Kohler ENGLEFIELD TAPWARE STUDIO 20149A-4 Bedienungsanleitung

BEFORE YOU BEGIN

1329095-AN2-C Jan 2020

INSTALLATION

INSTRUCTIONS

TAPWARE

Englefield

STUDIO Pin Lever Wall-Mount

Basin Mixer 20149A-4

All information is based on the latest product information available at the time of

publication. ENGLEFIELD reserves the right to make changes in product charac-

teristics, packaging, or availability at any time without notice.

Please leave this installation guide for the consumer as it contains important

information.

NOTES:

1. Flush the water supply pipes thoroughly to remove any debris.

2. An in-line water filter must be used with this product.

3. If possible, install this mixer before installing basin.

4. Ensure all local plumbing codes are observed.

5. Recommended working pressure: 100kPa to 500kPa.

6. Maximum working pressure: 800kPa.

7. If pressure exceeds 500kPa, a pressure limiting valve must be installed.

8. All installations should comply with the relevant requirements of AS/NZS 3500 and

AS/NZS 6400.

ROUGH-IN

NEW ZEALAND

KOHLER NZ LTD

Free Ph: 0800 100 382

Free Fax: 0800 664 488

www.engleﬁeld.co.nz

AUSTRALIA

KOHLER AUSTRALIA

Free Ph: 1 800 ENGLEFIELD

(1 800 364 533)

www.engleﬁeld.com

For warranty information, please visit our website

Page 41329095-AN2-C Jan 2020 Englefield

INSTALLATION INSTRUCTIONS

STUDIO Pin Lever Wall-Mount Basin Mixer

185.5

G1/2”

168

85.5

G1/2”

185

120

910

12 13

11 Grub Screws 1250284

12 Spout 1329216-**

13 Washer 1250285

14 Aerator 1250293

15 Aerator Shell 1250290-**

16 Grub Screw 1250284

17 Plug 1250283-**

No. Description Part No.

1 Pin Lever 1329093-**

2 Bonnet 1250279-**

3 Nut 1250281

4 Cartridge 1372775

5 Mixer Face Plate 1329213-**

6 O-Ring - Mixer

Face Plate

7 O-Ring 1250325

8 Spout Face Plate 1329215-**

9 Spout Adaptor 1250328

10 O-Ring 1250324

** Please specify a colour when ordering:

-CP (Chrome),

-BN (Brushed nickel),

-BL (Matte Black)

1329214

SPARE PARTS LIST

CLEANING INSTRUCTIONS

All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with a clean

soft cloth. Many cleaners may contain such chemicals as ammonia, chlorine, toilet chemicals etc., which could

adversely affect the finish and are not recommended for cleaning.

Do not use abrasive cleaners or solvents on Englefield tapware.

CONTACT AND WARRANTY INFORMATION

Flush

Wall

Faceplate

Flange

INSTALLATION - SPOUT AND TRIM KIT

INSTALLATION - IN-WALL VALVE

1329095-AN2-C Jan 2020 Page 2 Englefield 1329095-AN2-C Jan 2020 Page 3 Englefield

STUDIO Pin Lever Wall-Mount Basin Mixer INSTALLATION INSTRUCTIONS STUDIO Pin Lever Wall-Mount Basin Mixer INSTALLATION INSTRUCTIONS

1.) Construct a suitable nog for mounting the in-wall valve (1). Ensure the nog is level and at the correct depth.

Note: Distance from mounting surface to external surface of finished wall is between 41mm and 54mm.

1.) After the finished wall (6) has been completed, remove the plastic guards.

2.) Screw the spout adaptor (7) onto the spout nipple (2).

3.) Apply a bead of silicone to the rear of the spout faceplate (8). Slide the spout faceplate onto the spout adaptor

and push it firmly against the wall.

4.) Readjust the postion of spout adaptor (7) to ensure that the back surface of its flange flushes with the front

surface of the faceplate (8).

5.) Fit the spout (10) onto the spout adaptor, press it firmly against the spout faceplate. Make sure it is level and

tighten the grub screws(9) with the hex key (supplied).

6.) Apply a bead of silicone to the rear of the pin lever faceplate (12). Slide the pin lever faceplate onto the valve

body (14) and push it firmly against the wall.

7.) Install the handle (11) onto the cartridge stud (13) and tighten the grub screw (15) with the hex key (supplied).

8.) Insert the plug button (16) into the handle.

INSTALLATION CHECKOUT - FINAL

1.) Ensure that all connections are tight. Ensure that the handle is in

the off position.

2.) Open the basin drain as necessary. Turn on main water supply

and check for leaks. Repair as required.

3.) Remove aerator (17). Turn on the basin mixer. Run hot and cold

water through spout for about one minute to remove any debris.

Remove any debris from aerator. Shut off the basin mixer and

reinstall aerator.

2.) Ensure the cold water inlet (3) is on the right. Fix the in-wall valve body onto the nog through the lugs(4).

Note: Fixing screws not supplied.

3.) Connect the G1/2” water supply pipes to the inlets.

Note: Cold water inlet (3) on the right, hot water inlet (5) on the underside.

NOTE: DO NOT DISCARD THE PLASTIC GUARDS UNTIL THE FINISHED WALL HAS BEEN COMPLETED.

Finished

wall

Nog

Distance: 41mm ~ 54mm

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler Mira Logic L19B Bedienungsanleitung

Kohler

Kohler K-18865 Montageanleitung

Kohler

Kohler ALEO Bedienungsanleitung

Kohler

Kohler K-98835T-L Bedienungsanleitung

Kohler

Kohler K-669 Montageanleitung

Kohler

Kohler 97345IN-4 Series Bedienungsanleitung

Kohler

Kohler 32E Bedienungsanleitung

Kohler

Kohler K-T6808 Bedienungsanleitung

Kohler

Kohler K-4918 Bedienungsanleitung

Kohler

Kohler K-8703X Montageanleitung

Kohler

Kohler WELLINGTON WATERGUARD K-3415 Bedienungsanleitung

Kohler

Kohler Strayt Bedienungsanleitung

Kohler

Kohler K-6228 Montageanleitung

Kohler

Kohler Clearflo K-7160-TF Montageanleitung

Kohler

Kohler HARTLAND K-11021T-1S Bedienungsanleitung

Kohler

Kohler K-7145 Montageanleitung

Kohler

Kohler C3-430 Montageanleitung

Kohler

Kohler Stargaze BubbleMassage K-1959-GHW Bedienungsanleitung

Kohler

Kohler K-72218 Bedienungsanleitung

Kohler

Kohler STANCE 14760A-4ND Bedienungsanleitung

Kohler

Kohler K-6284 Montageanleitung

Kohler

Kohler K-14402 Bedienungsanleitung

Kohler

Kohler Mira Showers Escape Thermostatic 9.8 kW Bedienungsanleitung

Kohler

Kohler K-10217 Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung