Kohler K-98741 Montageanleitung

Installation and Care Guide

Lighted Rain Panel

Français, page ″Français-1”

Español, página ″Español-1”

K-98741

1207716-2-C

IMPORTANT INSTRUCTIONS

WARNING: When using electrical products, basic

precautions should always be followed, including the

following:

DANGER: Risk of electrocution. Disconnect the electricity

to the working area at the main breaker panel before

performing the installation steps for hardwiring.

DANGER: Risk of electric shock. Connect only to circuits

protected by a Ground-Fault Circuit-Interrupter (GFCI).

Grounding is required. The unit should be installed and

grounded by a qualiﬁed service representative.

WARNING: Risk of electric shock. A licensed electrician

should route all electrical wiring.

WARNING: Risk of electric shock. Disconnect power before

servicing.

WARNING: Risk of injury or property damage. Please read

all instructions thoroughly before beginning installation.

NOTICE: Follow all plumbing, electrical, and building codes.

NOTICE: Provide unrestricted service access to the Power Data

Supply (PDS). This access must be located immediately next to the

PDS. Refer to the roughing-in information.

Speciﬁcations

Shower Installation Application Ceiling-mount only

Ambient Temperature Max 104°F (40°C)

Maximum Relative Humidity 95% non-condensing

Power Data Supply (PDS) 100-240 VAC, 50-60 Hz, 1.7 A

PDS Power Cable Length 3’ (0.91 m)

Chroma Data Cable Length 30’ (9.14 m)

Chroma Power Cable Length 30’ (9.14 m)

1207716-2-C 2 Kohler Co.

Tools

Socket Wrench &

11 mm or 7/16"

Socket and Extension

5/64" and

5/32" Hex

Wrenches

Masking Tape

Sealant

Tape

Soldering

Supplies

Plus:

Note: All nipples & fittings 1/2" NPT

• (4) 2-1/2" nipples

• Female fittings

• 1/2" copper tubing

• 2x4s and 2x6s

• Conventional woodworking tools

& materials

• #8 x 1-1/2" drywall screws

• Standard wood or drywall screws

• Electrical Wire

• Wire Cutters or Wire Strippers

Phillips

Screwdriver

Kohler Co. 3 1207716-2-C

Roughing-In

20-1/8"

(511 mm)

5-1/2"

(140 mm)

8-1/4"

(210 mm)

1/8" (3 mm)

3-1/2"

(89 mm)

5/16"

(8 mm)

8-13/16"

(224 mm)

2" (51 mm)

Chroma Power Cable

30' (9.1 m)

Chroma Data Cable

3-1/2" (89 mm) Min Clearance

Bottom Face of Template/Cradle

3-5/16"

(84 mm)

4-13/16"

(122 mm)

1/2" NPT

9-5/8" (244 mm)

3-11/16"

(93 mm)

4-7/8" (124 mm)

Min Clearance

Bottom Face of

Ceiling Joist

19-5/16"

(490 mm)

21"

(533 mm)

1207716-2-C 4 Kohler Co.

Important Information

NOTICE: Choose an automatic compensating valve with the

appropriate minimum ﬂow rate to assure your valve will provide

safety at the lowest ﬂow rates.

•For a showerhead rated at 2.5 gal/min (9.5 l/min) maximum, use

with an automatic compensating valve rated at 2.0 gal/min (7.6

l/min) or less.

CAUTION: Risk of personal injury. If the rain panel is not

securely held in place during installation, the product may

fall causing personal injury. Get help when installing the light

panel assembly and waterways.

Observe all local plumbing, building, and electrical codes.

Your model may differ in appearance, the instructions still apply.

Read these instructions and determine all required components

along with their installation locations before beginning this

installation.

This product is designed for ceiling-mount installation only. Do

not install to a shower wall.

This manual covers vertical installation of the Power Data Supply

(PDS) in a service closet or 2x6 stud pocket. If the wall is

enclosed, an access panel must be provided for servicing.

The PDS may also be mounted under the ﬂoor joists. If mounting

under the ﬂoor, the unit must not be enclosed.

The PDS must be located within 25’ (7.62 m) of the rain panel.

Inspect the supply piping for damage. Replace as necessary.

The PDS is intended for hardwire installation. Make sure

electrical power can be provided to a service closet or 2x6 stud

framing with access panel, not more than 2’ (0.61 m) from the

intended PDS mounting location.

The installation must have a Class A Ground-Fault

Circuit-Interrupter (GFCI). The GFCI protects against

line-to-ground shock hazard. Use a 100 VAC - 240 VAC, 50 Hz -

60 Hz supply.

To reduce the risk of electric shock, locate the PDS and overhead

rain panel within proximity to each other to allow for each cable

to have a drip loop.

For service parts information, visit your product page at

www.kohler.com/serviceparts.

Kohler Co. 5 1207716-2-C

1. Determine Components

Speakers

AC Power AC Power

Media Module

Router

Computer Internet

Audio

Source

If a steam generator

is not used, connect

the PDS directly to

the media box.

Incandescent

Lighting

100-240 VAC

Power Data

Supply (PDS)

Steam

Adapter

Digital

Interfaces

Steam Generator

Digital

Mixing Valve

Lighted Rain Panel

1207716-2-C 6 Kohler Co.

Determine Components (cont.)

A 30’ (9.14 m) power cable is supplied for connecting the

overhead rain panel to the PDS. A 30’ (9.14 m) data cable is

supplied for connecting the PDS to the media module or steam

adapter.

Determine all required components along with their installation

locations before beginning the overhead rain panel installation.

Route the chroma power cable from the rain panel installation

location to the PDS installation location.

Route the chroma data cable from the PDS installation location to

the media module or steam adapter installation location.

Kohler Co. 7 1207716-2-C

2. Install the Supply Piping – Single Supply

Route the water supply lines.

Use the provided soldering template to construct a pressure

balancing loop.

Position tees in the loop over each of the four raised locations on

the template.

Solder the assembly while it is attached to the template.

Remove the pressure balancing loop from the template.

Connect the pressure balancing loop to the water supply.

Do not strap the pipes.

Temporarily install a nipple to each tee. Do not use any sealant.

Ø 9-5/8"

(244 mm)

6-3/4"

(172 mm)

Soldering Template

6-3/4" (172 mm)

Clamp each tee

to the template

during soldering.

1/2" NPT Nipple

Soldering

Template

Pressure

Balancing Loop

Pressure

Balancing

Loop

1207716-2-C 8 Kohler Co.

3. Install the Supply Piping – Multiple Supplies

Route the water supply lines.

Use the provided soldering template to construct the pressure

balancing loops.

Position tees in the loops over each of the four raised locations on

the template.

Solder the assembly while it is attached to the template.

IMPORTANT! To ensure proper alignment of the tees with the

product, the two pressure balancing loops must be rigidly connected

to each other while on the soldering template.

While still on the soldering template, rigidly connect the two

pressure balancing loops to each other.

Remove the pressure balancing loop assembly from the template.

Connect the pressure balancing loops to the water supplies.

Do not strap the pipes.

Temporarily install a nipple to each tee. Do not use any sealant.

Pressure

Balancing

Loops

1/2" NPT Nipple

Soldering

Template

Clamp each tee

to the template

during soldering.

Rigidly connect

to each other.

Ø 9-5/8"

(244 mm)

6-3/4"

(172 mm)

Soldering Template

6-3/4" (172 mm)

Kohler Co. 9 1207716-2-C

4. Install the Support Framing

WARNING: Risk of injury or property damage.

Template/cradle must be properly secured to support the

weight of the rain panel. Secure the cradle to the framing

using a minimum of six #8 x 1-1/2″long drywall screws.

If installing the rain panel to a ﬁnished ceiling, remove drywall

from the installation location.

IMPORTANT! The soldering template must be secured to structural

framing.

Attach a mounting surface to structural framing of the ceiling

using #8 x 1-1/2″long drywall screws.

Construct the support framing using 2x4 studs as shown in the

illustration above. The face of each 2x4 should be installed ﬂush

with the face of the ceiling joists.

Position the soldering template/cradle under the pressure

balancing loop(s), as illustrated. Attach the cradle to the support

framing.

Do not strap the pipes.

14-1/2" (368 mm)

12-1/4"

(311 mm)

2x4

Pressure

Balancing

Loop

Ceiling

Joist

Soldering

Template/Cradle

Bottom View

2x4 Ceiling Joist

Pressure

Balancing Loop

1207716-2-C 10 Kohler Co.

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler SYMBOL 72641T Bedienungsanleitung

Kohler

Kohler MODULO 99960T-4V Bedienungsanleitung

Kohler

Kohler K-7131 Montageanleitung

Kohler

Kohler KARAT K-23883 Bedienungsanleitung

Kohler

Kohler Mira Event XS Bedienungsanleitung

Kohler

Kohler KUMIN 99474T-C4 Bedienungsanleitung

Kohler

Kohler Mira Platinum Rear Fed Bedienungsanleitung

Kohler

Kohler Mira Showers Escape Thermostatic 9.8 kW Bedienungsanleitung

Kohler

Kohler Sterling SC2522SBG Montageanleitung

Kohler

Kohler K-97060-4-CP Bedienungsanleitung

Kohler

Kohler URBANITY+ 23751Т-9 Bedienungsanleitung

Kohler

Kohler K-19321T Bedienungsanleitung

Kohler

Kohler K-T13140 Bedienungsanleitung

Kohler

Kohler Loure K-15285 Montageanleitung

Kohler

Kohler K-7166-AF Montageanleitung

Kohler

Kohler S-TRAP K-27344T Bedienungsanleitung

Kohler

Kohler Pillows K-7943 Bedienungsanleitung

Kohler

Kohler ECO 72685T-B7 Bedienungsanleitung

Kohler

Kohler K-1913 Montageanleitung

Kohler

Kohler K-5024-T Bedienungsanleitung

Kohler

Kohler Karbon K-6227A Bedienungsanleitung

Kohler

Kohler Archer K-2359X Montageanleitung

Kohler

Kohler K-T15231 Bedienungsanleitung

Kohler

Kohler Oblo K-124B16-SANA-CP Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung