Kohler K-11660 Montageanleitung

Installation and Care Guide

Bath Drains

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page “Français-1”

Español, página “Español-1”

K-11660 K-11677

1114757-2-B

Tools and Materials

Before You Begin

Observe all local plumbing and building codes.

Turn off the water supplies.

Carefully inspect the ﬁttings for damage before installing.

For new bath installations: Install the drain to the bath and ﬁnish

the installation according to your bath’s installation guide.

For replacement installations: Remove the wall covering from the

drain end of the bath and remove the existing drain.

The overﬂow ell and drain ell tubes may need to be cut for

proper ﬁt. Dry ﬁt or measure and cut them to the proper length.

If cutting is needed, remove any burrs from the tubes.

Hacksaw or

Tubing Cutter Plumbers Putty or

Suitable Sealant Sealant

Tape

Plus:

• Trap

• Emery Paper

1114757-2-B 2 Kohler Co.

1. Assemble the Drain

Remove

Unthread the screw from the strainer.

Remove the strainer, strainer body, and gasket from the drain ell.

Unthread the screws on the hood.

Pull the hood out from the overﬂow ell to access the pin on the

plunger assembly.

Remove the pin on the plunger assembly from the overﬂow ell,

and remove the plunger assembly.

Set aside the pin, plunger assembly, hood, and screws.

Install

Install the coupling nuts and the gaskets onto the overﬂow ell

and the drain ell.

Fit the overﬂow ell and the drain ell into the tee.

If necessary, cut the drain ell to ﬁt a minimum of 3/4″(19 mm)

inside the tee. Remove any burrs using emery paper.

Gasket

Plunger Assembly

Coupling

Nut

Screw

Coupling Nut

Gasket

Tee

Tailpiece

Screw

Strainer

Body

Strainer

Drain Ell

Gasket

Overflow Ell Hood

Kohler Co. 3 1114757-2-B

Assemble the Drain (cont.)

Hand tighten the coupling nuts. Do not wrench tighten at this

time.

Apply thread sealant to the threaded end of the tailpiece. Thread

the tailpiece into the tee.

Insert the tailpiece approximately 1″(25 mm) to 2″(51 mm) into

the trap inlet (not shown). If necessary, cut the tailpiece to its

proper length and install the tailpiece into the trap inlet.

Tighten all drain connections.

1114757-2-B 4 Kohler Co.

2. Install the Overﬂow Ell

Position the gasket with the tapered side against the overﬂow ell

with the thin edge of the gasket at the top of the overﬂow ell.

Align the overﬂow ell with the overﬂow hole of the bath.

Fit the hold down plate over the lower mounting holes on the

overﬂow ell.

Wrap thread sealant tape around the threads of the two ﬂat-blade

screws. This will prevent water seeping through the lower

mounting holes on the overﬂow ell.

From inside the bath, insert the two ﬂat-blade screws through the

hold down plate and into the lower mounting holes on the

overﬂow ell.

Thread the screws into the overﬂow ell approximately three to

four turns. Do not tighten the screws completely. The overﬂow ell

must be loose in order to align the rest of the drain.

Lower Mounting

Holes

Gasket

Hold Down

Plate

Screws

Overflow Ell

Kohler Co. 5 1114757-2-B

3. Install the Drain Ell

CAUTION: Risk of property damage. Do not reposition the

drain ell after the strainer body is tightened. Moving the

drain ell may damage the seal created when the strainer is

tightened, increasing the risk of leaking.

Apply a ring of plumbers putty or other sealant around the

underside of the strainer body. Refer to the plumbers putty or

sealant manufacturer’s instructions.

Fit the gasket between the drain ell and below the bath drain

outlet.

Thread the strainer body into the drain ell.

Using pliers handles, tighten the strainer body securely into the

drain ell.

Place the strainer into the drain ell.

Thread the screw into the strainer.

Remove any excess sealant.

Bath

Strainer Body

Gasket

Screw

Strainer

Drain Ell

Apply plumbers putty.

1114757-2-B 6 Kohler Co.

4. Complete the Installation

Insert the plunger assembly into the overﬂow ell.

Properly secure the hold down plate to the overﬂow ell to

complete the hold down plate installation.

Attach the pin on the plunger assembly to the backside of the

hood.

Wrap thread sealant tape around the threads of the two Phillips

screws. This will prevent water seeping through the mounting

holes on the overﬂow ell.

Secure the hood to the overﬂow ell with the two Phillips screws.

Ensure the ″KOHLER″logo is above the lever. Do not

overtighten the screws.

Make all ﬁnal plumbing and drain connections.

Push the lever on the hood down to close the drain.

Fill the bath with water and check for leaks.

Check for proper operation of the lever. If necessary, refer to the

″Plunger Assembly Adjustment″section.

Overflow Ell

Plunger

Assembly

Hold Down Plate

Hood

Screw

Kohler Co. 7 1114757-2-B

Plunger Assembly Adjustment

NOTE: Adjust the plunger assembly until it is at the proper height.

Remove the hood from the overﬂow ell.

Remove the pin on the plunger assembly from the hood.

Remove the plunger assembly from the overﬂow ell.

Remove the pin from the link, then reinsert the pin at the proper

height.

Reinsert the plunger assembly into the overﬂow ell.

Reinstall the hood to the overﬂow ell.

Verify proper operation of the lever.

Care and Cleaning

For best results, keep the following in mind when caring for your

KOHLER product:

Linkage

Rod

Plunger

Assembly

Hood

Overflow Ell

Plunger AssemblyBath Drain

1114757-2-B 8 Kohler Co.

Care and Cleaning (cont.)

•Use a mild detergent such as liquid dishwashing soap and warm

water for cleaning. Do not use abrasive cleaners that may scratch

or dull the surface.

•Carefully read the cleaner product label to ensure the cleaner is

safe for use on the material.

•Always test your cleaning solution on an inconspicuous area

before applying to the entire surface.

•Do not allow cleaners to sit or soak on the surface.

•Wipe surfaces clean and rinse completely with water immediately

after cleaner application. Rinse and dry any overspray that lands

on nearby surfaces.

•Use a soft, dampened sponge or cloth. Never use an abrasive

material such as a brush or scouring pad to clean surfaces.

For detailed cleaning information and products to consider, visit

www.kohler.com/clean. To order Care & Cleaning information, call

1-800-456-4537.

Warranty

ONE-YEAR LIMITED WARRANTY

KOHLER plumbing products are warranted to be free of defects in

material and workmanship for one year from date of installation.

Kohler Co. will, at its election, repair, replace or make appropriate

adjustment where Kohler Co. inspection discloses any such defects

occurring in normal usage within one (1) year after installation. Kohler

Co. is not responsible for removal or installation costs. Use of in-tank

toilet cleaners will void the warranty.

To obtain warranty service contact Kohler Co. either through your

Dealer, Plumbing Contractor, Home Center or E-tailer, or by writing

Kohler Co., Attn.: Customer Care Center, 444 Highland Drive, Kohler,

WI 53044, USA, or by calling 1-800-4-KOHLER (1-800-456-4537) from

within the USA and Canada, and 001-800-456-4537 from within Mexico,

or visit www.kohler.com within the USA, www.ca.kohler.com from

within Canada, or www.mx.kohler.com in Mexico.

IMPLIED WARRANTIES INCLUDING THAT OF

MERCHANTABILITY AND FITNESS FOR A PARTICULAR

PURPOSE ARE EXPRESSLY LIMITED IN DURATION TO THE

DURATION OF THIS WARRANTY. KOHLER CO. AND/OR

SELLER DISCLAIM ANY LIABILITY FOR SPECIAL, INCIDENTAL

Kohler Co. 9 1114757-2-B

Warranty (cont.)

OR CONSEQUENTIAL DAMAGES. Some states/provinces do not

allow limitations on how long an implied warranty lasts, or the

exclusion or limitation of special, incidental or consequential damages,

so these limitations and exclusions may not apply to you. This

warranty gives you speciﬁc legal rights. You may also have other

rights which vary from state/province to state/province.

This is Kohler Co.’s exclusive written warranty.

1114757-2-B 10 Kohler Co.

Andere Handbücher für K-11660

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler Brenham K-1999-8-0 Bedienungsanleitung

Kohler

Kohler K-8666X Bedienungsanleitung

Kohler

Kohler K-T14419 Montageanleitung

Kohler

Kohler Sterling 7613 Series Bedienungsanleitung

Kohler

Kohler K-99255X-4CD Montageanleitung

Kohler

Kohler K-13490 Montageanleitung

Kohler

Kohler Purist T11837-CP Bedienungsanleitung

Kohler

Kohler K-10121 Bedienungsanleitung

Kohler

Kohler K-18494 Montageanleitung

Kohler

Kohler K-7129 Montageanleitung

Kohler

Kohler K-6331 Bedienungsanleitung

Kohler

Kohler K-433 Montageanleitung

Kohler

Kohler Fountainhead K-1786 Bedienungsanleitung

Kohler

Kohler C3-255 Bedienungsanleitung

Kohler

Kohler K-8998 Montageanleitung

Kohler

Kohler K-2369 Bedienungsanleitung

Kohler

Kohler Pillows K-7943 Bedienungsanleitung

Kohler

Kohler K-5826 Montageanleitung

Kohler

Kohler K-1491 Bedienungsanleitung

Kohler

Kohler STERLING 996 Bedienungsanleitung

Kohler

Kohler K-1954 Montageanleitung

Kohler

Kohler AVID 97367T-4 Bedienungsanleitung

Kohler

Kohler 11829T-B Bedienungsanleitung

Kohler

Kohler Leighton K-2326 Montageanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung