Kodak ESP 5200 - NETWORKING Bedienungsanleitung

Networking Setup Guide

All-in-One Printers • All-in-One Printers

1www.kodak.com/go/aiosupport

Choosing a Connection Type

Make sure you completed the steps in the Start Here instructions. Then choose one of the following

connection types for your printer, and see the corresponding chapter for instructions.

NOTE:

• You can change your connection type later. See the chapter Configuring Your Printer in the

Extended User Guide.

• For additional networking information or troubleshooting, go to

www.kodak.com/go/inkjetnetworking.

Wireless (Wi-Fi) connection

Ethernet connection

To connect your printer to a wireless network, see Setting Up the Wireless (Wi-Fi)

Connection, page 2.

To connect your printer to a wired network using an Ethernet cable, see Setting Up the

Ethernet Connection, page 4.

MSSD/HCMMC

Rotate

BackHome

www.kodak.com/go/aiosupport 2

Setting Up the Wireless (Wi-Fi) Connection

Before you connect, you need to:

• Have a functional 802.11 wireless network. Kodak recommends that you use a wireless access point, most

commonly a router, that uses Dynamic Host Configuration Protocol (DHCP).

• Determine whether your wireless router supports Wi-Fi Protected Setup (WPS).

• Temporarily disable your firewall until the printer is successfully installed and communicating.

IMPORTANT: If you are unsure of how your network is configured, contact your Internet service provider or your

network administrator for assistance.

Using the LCD keyboard

There are two types of keyboards.

On the control panel (both types of keyboards), press , , or to select the letters and numbers,

using the correct uppercase and lowercase letters. Press OK after each character. When you are done, select

DONE, then press OK.

Connecting to a non-WPS wireless router

To connect your printer to your wireless network, you need to know the network name, which is also called the

Service Set Identifier (SSID). You can obtain your network name from the wireless router. See the

manufacturer’s documentation for more information.

If your network has security enabled, you also need to know the security string, which may be a Wired

Equivalent Privacy (WEP) key or a Wi-Fi Protected Access (WPA/WPA2) passphrase or password.

Record your network information in the spaces below, using the correct uppercase and lowercase letters.

Network Name (SSID): __________________________________________________________________________

Security String: _________________________________________________________________________________

1. Press Home.

2. Press to select Network Settings, then press OK.

3. With WiFi Setup Wizard selected, press OK.

The printer searches for available wireless networks within range, then displays the list in order of signal

strength. If there are more networks than can be shown on the LCD, a (page down) symbol appears in

the bottom right of the display. If you don’t see your network in the list, or if you want to change your

network, select Rescan for Wireless Networks, then press OK.

•To change from uppercase to

lowercase, select abc/123,

then press OK.

• To change from lowercase to

uppercase, select ABC/123,

then press OK.

•To enter punctuation or

symbols, select !@#, then press

OK.

Use the arrow

keys to select the

letters, numbers,

and symbols.

Setting Up the Wireless (Wi-Fi) Connection

3www.kodak.com/go/aiosupport

4. If the name of your network is:

5. If your network has security enabled, use the LCD keyboard to enter your security string.

6. When the confirmation message appears, press OK.

If the printer is successfully connected, the Wi-Fi status light should be on.

If you are unable to connect your printer, go to www.kodak.com/go/inkjetnetworking.

7. When the printer is successfully connected, install the KODAK All-in-One Printer Software on your

computer. Follow the on-screen instructions to complete your setup.

Connecting to a WPS wireless router

1. Press Home.

2. Press to select Network Settings, then press OK.

3. With WiFi Setup Wizard selected, press OK.

NOTE: The Wi-Fi radio turns on automatically when you select Wi-Fi Setup Wizard.

4. With WPS Connect selected, press OK.

5. Select one of these two methods of connecting:

IMPORTANT: Before you press OK on the printer, make sure you know where the router's button is, or where to

enter the generated PIN. If necessary, consult your Internet service provider or router

manufacturer’s documentation for more information.

6. When the confirmation message appears, press OK.

If the printer is successfully connected, the Wi-Fi status light should be on.

If you are unable to connect your printer, go to www.kodak.com/go/inkjetnetworking.

7. When the printer is successfully connected, install the KODAK All-in-One Printer Software on your

computer. Follow the on-screen instructions to complete your setup.

Listed Not Listed

Press to select your

network, then press

OK.

Make sure your wireless router is turned on and within range. If your wireless

router does not broadcast its SSID:

a. Press to select Unlisted network, then press OK.

b. Use the LCD keyboard to enter your network name.

c. Select WEP or WPA/WPA2 as required for your network's security

setup, then press OK.

Pressing a Button Entering a PIN

a. With Push Button Configuration selected, press OK.

b. Press or select the WPS button for your wireless router.

NOTE: You will have two minutes to press or select the

WPS button. It may be a button on the device or a

virtual button in the device’s software.

a. Press to select Generate WPS

PIN, then press OK.

b. In your wireless router’s software,

locate the PIN screen.

c. Enter the PIN you received from the

LCD into the PIN screen.

www.kodak.com/go/aiosupport 4

Setting Up the Ethernet Connection

Before you connect, you need to:

• Have a functional Ethernet network that includes a router, switch, or hub with an Ethernet port.

• Have a Category 5 (or higher) Ethernet cable.

• Temporarily disable your firewall until the printer is successfully installed and communicating.

Connecting to an Ethernet network

1. Connect the Ethernet cable into the Ethernet port on the back of the printer.

2. Connect the other end of the Ethernet cable into an available Ethernet port on your router, switch, or hub.

3. Install the KODAK All-in-One Printer Software on your computer. Follow the on-screen instructions to

complete your setup.

Eastman Kodak Company

Rochester, NY 14650

Kodak is a trademark of Eastman Kodak Company.

Specifications subject to change without notice.

P/N 1K5952

May 2010

Printed in China

1K5982

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Kodak Drucker Handbücher

Kodak

Kodak Magnus VLF Q2400 Bedienungsanleitung

Kodak

Kodak 8500 - USER'S GUIDE 240V Bedienungsanleitung

Kodak

Kodak 1200I Installationsanleitung

Kodak

Kodak RP 50 2J0686 Handbuch

Kodak

Kodak Photo Printer 6850 Bedienungsanleitung

Kodak

Kodak Verite JF120UB Series Bedienungsanleitung

Kodak

Kodak 1400 Installations- und Betriebshandbuch

Kodak

Kodak Professional ML-500 Bedienungsanleitung

Kodak

Kodak DryView 6800 Einrichtungshandbuch

Kodak

Kodak Smile Bedienungsanleitung

Kodak

Kodak 9810 - PRINTING IMAGES FROM PHOTOSHOP 7 AND... Bedienungsanleitung

Kodak

Kodak D4000 Bedienungsanleitung

Kodak

Kodak VERSAMARK DP5120 Bedienungsanleitung

Kodak

Kodak D4000 Installations- und Betriebshandbuch

Kodak

Kodak EASYSHARE EASYSHARE ONE Bedienungsanleitung

Kodak

Kodak 4000 series Bedienungsanleitung

Kodak

Kodak 9810 - PRINTING IMAGES FROM PHOTOSHOP 7 AND... Bedienungsanleitung

Kodak

Kodak 1400 Bedienungsanleitung

Kodak

Kodak ESP C310 Bedienungsanleitung

Kodak

Kodak Diconix 180si Bedienungsanleitung

Kodak

Kodak Professional ML-500 Handbuch

Kodak

Kodak 8650R THERMAL PRINTER Handbuch

Kodak

Kodak 7 Bedienungsanleitung

Kodak

Kodak VERSAMARK DP5120 Bedienungsanleitung

Beliebte Drucker Handbücher anderer Marken

Canon

Canon i70 Series Bedienungsanleitung

Evolis

Evolis Elypso Bedienungsanleitung

Kyocera

Kyocera FS-9530DN Bedienungsanleitung

Canon

Canon LASER SHOT LBP-1210 Bedienungsanleitung

Samsung

Samsung BIXOLON SRP-350plusF Bedienungsanleitung

Canon

Canon PIXMA PRO-1 Series Bedienungsanleitung

Canon

Canon PIXMA G3560 Einrichtungshandbuch

Dell

Dell Color Laser Printer 2130cn Bedienungsanleitung

Tektronix

Tektronix Phaser 840 Bedienungsanleitung

Brother

Brother 1440 - HL B/W Laser Printer Kurzanleitung

Fuji Xerox

Fuji Xerox DocuPrint P375 dw Bedienungsanleitung

WOOSIM

WOOSIM PORTI-S30 Bedienungsanleitung

Olivetti

Olivetti PG L2140 Bedienungsanleitung

Konica Minolta

Konica Minolta bizhub 224e Bedienungsanleitung

Canon

Canon LBP113w Bedienungsanleitung

Xerox

Xerox DocuColor 5000 Bedienungsanleitung

Canon

Canon PRO-500 Series Einrichtungshandbuch

Epson

Epson ET-7750 Betriebsanleitung