JVC LT-24HD7WU Bedienungsanleitung

LT-24HD7WU

EnglishFrenchDutchSpanish

Operating Instructions

Mode d'emploi

Handleiding

Instrucciones de Funcionamiento

VOL

ANGLE

REC

A-B

Downloaded from www.vandenborre.be

You get the smartcard from your cable supplier (CAMs are customary). Insert the

smartcard into the CAM, and then insert the CAM into the CI slot of your TV set.

modules

DVD Player

Downloaded from www.vandenborre.be

it is damaged.

broken glass. You could be hurt or the unit could become damaged.

to allow for air circulation.

100-240V~50/60Hz

Downloaded from www.vandenborre.be

Carefully hold the base plate in position and secure it with screws.

To detach the stand, perform these steps in reverse order.

For wall mounting , the stand must be dismantled. To do this, remove screws ( above drawing ) from the

back . Fit a VESA (100 x 100) wall mounting kit. The screw thread length must not exceed 5mm.

Remove the stand as one piece by reversing the fixing procedure described above.

You can refit the screws to the stand for safe keeping, but tighten them only slightly.

VESA screw size 4xM4x5mm

Protect the screen and lay the TV flat on its face, on a stable table, with the stand foot clear of the

table edge.

To ensure a safe installation, please observe the following when hanging the television on a wall:

Warning: This operation requires two people.

Check that the wall can support the weight of the television set and a VESA-standard wall mount

assembly (not supplied).

Be sure to use only screws suitable for the material of the wall.

In case of any doubt please contact a qualified installer.

Beware of electrical cables, gas and water pipes in the wall.

Follow the instructions provided with the wall mount.

The set must be installed on a vertical wall.

Make sure that cables are placed so that there is no danger of tripping over them or damaging

them.

fit in

1. Place the TV with the display side down

on a flat surface. Use a cloth to protect the

display.Position the stand base pillar onto

the bottom of the TV.

2. Attach the stand base plate and washer to

the stand pole by firmly tightening the supplied

screws.

1xM4x20mm

Dismantling the stand

3xM4x10mm

Downloaded from www.vandenborre.be

Safety Information

Dangerous voltage constituting a risk

of electric shock is present inside this

equipment.

This equipment is double insulated

and an earth connection is not

required.

This mark is applied to show the

equipment conforms to European

safety and electro-magnetic

compatibility standards.

Safe use and care of your television

We have designed and made this television to meet

European Safety Standards, but as with any

electronic equipment you must take care, to stay

safe and get the best results. Here is some good

advice to help you do this.

Read these instructions carefully before you try to

use the television.

Protect the mains lead. You must ensure the mains

lead cannot be walked on, crushed, chafed, cut or

trapped.

Switch off the mains power or pull out the mains plug

when you leave the television unattended, unless

the function of the television requires a continuous

power supply.

Do not continue to use your television if you have

spilt liquids in it, if it is damaged in any way or if it

does not work normally. Immediately unplug the

television and get expert advice.

Avoid harsh conditions such as wet or damp places,

high humidity, strong vibration, extremely high or

low temperatures, strong sunlight and places that

are very dusty.

Never fit makeshift stands or legs to the television.

Never push objects into holes and ventilation slots.

To prevent electric shock do not remove any cover.

Do not touch the LED display as it gets warm when

in use, this is normal and is not a fault.

If anything goes wrong do not try to fix it yourself,

get a qualified service agent to look at it.

Pull out the mains plug and disconnect the aerial

lead during thunder storms.

Cleaning

Disconnect the mains supply and use only a lightly

dampened soft cloth. Do not use chemical solvents

or strong detergents as these may damage the

cabinet or screen.

Mains Supply

This television is designed to operate from a 100-

240 Volts 50/60Hz AC mains supply. Other power

sources

may damage it. Check that the rating plate (on the

back cover of the television) states 100-240V AC

before you plug it in for the first time.

The manufacturer accepts NO liability for damage

or injury caused by using the product with the

wrong mains voltage.

Never allow water droplets to remain on the

screen as moisture can cause permanent

discolouration.

Greasy marks must only be removed with a

commercial cleaner specifically recommended for

LED screens.

Downloaded from www.vandenborre.be

Features...............................................................................................2

Important Safety Information...................................................................3-7

Contents...............................................................................................8

Installation............................................................................................9-12

Remote Control.....................................................................................13-14

Operation.............................................................................................15-24

DVD Operation.....................................................................................25-29

Troubleshooting table............................................................................30-34

Specification.........................................................................................35

License Information...............................................................................36

Downloaded from www.vandenborre.be

1: Remote Control Sensor.

2: Power Indicator LED:

RED STANDBY.

3: Side buttons 30 30

KEYBOARD

Front panel

REAR AV Connections

All the terminals are (from left to right): YPbPr INPUT, VIDEO, AUDIO INPUT,COAXIAL OUTPUT, SCART.

Note: VIDEO and YPbPr share one audio channel.

REAR AV Connections(SIDE)

All the terminals are(from left to right):

USB, HDMI2(ARC), HDMI1, HEADPHONE, CI, PC AUDIO, VGA, RF.

Note: 1.When HDMI port gets DVI signal ,the audio signal is received from the PC Audio channel.

2.Insert the plug of the earphone into the headphone jack on the unit.

The speakers are then muted.

Installation

VOL CH

FREEZE

EPG

1. OPEN/CLOSE: Open or close DVD slot.

2. PLAY/PAUSE: Play or pause playback.

3. SOURCE: Displays the input source, press “CH+”or

“CH-”to select required source,then press "VOL-" or

"VOL+" to change source.

4. MENU: Display main MENU.

5. CH+/CH-: In TV mode, press "CH+" or "CH-" to

change the channel up and down. In MENU mode,

press "CH+" or "CH-" to select items.

6. VOL+/VOL-: Adjust sound level. In MENU mode,

press "VOL+ " or "VOL- " to adjust the item that you

selected.

7. STANDBY: Press this button to turn the unit ON

from STANDBY mode. Press it again to turn the set

back to STANDBY.

HDMI ARC (Audio Return Channel)

The ARC function allows you to send audio signal from your ARC-compliant TV to ARC-compliant

audio devices (e.g. home theatre) without the need to connect any audio cable (e.g. coaxial, optical

digital audio cable, or analog audio cable).

To enjoy the ARC function:

1. Make sure your ARC- compliant audio devices are connected by an HDMI 1.4 cable to the HDMI 2 (ARC)

port of your ARC- compliant TV. And open the ARC function of ARC-compliant audio devices.

2. Adjust TV setting : press MENU button, choose SETUP, then set HDMI CEC Control on.

3. Then, just use your TV remote control to adjust the volume output (VOL + / - and MUTE) of the

connected audio device.

COAXIAL OUTPUT

SOURCE

CH+

CH-

VOL+

VOL-

STANDBY

OPEN/CLOSE

PLAY/PAUSE

Note: If the ARC-compliant audio devices do not support sound that TV outputs, such as Dolby

Digital , or Dolby Digital Plus, then ARC function will not work and there may be no sound from

ARC-compliant audio devices. In this case, please set coaxial to PCM.

Downloaded from www.vandenborre.be

STEPS:

Be sure both the TV and computer are set to

Power off.

1.Connect VGA and audio cable.

2.Connect the power cord.

3.Power on the TV, switch to PC mode.

4.Power on the PC.

This sequence is very important.

Installation

Downloaded from www.vandenborre.be

Inhaltsverzeichnis

Sprachen:

Andere JVC Fernseher Handbücher

JVC

JVC AV-21LS2, AV-21WS3, AV-25LS3, Bedienungsanleitung

JVC

JVC LT-20DA6SK Bedienungsanleitung

JVC

JVC LT-49K880 Bedienungsanleitung

JVC

JVC AV 14F704 Bedienungsanleitung

JVC

JVC AV-14FT Administratorhandbuch

JVC

JVC AV-21KT1BEF Bedienungsanleitung

JVC

JVC HD-56FH97 - 56" Rear Projection TV Bedienungsanleitung

JVC

JVC AV-21KM3BN Bedienungsanleitung

JVC

JVC AV-27530/SC Bedienungsanleitung

JVC

JVC AV-14A16 Bedienungsanleitung

JVC

JVC AV-27F704/BSA Bedienungsanleitung

JVC

JVC AV-14A15 Bedienungsanleitung

JVC

JVC AV-21FT5 Bedienungsanleitung

JVC

JVC AV-21B17 Bedienungsanleitung

JVC

JVC AV-21P8 Bedienungsanleitung

JVC

JVC C-13310/S Bedienungsanleitung

JVC

JVC AV-20N8(BK) Bedienungsanleitung

JVC

JVC AV-21V511 Bedienungsanleitung

JVC

JVC AV-21F4EE Bedienungsanleitung

JVC

JVC AV-25P8PH Bedienungsanleitung

JVC

JVC I'Art Pro AV-32S565 Bedienungsanleitung

JVC

JVC AV-20RM4SE Bedienungsanleitung

JVC

JVC AV-16KG11 Bedienungsanleitung

JVC

JVC AV-28X5BU Bedienungsanleitung

Beliebte Fernseher Handbücher anderer Marken

Philips

Philips Colour Television Bedienungsanleitung

Toshiba

Toshiba 27A10 Bedienungsanleitung

Philips

Philips 42PF9630A/37 Bedienungsanleitung

Hitachi

Hitachi 32FX48B Bedienungsanleitung

DAEWOO ELECTRONICS

DAEWOO ELECTRONICS DTQ-14V1FC Bedienungsanleitung

Changhong Electric

Changhong Electric uhd55b6000is Bedienungsanleitung

Philips

Philips Matchline 21CE7551 Bedienungsanleitung

Panasonic

Panasonic Genus TX-G10 Bedienungsanleitung

Toshiba

Toshiba 19A20 Bedienungsanleitung

Philips

Philips 25PT4523-16 Bedienungsanleitung

Sony

Sony XBR-100Z9D Bedienungsanleitung

Philips

Philips PR0930X3 Bedienungsanleitung

Philips

Philips Brilliance 231P4QPY Bedienungsanleitung

Samsung

Samsung 55S9 B Series Bedienungsanleitung

Philips

Philips 32HF9385D Fehlerbehebungshandbuch

Sharp

Sharp LC-40FI5012E Bedienungsanleitung

Loewe

Loewe Table Stand Reference 55 Bedienungsanleitung

Philips

Philips 32PFH5300 Bedienungsanleitung