Kohler K-12177 Bedienungsanleitung

Installation Guide

Kitchen Sink Faucet

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page “Français-1”

Español, página “Español-1”

K-12177

1004614-2-E

Tools and Materials

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few

minutes to review this manual before you start installation. If you

encounter any installation or performance problems, please don’t

hesitate to contact us. Our phone numbers and website are listed on

the back cover. Thanks again for choosing Kohler Company.

Before You Begin

CAUTION: Risk of fresh water contamination. This faucet

contains important back-siphonage protection. Do not replace the

faucet ground joints or remove any components.

CAUTION: Risk of restricted water ﬂow and product damage.

Use extreme care when connecting all hoses to avoid kinking

and twisting.

Observe all local plumbing and building codes.

Shut off the water supplies.

Before installation, unpack the new faucet and inspect it for

damage. Return the faucet to the carton until you are ready to

install it.

Carefully inspect waste and supply tubing for any sign of

damage and replace if necessary.

For new installations, assemble the faucet to the sink before

installing the sink.

Except for plumbers putty on the undercover, do not use

petroleum based products on this faucet.

Plumbers

Putty Adjustable

Wrenches Masking

Tape Pencil Phillips

Screwdriver

1004614-2-E 2 Kohler Co.

Before You Begin (cont.)

Kohler Co. reserves the right to make revisions in the design of

faucets without notice, as speciﬁed in the Price Book.

Kohler Co. 3 1004614-2-E

1. Install the Escutcheon (Optional)

For 1-hole Installations:

Apply a bead of plumbers putty to the underside of the

escutcheon according to the manufacturer’s instructions.

Position the escutcheon over the sink hole, align, then press into

place.

Remove any excess putty.

For 3-hole Installations:

Apply a bead of plumbers putty or other sealant to the bottom

edges of the undercover according to the manufacturer’s

instructions.

Position the undercover over the sink hole, align, then press into

place.

Remove any excess putty.

Place the escutcheon over the undercover.

Escutcheon For

Three-Hole Sinks

Escutcheon For

One-Hole Sinks

Faucet

Undercover

1004614-2-E 4 Kohler Co.

2. Install the Faucet

Fit the faucet through the sink hole.

Position the faucet so the handle faces toward the user.

Partially thread two screws into the threaded ring until they

barely protrude from the backside of the threaded ring.

Slide the ﬁber washer, metal washer, and ring to the threaded

shank until it is about 1/4″(6 mm) from touching the sink

bottom.

Turn the ring so the screws are to the front and back of the

faucet.

Tighten the screws securely and evenly using a Phillips

screwdriver.

Metal Washer

Ring

Screw

Sink Threaded Shank

Fiber Washer

Kohler Co. 5 1004614-2-E

3. Connect the Spray Hose

NOTE: To prevent kinking damage to the spray hose, the weight

must be installed onto the spray hose to act as a pull stop.

Slide the weight up 9″(22.9 cm) from the unattached end of the

spray hose. If necessary, the weight may be moved up or down at

this time to adjust the pullout length of the spray hose.

Carefully tighten the weight screws on the weight at the desired

location. Do not overtighten.

Reconnect the unattached end of the spray hose to the hose

connector.

Spray Hose

Supply Hose

Valve Outlet Hose

Hose Guide

Weight

Spray Hose

9" (22.9 cm)

1004614-2-E 6 Kohler Co.

4. Connect the Supplies

NOTE: If the sink installation requires that you coil the supply hoses

to obtain a good connection, maintain an inside coil diameter of at

least 3″(7.6 cm).

Carefully position the hot and cold supplies so they will not

interfere with the other hoses.

Connect the supply hoses to the supply stops. Left is hot, right is

cold.

Tighten all connections.

3" (7.6 cm)

or Larger

Cold

Hot

Kohler Co. 7 1004614-2-E

5. Flush the Supply Lines

Place a stopper in the drain of the sink to ensure the faucet

components do not fall down the drain.

Pull the sprayhead out to partially expose the hose.

Remove the sprayhead with screen gasket from the spray hose.

Remove the seal retainer, O-ring, and plastic washer from the end

of the spray hose.

Position the hose in the sink. Tie or tape the hose to the sink to

prevent it from sliding back into the faucet.

Turn on the hot and cold water supplies.

Remove the stopper in the drain of the sink.

Turn the faucet handle to the full cold position and lift to the

″ON″position.

Run the cold water through the faucet for about one minute to

remove any debris.

Turn the faucet handle to the full hot position.

Run the hot water through the faucet for about one minute to

remove any debris.

Push the lever handle down to the ″OFF″position.

Place a stopper in the drain of the sink.

Reinstall the seal retainer, O-ring, and plastic washer into the end

of the spray hose.

Sprayhead

Seal Retainer

Hose

Tape

Screen Gasket

O-Ring

Plastic Washer

1004614-2-E 8 Kohler Co.

Flush the Supply Lines (cont.)

Reinstall the screen gasket and sprayhead to the spray hose.

Remove the stopper in the drain of the sink.

Run water through the faucet again and check for leaks.

Kohler Co. 9 1004614-2-E

6. Adjust the Water Temperature

Remove the plug button and screw from the handle.

Remove the handle and bonnet from the faucet body.

Lift the valve stem up and off the stop tab. The water will turn

on.

Align the stop tab with the mounting nut to establish the

maximum temperature.

Mark the maximum temperature on the mounting nut with a

marker or pencil.

Lift up the indexer and disk to clear the splines.

NOTE: Each spline notch represents approximately 9.5°F (5.3°C).

Turn the indexer, disk and valve stem counterclockwise, until the

temperature is properly adjusted.

Push down the indexer and disk to cover the splines after the

temperature is adjusted. Ensure that the disk is fully snapped into

the indexer.

Push the valve stem down onto the stop tab. The water will turn

off.

Reinstall the bonnet, handle, screw, and plug button.

Plug

Button

Screw

Bonnet

Stop Tab

Mounting

Nut Splines

Indexer

Disc

Valve

Stem

Handle

1004614-2-E 10 Kohler Co.

Andere Handbücher für K-12177

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler 528D Bedienungsanleitung

Kohler

Kohler C3-050 Montageanleitung

Kohler

Kohler K-2443-4 Montageanleitung

Kohler

Kohler Mira Sport J03A Bedienungsanleitung

Kohler

Kohler K-97060-4-CP Bedienungsanleitung

Kohler

Kohler K-2804 Bedienungsanleitung

Kohler

Kohler Stillness K-14450 Bedienungsanleitung

Kohler

Kohler K-1418-GCR Kurzanleitung

Kohler

Kohler AIRFOIL 37273T Bedienungsanleitung

Kohler

Kohler Fairfax K-12265-4-BN Montageanleitung

Kohler

Kohler K-8724 Bedienungsanleitung

Kohler

Kohler K-7653 Montageanleitung

Kohler

Kohler K-6130 Montageanleitung

Kohler

Kohler K-2096 Bedienungsanleitung

Kohler

Kohler Castia K-TS35917-4Y-2MB Bedienungsanleitung

Kohler

Kohler K-3099 Montageanleitung

Kohler

Kohler 12969T-B Bedienungsanleitung

Kohler

Kohler C3-050 Bedienungsanleitung

Kohler

Kohler K-1243 Bedienungsanleitung

Kohler

Kohler K-349 Montageanleitung

Kohler

Kohler Serif 5 BubbleMassage K-1337-G Bedienungsanleitung

Kohler

Kohler K-9142 Bedienungsanleitung

Kohler

Kohler K-1106 Bedienungsanleitung

Kohler

Kohler K-14675 Montageanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung