD-G632 Leitfaden
JVC
JVC KD-G502 Bedienungsanleitung
JVC
JVC GET0187-001A Bedienungsanleitung
JVC
JVC KD-AR760 - Arsenal CD Receiver Bedienungsanleitung
JVC
JVC KD-DB922BT Bedienungsanleitung
JVC
JVC KW-XC777 - Radio / CD Bedienungsanleitung
JVC
JVC KW-AVX716 Bedienungsanleitung
JVC
JVC GET0425-001A Bedienungsanleitung
JVC
JVC KD-DV5506 Leitfaden
JVC
JVC KW-XC888 Bedienungsanleitung
JVC
JVC KD-G432 Bedienungsanleitung
JVC
JVC KD-G489UR Bedienungsanleitung
JVC
JVC KD-R200 Leitfaden
JVC
JVC G300 - KD Radio / CD Bedienungsanleitung
Beliebte Autoempfänger Handbücher anderer Marken
Sound Storm
Sound Storm STM93R Bedienungsanleitung
Soundstream
Soundstream VIR-5000 Bedienungsanleitung
Avson
Avson MKT Platform Bedienungsanleitung
Sony
Sony MEX-1HD - Audio Library System Bedienungsanleitung
Pioneer
Pioneer DVH-P500UB Bedienungsanleitung
Blaupunkt
Blaupunkt SANTIAGO CR 87 Bedienungsanleitung
