Kohler Stillness K-14450 Bedienungsanleitung

Installation Guide

Accessories

K-14450, K-14451, K-14452,

K-14455, K-14456, K-14458,

K-14459, K-14461, K-14463

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page “Français-1”

Español, página “Español-1”

1013267-2-C

Tools and Materials

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few

minutes to review this manual before you start installation. If you

encounter any installation or performance problems, please don’t

hesitate to contact us. Our phone numbers and web site are listed on

the back cover. Thanks again for choosing Kohler Company.

Before You Begin

DANGER: Risk of personal injury. These products are not

designed or intended for use as a grab bar or support bar. Do

not install any of these products in any area where they are

likely to be used inadvertently as a grab bar or support bar.

NOTE: When installing the glass shelf, do not drill the mounting

holes for the second wall plate until the actual product is measured.

Determine the wall plate location using the product measurement.

These products should be located and mounted to a wall stud.

While it is possible to mount them to any surface, a stud

mounted product will yield the best results.

Use a level to ensure that the center lines for the wall plates are

vertical where applicable and the post center lines are horizontal

where applicable.

Kohler Co. reserves the right to make revisions in the design of

products without notice, as speciﬁed in the Price Book.

Observe all local plumbing codes and building codes.

1013267-2-C 2 Kohler Co.

1. Roughing-In Information

Kohler Co. 3 1013267-2-C

2. Prepare the Site — Wall Plate(s)

Determine the desired mounting location.

Mark the vertical and horizontal center lines for the accessory to

be installed. Consult the roughing-in diagrams to determine the

dimensions.

When installing multiple-post accessories, measure the accessories

so you can provide the required distance between the center

points.

Use a level to ensure that all center points are level.

3. Mark and Drill the Pilot Holes

Mark the pilot hole locations vertically 15/32” (1.1cm) above and

below the center point or center points.

Vertically align the holes on each wall plate. Make sure the larger

hole is oriented as shown in the illustration.

If the installation requires multiple posts, conﬁrm that the center

points are even using a level.

NOTE: There is no provision for later adjustment if the center points

and resulting pilot holes for multiple post accessories are not level.

Select a drill and 5/16” drill bit that are appropriate for the wall

material you will be drilling through.

Carefully drill a 5/16” hole at all marked pilot hole locations.

1013267-2-C 4 Kohler Co.

4. Anchor Installation

NOTE: You may need to disassemble some of the accessories. Some

accessories will be packed with the wall plate installed in the post.

Loosen the setscrew and remove the wall plate if needed.

Press and hold the legs of a wall anchor (provided) together and

insert the wall anchor legs into the hole. Insert all wall anchors

into the pre-drilled mounting holes.

With a hammer, carefully tap each wall anchor until they are

ﬂush with the ﬁnished surface.

If the wall anchor was inserted into a space between the studs, it

will be necessary to spread the wall anchor legs.

To spread the anchor legs, insert the supplied red key into the

wall anchor hole.

Repeat for all wall anchors inserted between studs.

Ensure that the wall anchors are ﬂush with the ﬁnished surface.

5. Wall Plate Installation

Orient the wall plate with the large slotted mounting hole down

and the smaller hole over the higher anchor.

Secure the wall plate with the supplied panhead screws.

Repeat at each wall plate location.

NOTE: The tissue holder may be installed horizontally or vertically.

Position the wall plate accordingly.

Kohler Co. 5 1013267-2-C

6. Install the Tissue Holder

NOTE: This toilet tissue holder may be installed horizontally or

vertically. Position the wall plate accordingly.

Start a setscrew into the setscrew hole in each post. Do not thread

fully into the post.

Position the escutcheons, if included, onto the wall plates.

NOTE: The escutcheons are loose until the posts are in place and the

setscrews are tightened.

Install the tissue holder post onto the wall plate.

Tighten each setscrew.

7. Install the Towel Ring

Start the setscrew into the setscrew hole in the post. Do not

thread fully into the post.

Position the escutcheon, if included, onto the wall plate.

Install the towel ring post onto the wall plate.

Tighten each setscrew.

NOTE: The escutcheons are loose until the posts are in place and the

setscrews are tightened.

1013267-2-C 6 Kohler Co.

8. Install the Towel Bar

Start a setscrew into each post. Do not thread fully into the post.

If included, place an escutcheon on both the left and right side

wall plates.

NOTE: The escutcheons are loose until the posts are in place and the

setscrews are tightened.

Align the towel bar assembly over the wall plates. Slide the

assembly onto the wall plates.

Tighten the setscrews with a hex wrench.

9. Install the Robe Hook

Start a setscrew into each post. Do not thread fully into the post.

If included, slide an escutcheon onto the wall plate.

NOTE: The escutcheon sits loosely until the post is in place and the

setscrew is tightened.

Align the robe hook assembly over the wall plate.

Tighten the setscrew with a hex wrench.

Kohler Co. 7 1013267-2-C

10. Install the Soap Dish

Start a setscrew into the post. Do not thread fully into the post.

If included, place an escutcheon on the wall plate.

NOTE: The escutcheon sits loosely until the post is in place and the

setscrew is tightened.

Align the soap dish assembly over the wall plate.

Tighten the setscrew with a hex wrench.

11. Install the Tumbler Holder

Start a setscrew into the post. Do not thread fully into the post.

If included, place an escutcheon on the wall plate.

NOTE: The escutcheon sits loosely until the post is in place and the

setscrew is tightened.

Align the tumbler holder assembly over the wall plate.

Tighten the setscrew with a hex wrench.

Insert the glass tumbler into the holder.

1013267-2-C 8 Kohler Co.

12. Install the Glass Shelf

Start a setscrew into each post.

If included, place an escutcheon on the wall plate.

NOTE: The escutcheon sits loosely until the post is in place and the

setscrew is tightened.

Align a post over a wall plate. Repeat with the other post.

Loosely secure both posts with the setscrews.

Carefully place the shelf into position in the brackets.

Adjust the bracket assembly alignment as needed.

Tighten the setscrews on both the bracket assemblies and the

posts.

Kohler Co. 9 1013267-2-C

Guide du Propriétaire

Accessoires

Outils et Matériaux

Merci d’avoir choisi un des produits de la Société Kohler

Nous apprécions votre engagement envers la qualité de KOHLER. S’il

vous plaît, veuillez lisez attentivement ce Guide du Propriétaire avant

de commencer l’installation. En cas de problème d’installation ou de

fonctionnement, n’hésitez pas à nous contacter. Notre numéro de

téléphone et notre adresse de site Internet sont au verso de ce Guide

de l’Installation. Merci encore d’avoir choisi la Société KOHLER.

Avant de Commencer

DANGER : Risque de blessure. Ces accessoires ne sont pas

destinés ou conçus pour servir de barre d’appui ou de main

courante. N’installez pas ces accessoires dans un endroit où ils

pourraient être utilisés de cette façon par inadvertance.

REMARQUE : Quand vous installerez l’étagère en verre, ne percez

pas les trous pour la deuxième plaque murale sans avoir pris les

dimensions de l’accessoire. Déterminez l’emplacement de l’accessoire

en utilisant les dimensions du produit.

Il est préférable d’installer ces accessoires sur un support mural.

Ces accessoires peuvent être installés sur différentes surfaces,

mais l’installation sur un support mural sera plus solide.

Marteau à Griffes

Mètre Ruban

Niveau à

Bulles

Tournevis

Variés Clés Hexagonale

Variées

Kohler Co. Français-1 1013267-2-C

Andere Handbücher für Stillness K-14450

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler Stance 14787A Bedienungsanleitung

Kohler

Kohler K-11797T Bedienungsanleitung

Kohler

Kohler K-705771 Montageanleitung

Kohler

Kohler K-T9493 Bedienungsanleitung

Kohler

Kohler Margaux Series Bedienungsanleitung

Kohler

Kohler K-6350 Montageanleitung

Kohler

Kohler 76633T-B Bedienungsanleitung

Kohler

Kohler K-13132 Bedienungsanleitung

Kohler

Kohler K-2002 Bedienungsanleitung

Kohler

Kohler 10373 Bedienungsanleitung

Kohler

Kohler K-4761 Bedienungsanleitung

Kohler

Kohler Centerset K-15241 Montageanleitung

Kohler

Kohler K-3487 Bedienungsanleitung

Kohler

Kohler K-T10585 Bedienungsanleitung

Kohler

Kohler STATEMENT K-26325T-CP Bedienungsanleitung

Kohler

Kohler C3-225 K-4736T-0 Bedienungsanleitung

Kohler

Kohler Purist K-T14428 Bedienungsanleitung

Kohler

Kohler K-4991X Montageanleitung

Kohler

Kohler K-5805 Montageanleitung

Kohler

Kohler K-5293 Bedienungsanleitung

Kohler

Kohler K-14663 Montageanleitung

Kohler

Kohler 13142-4A-CP Montageanleitung

Kohler

Kohler NEW MEMOIRS K-76555T Bedienungsanleitung

Kohler

Kohler GANDIDE 11685T-4 Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung