Kohler K-9132 Bedienungsanleitung

Installation Guide

Shower Drain

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page “Français-1”

Español, página “Español-1”

K–9132

1032220-2-B

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few

minutes to review this manual before you start installation. If you

encounter any installation or performance problems, please don’t

hesitate to contact us. Our phone numbers and website are listed on

the back cover. Thanks again for choosing Kohler Company.

Tools and Materials

Before You Begin

Read all instructions before you begin.

This guide provides instructions for installing this drain with

either the included gasket/connector or with oakum and lead.

NOTE: Install the shower drain to the ﬁxture before installing the

ﬁxture.

Observe all local plumbing and building codes.

Turn off the main water supply.

Carefully inspect the ﬁttings for damage.

Plus:

For Oakum and Lead

Installations:

Basin Wrench

Safety Glasses

Hammer Pipe Wrench

• Caulking Lead

• Oakum

• Lead Furnace

• Pot

• Ladle

• Yarning and Packing

Irons

Hacksaw or Tubing Cutter

Tape Measure

• Caulk

• Caulking Iron

• Caulking Hammer

• Pipe Reamer

• Soap Solution

1032220-2-B 2 Kohler Co.

Before You Begin (cont.)

Locate the rough plumbing for the shower drain according to the

dimensions speciﬁed for the ﬁxture and for this ﬁtting.

Kohler Co. reserves the right to make revisions in the design of

drains without notice, as speciﬁed in the Price Book.

Kohler Co. 3 1032220-2-B

1. Prepare the Site

The 2″NPT (2-3/8″OD) drain pipe must extend as speciﬁed for

the ﬁxture. Consult the ﬁxture installation instructions.

Provide a 4-5/8″(11.7 cm) D. minimum hole in the subﬂoor to

accommodate the 4-1/2″(11.4 cm) shower drain nut. Provide a

minimum working depth of 1-1/2″(3.8 cm) to accommodate the

shower drain nut, washer, gasket, and strainer body.

4-5/8"

(11.7 cm) Min

2" NPT

2-3/8" OD

1-1/2"

(3.8 cm)

Min

1/4" (6 mm)

See fixture

instructions.

Subfloor

1032220-2-B 4 Kohler Co.

2. Install the Shower Drain

Add support blocks to the shower ﬁxture to access the drain hole.

Apply a bead of caulk around the underside of the strainer body

ﬂange.

Position the strainer body ﬂange through drain hole in the

shower ﬁxture.

Fit the gasket and washer over the strainer body and secure with

the nut.

As an alternative to pre-installing the shower drain to the shower

ﬁxture, place the nut, gasket, and washer over the drain pipe

before installing the shower ﬁxture.

After the shower ﬁxture is installed, thread the strainer body into

the nut from above. This alternative may present difficulty in

threading the nut.

Use the integral bar in the strainer body to securely tighten the

strainer body to the shower ﬁxture.

Set the shower ﬁxture squarely into the pocket in the subﬂoor or

slab and over the drain pipe.

Shim and level the shower ﬁxture according to the ﬁxture

instructions prior to connecting the drain pipe.

Verify that the drain pipe extends into the drain body the

required distance, and that the drain pipe is centered in the drain

body.

Support

Blocks

Strainer Body

Flange

Shower

Fixture

Gasket

Washer

Nut

Notches for

Tightening

Seal Gap

Kohler Co. 5 1032220-2-B

Install the Shower Drain (cont.)

Secure the ﬁxture according to the shower ﬁxture installation

instructions.

If installing the shower drain using the provided

gasket/connector, proceed to Option A.

If installing the shower drain using oakum and lead, proceed to

Option B.

1032220-2-B 6 Kohler Co.

3. Option A: Install Using Gasket/Connector

Ensure that the drain pipe extends 1-1/4″(3.2 cm) into the drain

body. Center the shower ﬁxture over the drain pipe.

Lubricate the gasket/connector with soap solution.

With the drain pipe inserted into the drain body, pull the

gasket/connector over the drain pipe so the raised letters face

upward.

Push the gasket/connector downward into the strainer body so it

ﬁts tightly.

Use a hammer and caulking tool (a short, narrow piece of wood

will suffice if a caulking tool is not available) to carefully drive

the gasket/connector as far into the drain body as possible. The

drain pipe should be even with the top of the gasket/connector.

Proceed to the ″Complete the Installation″section.

Strainer

Body

Strainer

Plate

Gasket/

Connector

Kohler Co. 7 1032220-2-B

4. Option B: Install Using Oakum and Lead

WARNING: Risk of personal injury. An explosion can occur

if moisture comes in direct contact with molten lead. Pre-heat

wet or cold lead on the side of the furnace before adding it to

a pot containing molten lead. Dry the shower ﬁxture, drain

pipe, and all shower drain components before installing the

drain ﬁtting over the drain pipe.

Gather the materials and prepare the site for lead caulking.

Begin melting the lead. Use enough lead to ensure that the joint

can be ﬁlled in one pour.

While the lead is melting, yarn and pack oakum into the gap

between the drain pipe and the strainer body to a depth of

1-5/16″(3.3 cm) from the top of the strainer body [5/8″(1.6 cm)

thickness].

Eliminate all loose oakum ﬁbers by packing them into the joint

with a yarning iron or packing iron heated in the molten lead pot.

Pour the molten lead into the joint to the top of the pipe in one

pour. Allow the lead to cool.

With the caulking hammer and the inside caulking iron, drive

down the lead in four places to set the joint.

Move the inside caulking iron slowly around the joint and pound

it with the caulking hammer to thoroughly caulk the inside edge.

With the outside caulking iron, work slowly around the joint with

the caulking hammer to thoroughly caulk the outside edge.

Oakum (see text)

Lead (see text)

1032220-2-B 8 Kohler Co.

5. Complete the Installation

Plug the inside diameter of the drain pipe and run water into the

drain.

Check for leaks at the joint and around the strainer body ﬂange.

Remove the plug.

Press the strainer plate or drain cover ﬁrmly into the strainer

body.

Strainer Body

Flange

Strainer Plate or

Drain Cover

Kohler Co. 9 1032220-2-B

Guide d’installation

Drain de douche

Outils et matériels

Merci d’avoir choisi la compagnie Kohler

Nous apprécions votre engagement envers la qualité Kohler. Veuillez

prendre s’il vous plaît quelques minutes pour lire ce manuel avant de

commencer l’installation. Ne pas hésiter à nous contacter en cas de

problème d’installation ou de performance. Nos numéros de téléphone

et notre adresse du site internet sont au verso. Merci encore d’avoir

choisi la compagnie Kohler.

Avant de commencer

Veuillez lire toutes les instructions avant de commencer

l’installation.

Plus:

Pour des installations

avec filasse et plomb:

Clé pour

bassin

Lunettes de

protection

Marteau Clé à tuyau

• Plomb de garnissage

• Filasse

• Appareil de

chauffage à plomb

• Marmite

• Poche de coulée

• Fers pour filer et

entasser

Scie à métaux ou coupe

tubes

Mètre ruban

• Mastic

• Cordoir

• Marteau à mastiquer

• Aléseur de tuyau

• Solution savonneuse

Kohler Co. Français-1 1032220-2-B

Andere Handbücher für K-9132

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler Fountainhead K-1786 Bedienungsanleitung

Kohler

Kohler PureFlo K-37388 Montageanleitung

Kohler

Kohler Serif 5 BubbleMassage K-1337-G Bedienungsanleitung

Kohler

Kohler K-17492 Montageanleitung

Kohler

Kohler K-T14783 Montageanleitung

Kohler

Kohler K-98741 Montageanleitung

Kohler

Kohler K-669 Montageanleitung

Kohler

Kohler K-1997 Montageanleitung

Kohler

Kohler K-332 Bedienungsanleitung

Kohler

Kohler K-T16106 Bedienungsanleitung

Kohler

Kohler CORALAIS K-15290 Bedienungsanleitung

Kohler

Kohler Kathryn K-2322 Montageanleitung

Kohler

Kohler PURIST Series Bedienungsanleitung

Kohler

Kohler Sunstruck K-24009-GH Bedienungsanleitung

Kohler

Kohler ENGLEFIELD TAPWARE STUDIO 20149A-4 Bedienungsanleitung

Kohler

Kohler Singulier 10861-4ND Bedienungsanleitung

Kohler

Kohler K-6945 Bedienungsanleitung

Kohler

Kohler K-9110 Montageanleitung

Kohler

Kohler Rada T1 Bedienungsanleitung

Kohler

Kohler Parallel T23492-4-CP Bedienungsanleitung

Kohler

Kohler Trend K-11935 Montageanleitung

Kohler

Kohler Modernlife Touchless 77786K-TF-0 Bedienungsanleitung

Kohler

Kohler K-6228 Montageanleitung

Kohler

Kohler K-7305 Betriebsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung