Step 3: Install VS-21DTP
Install VS-21DTP using one of the following methods:
Attach the rubber feet and place the unit on a flat surface.
Fasten a bracket (included) on each side of the unit and attach it to a flat surface.
For more information go to www.kramerav.com/downloads/VS-21DTP.
Mount the unit in a rack using an optional RK-3T rack adapter.
Step 4: Connect the inputs and outputs
Always switch OFF the power on each device before connecting it to your VS-21DTP. For best results, we recommend that you
always use Kramer high-performance cables to connect AV equipment to VS-21DTP.
DIP-switches Setup:
A switch that is down is on; a switch that is up is off. By default, both switches are up (off).
Video Switching Selection:
INPUT 1 is the default priority setup and is automatically switched to the
output.
INPUT 2 is the default priority setup and is automatically switched to the
output.
The last connected source is switched to the output (a reactivated or
reconnected source becomes the new “Last Connected” source).
Contact Closure Switches (Manual Override):
Controlling via the remote contact closure pushbuttons overrides all DIP-switch settings and automatic switching until the manually
selected source disconnects, becomes inactive or the VS-21DTP is powered off.
Momentarily connect REMOTE IN 1 to PIN G (ground).
Momentarily connect REMOTE IN 2 to PIN G (ground).
Step 5: Connect the power
Connect the 48V DC power supply to VS-21DTP and plug it into the mains electricity or accept power over Ethernet (PoE) from an
HDBaseT receiver via PoE.
Safety Instructions
There are no operator serviceable parts inside the unit.
Use only the power cord that is supplied with the unit.
Do not open the unit. High voltages can cause electrical shock! Servicing by qualified personnel only.
Disconnect the power and unplug the unit from the wall before installing.
See www.KramerAV.com for updated safety information.
