Kohler K-T10585 Bedienungsanleitung

Installation Guide

Bath/Deck Mount Faucet Trim

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page“ Français-1”

Español, página“ Español-1”

K-T10585

1036164-2-A

Tools and Materials

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few

minutes to review this manual before you start installation. If you

encounter any installation or performance problems, please don’t

hesitate to contact us. Our phone numbers and website are listed on

the back cover. Thanks again for choosing Kohler Company.

Before You Begin

The valve is sold separately. Please read the instructions packed

with the valve for installation procedures.

Deep rough-in kit #73444 allows an additional 1/2″(1.3 cm) of

tile thickness.

Please read all instructions before you begin.

Shut off the main water supply.

Observe all local plumbing and building codes.

Complete the ﬁnished deck material before installing.

Before installation, unpack the new faucet trim and inspect it for

damage. Return it to the carton until installation.

Kohler Co. reserves the right to make revisions in the design of

faucets without notice, as speciﬁed in the Price Book.

Adjustable

Wrench • Rag

Plus:

Tube Cutter

Tape

Measure

Hex

Wrench Assorted

Screwdrivers

File

Plumbers

Putty

1036164-2-A 2 Kohler Co.

1. Remove the Pipe Plug

WARNING: Risk of personal injury. Lines may be pressurized.

Do not lean over the pipe plug when turning or removing the

plug.

Make sure the valves are closed (cold = fully counterclockwise;

hot = fully clockwise).

Turn off the main water supply.

Wrap a rag around the pipe plug to prevent water spray.

IMPORTANT! Water may purge from the supply tube when you

remove the plug.

Carefully remove the pipe plug.

Pipe Plug

Hot

Cold

Kohler Co. 3 1036164-2-A

2. Prepare for Spout installation

Remove the plaster guard from the spout supply tube.

Cut off the spout supply tube 1-1/4” (3.2 cm) above the rim,

ﬁnished deck, or tile.

Remove all burrs from the spout supply tube to prevent damage

to the O-ring seal on the spout sleeve assembly.

NOTE: The washer is not needed for rim/ﬁnished deck installation.

If the installation includes a tile covered rough deck, slide the

washer, ﬂat side facing forward, onto the spout supply tube.

NOTE: Before installing the spout sleeve assembly, make sure the

O-ring is properly positioned in the groove on the outside of the

sleeve.

Back off the setscrews in the spout sleeve assembly.

With a twisting motion, place the spout sleeve assembly over the

spout supply tube and push down to the deck surface.

Align the sleeve with the setscrews offset from the center (not

facing directly forward or backward) of the spout supply tube.

Tighten the setscrews.

Purge the supply tube of debris.

Rough

Deck

Tile

Finish

1-1/4"

(3.2 cm) Washer

Spout

Supply

Tube

Rough

Deck

Finished

Deck

Setscrews

Spout Sleeve

Assembly

1036164-2-A 4 Kohler Co.

3. Install the Spout

IMPORTANT! Keep the spout supply tube clean above the ﬁnished

deck to avoid damage to the O-ring seal.

Loosen the spout setscrew until it is clear of the inside wall of the

spout.

Apply a ring of plumbers putty or other sealant around the

underside of the spout base according to the manufacturer’s

instructions.

Position the spout on the sleeve, and carefully press down until

the spout contacts the ﬁnished deck.

Rotate the spout until it is aligned to face straight forward.

Tighten the setscrew.

Insert the plug button (if included) over the setscrew, ﬂush with

the spout surface.

Remove any excess putty or sealant.

Sleeve

Setscrew

Finished

Deck

Spout

Assembly

PlugButton

Apply

plumbers

putty.

Kohler Co. 5 1036164-2-A

4. Install the Handles

NOTE: There are different handle styles available for this product.

Only one style of handle is shown. Installation of all handle styles is

identical.

Remove the plaster guards.

Measure the distance from the top of the valve stem to the

ﬁnished surface.

For a valve stem height between 1-13/16″(4.6 cm) and 2-1/8″(5.4

cm) use a brass spline adapter and screw. For a valve stem height

between 2-1/8″(5.4 cm) and 2-5/16″(5.9 cm) use a plastic spline

adapter.

If the brass spline adapter is required, attach using the screw

supplied. The plastic spline adapter slides on with no attachment.

Position the handle assemblies facing in opposite directions away

from the spout.

NOTE: The spline adapter allows ﬁne adjustment of the handle

alignment. To adjust, remove the handle and reposition the spline

adapter.

Align the handle.

Reinstall the handle and check alignment.

Handle

Screw Valve Stem

Valve Body

Plastic

Spline

Adapter

Brass Spline

Adapter

Valve Stem

Height

Measurement

Finished

Surface

Threaded

Sleeve

Apply plumbers

putty.

Hot Cold

Orientation of Handles

in Off Position

1036164-2-A 6 Kohler Co.

5. Complete the Installation

Turn off the water (hot = clockwise, cold = counterclockwise).

Remove the aerator assembly.

Turn on the main water supply and check for leaks.

Turn on the hot and cold valves and run water through the spout

to remove debris. Check for leaks.

Turn off the hot and cold valves.

Reinstall the aerator assembly.

Aerator

Kohler Co. 7 1036164-2-A

Guide d’installation

Garniture robinet montage sur

baignoire/comptoir

Outils et matériels

Merci d’avoir choisi la compagnie Kohler

Nous apprécions votre engagement envers la qualité Kohler. Veuillez

prendre s’il vous plaît quelques minutes pour lire ce manuel avant de

commencer l’installation. Ne pas hésiter à nous contacter en cas de

problème d’installation ou de fonctionnement. Nos numéros de

téléphone et notre adresse du site internet sont au verso. Merci encore

d’avoir choisi la compagnie Kohler.

Avant de commencer

La valve est vendue séparément. Veuillez s’il vous plaît lire les

instructions d’installation emballées avec la valve.

Le kit d’installation No.73444 permet une épaisseur additionnelle

de 1/2″(1,3 cm) de carreau.

Veuillez lire toutes les instructions avant de commencer.

Couper l’alimentation d’eau principale.

Respecter tous les codes de plomberie et de bâtiment locaux.

Compléter le matériau du comptoir ﬁni avant d’installer.

Cléà

molette • Chiffon

Plus:

Coupe-tubes

Mètre

ruban

Clé

hexagonale Tournevis

assortis

Lime

Mastic de

plombier

Kohler Co. Français-1 1036164-2-A

Avant de commencer (cont.)

Avant l’installation, déballer la garniture du nouveau robinet et

l’examiner pour en déceler tout dommage. Remettre le robinet

dans l’emballage jusqu’à l’installation.

Kohler Co. se réserve le droit d’apporter toutes modiﬁcations au

design des robinets et ceci sans préavis, comme spéciﬁé dans le

catalogue des prix.

Kohler Co. Français-2 1036164-2-A

1. Retirer le bouchon du tube

AVERTISSEMENT : Risque de blessure corporelle. Les

canalisations peuvent être pressurisées. Ne pas se pencher sur le

bouchon du tube au moment de le tourner et de le retirer.

S’assurer que les robinets soient fermés (côté froid complètement

vers la gauche, côté chaud complètement vers la droite).

Fermer l’alimentation d’eau principale.

Enrouler une serviette autour du bouchon du tube pour

empêcher l’eau de gicler.

IMPORTANT ! L’eau pourrait s’écouler du tube d’alimentation

d’eau lorsque le bouchon est retiré.

Retirer le bouchon de tuyau avec précaution.

Bouchon

du tuyau

Fermer l'eau

chaude

Fermer

l'eau froide

1036164-2-A Français-3 Kohler Co.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler K-1188 Bedienungsanleitung

Kohler

Kohler LUSTRA Bedienungsanleitung

Kohler

Kohler Triton K-T7019 Bedienungsanleitung

Kohler

Kohler CUFF 37301M-4 Bedienungsanleitung

Kohler

Kohler K-T8230 Bedienungsanleitung

Kohler

Kohler K-10088 Montageanleitung

Kohler

Kohler K-702200 Bedienungsanleitung

Kohler

Kohler PURIST Series Bedienungsanleitung

Kohler

Kohler K-7179 Montageanleitung

Kohler

Kohler Singulier K-T10449 Montageanleitung

Kohler

Kohler 23475-4-BL Bedienungsanleitung

Kohler

Kohler K-15171 Montageanleitung

Kohler

Kohler MARGAUX Montageanleitung

Kohler

Kohler K-251 Bedienungsanleitung

Kohler

Kohler 72842T-4ND Bedienungsanleitung

Kohler

Kohler STRAYT 37327M Bedienungsanleitung

Kohler

Kohler SKYLINE Series Bedienungsanleitung

Kohler

Kohler K-158 Bedienungsanleitung

Kohler

Kohler K-5665 Montageanleitung

Kohler

Kohler K-856 Kurzanleitung

Kohler

Kohler 16316-4FP Bedienungsanleitung

Kohler

Kohler Cabriole K-T14640 Montageanleitung

Kohler

Kohler K-13925 Bedienungsanleitung

Kohler

Kohler K-10217 Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung