Lantech IPES-3408GSFP Bedienungsanleitung

Lantech

IPES-3408GSFP

4 1000 SFP +8 10/100TX L2 + PoE

Industrial Managed Switch

User Manual

Beta.04

July. 2013

Recommendation for Shielded network cables

STP cables have additional shielding material that is used to reduce external interference. The

shield also reduces the emission at any point in the path of the cable. Our recommendation is

to deploy an STP network cable in demanding electrical environments. Examples of

demanding indoor environments are where the network cable is located in parallel with

electrical mains supply cables or where large inductive loads such as motors or contactors are

in close vicinity to the camera or its cable. It is also mandatory to use an STP cable where the

power device (like IP camera) is used outdoors or where the network cable is routed outdoors.

FCC Warning

This Equipment has been tested and found to comply with the limits for a

Class-A digital device, pursuant to Part 15 of the FCC rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy. It may cause harmful interference to radio

communications if the equipment is not installed and used in accordance

with the instructions. However, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

CE Mark Warning

This is a Class-A product. In a domestic environment this product may

cause radio interference in which case the user may be required to take

adequate measures.

Chapter 1 Introduction

The IPES-3408 series Managed Industrial Switch is a cost-effective solution and meets

the high reliability requirements demanded by industrial applications. Using fiber port can

extend the connection distance that increases the network elasticity and performance.

1.1 Hardware Features

Standard

IEEE 802.3 10Base-T Ethernet

IEEE 802.3u 100Base-TX

IEEE802.3z Gigabit fiber

IEEE802.3x Flow Control and Back Pressure

IEEE802.3ad Port trunk with LACP

IEEE802.1d Spanning Tree

IEEE802.1w Rapid Spanning Tree

IEEE802.1s Multiple Spanning Tree

IEEE 802.3ad Link Aggregation Control Protocol (LACP)

IEEE 802.1AB Link Layer Discovery Protocol (LLDP)

IEEE 802.1X User Authentication (Radius)

IEEE802.1p Class of Service

IEEE802.1Q VLAN Tag

IEEE802.3at/af Power over Ethernet

IEEE 802.3az Efficient Energy Ethernet

Switch

Architecture

Back-plane (Switching Fabric): 9.6Gbps

Packet throughput ability (Full-Duplex): 23.8Mpps

@64bytes

Transfer Rate

14,880pps for Ethernet port

148,800pps for Fast Ethernet port

1,488,000pps for Gigabit Fiber Ethernet port

MAC Address

16K MAC address table

Connector

10/100TX: 8 x RJ-45 type connector

Mini-GBIC: 4 x 1000 SFP Sockets

Power & P-Fail connector: 1 x 6-pole terminal block

RS-232 connector: 1 x RJ-45 type connector

Network Cable

10Base-T: 2-pair UTP/STP Cat. 3, 4, 5 cable

EIA/TIA-568 100-ohm (100m)

100Base-TX: 2-pair UTP/STP Cat. 5/ 5E cable

EIA/TIA-568 100-ohm (100m)

Optical Fiber

Multi-mode: 50/125um~62.5/125um; Single mode: 9/125um

Wavelength: 850nm (Multi-mode) / 1310nm (Single-mode)

Protocol

CSMA/CD

LED

Per unit: Power 1 (Green), Power 2 (Green), P-Fail (Red)

Ethernet port: Link/Activity (Green), Speed (Green); Mini-

GBIC: Link/Activity (Green)

Power Supply

48~56VDC, Redundant power input with 1500VDC isolation

-48VDC is single power input

Power

Consumption

10Watts (switch)/ 240Watts(with PoE)

Operating

Humidity

5% to 95% (Non-condensing)

Operating

Temperature

-20oC ~ 60oC

Storage

Temperature

-40oC ~ 85oC

Case Dimension

Metal case. IP-30,

65 (W) x 105 (D) x 152 (H) mm

Installation

DIN rail and wall mount ear

EMI

FCC Class A, CE EN61000-4-2, CE EN61000-4-3, CE EN-

61000-4-4, CE EN61000-4-5,

CE EN61000-4-6, CE EN61000-4-8, CE EN61000-4-11, CE

EN61000-4-12, CE EN61000-6-2, CE EN61000-6-4

Stability Testing

IEC60068-2-32 (Free fall), IEC60068-2-27 (Shock),

IEC60068-2-6 (Vibration)

1.2 Software Features

Management

SNMP v1 v2c, v3/ Web/Telnet/CLI

SNMP MIB

RFC 1215 Traps MIB,

RFC 1213 MIBII,

RFC 1157 SNMP MIB,

RFC 1493 Bridge MIB,

RFC 2674 VLAN MIB,

RFC 1643 EtherLike,

RFC 1757 RMON,

RSTP MIB,

Private MIB,

LLDP MIB

ITU G.8032

Support ITU G.8032 v2 for Ring protection in less than

10ms for self-heal recovery < 256 switches which can be

compatible with other ITU G.8032 metro switches

Support various ring/chain topologies

Ring covers data & multicast* packets

Pro-Ring 2se*

Self-healing recovery in less than 20ms for Single Ring

topology < 50switches

User friendly UI

Auto topology drawing

Topology demo

Auto configuration for G.8032*

Port Trunk with

LACP

LACP Port Trunk: 4 Trunk groups/Maximum 4 trunk

members

Load balancing through LACP to distribute load*

LLDP

Supports LLDP to allow switch to advise its identification

and capability on the LAN

CDP

Cisco Discovery Protocol for topology mapping

PoE

Management

PoE Detection to check if PD is hang up then restart

the PD

PoE Scheduling to On/OFF PD upon routine time

table

VLAN

Port Based VLAN

IEEE 802.1Q Tag VLAN (256 entries)/ VLAN ID (Up to 4K,

VLAN ID can be assigned from 1 to 4096.)

GVRP (256 Groups)*,GMRP*, MVRP (Multi VLAN

Registeration)*, QinQ

IPv6

Support dual stack for IPv4 and IPv6

Support Plug and Play function

IPv6 Logo Committee certified

Perform with following RFCs:

1. RFC 2460 –IPv6 Specification

2. RFC 4861 –Neighbor Discovery for IPv6

3. RFC 4862 –IPv6 Stateless Address Auto-configuration

4. RFC 1981 –Path MTU Discovery for IPv6

Network Security

Support 10 IP addresses that have permission to access

the switch management and to prevent unauthorized

intruder.

802.1X access control for port based and MAC based

authentication/MAC-IP-Port binding

Management access control with priority *

256 Policy based Access Control List*

SSL/ SSH for Management

TACACS+ for Authentication*

SMTP/Text SMS

Supports SMTP Server and 6 e-mail accounts for

receiving event alert; can send SMS text alert via mobile

Spanning Tree

Supports IEEE802.1d Spanning Tree and IEEE802.1w

Rapid Spanning Tree, IEEE802.1s Multiple Spanning Tree

Quality of Service

The quality of service determined by port, Tag and IPv4

Type of service, IPv4 Different Service

Class of Service

Supports IEEE802.1p class of service, per port provides 4

priority queues

IP Security

Supports 10 IP addresses that have permission to access

the switch management and to prevent unauthorized

intruder.

Supports IEEE802.1X Authentication/RADIUS

Port Mirror

Support 3 mirroring types: “RX, TX and Both packet”

IGMP

Support IGMP snooping v1,v2,v3; Supports IGMP static

route

256 multicast groups and IGMP query

Multicast VLAN

Registration*

MVR enables multicast packets go through VLAN for VOD

application

Bandwidth

Control

Support ingress packet filter and egress packet limit.

The egress rate control supports all of packet type.

Ingress filter packet type combination rules are

Broadcast/Multicast/Flooded Unicast packet,

Broadcast/Multicast packet, Broadcast packet only and all

types of packet.

The packet filter rate can be set an accurate value through

the pull-down menu for the ingress packet filter and the

egress packet limit.

RTC

Built-in Real Time Clock to keep track of time always

Flow Control

Supports Flow Control for Full-duplex and Back Pressure

for Half-duplex

System Log

Supports System log record and remote system log server

SMTP

Supports SMTP Server and 6 e-mail accounts for receiving

event alert

Relay Alarm

Provides one relay output for port breakdown, power fail

Alarm Relay current carry ability: 1A @ DC24V

SNMP Trap

1. Topology Change

2. Power Trap

3. MAC-Violation

DHCP

Provides DHCP Client/ DHCP Server/ Port and IP Binding

DNS

Provides DNS client feature and supports Primary and

Secondary DNS server

SNTP

Supports SNTP to synchronize system clock in Internet

Firmware Update

Supports TFTP firmware update, TFTP backup and restore.

Configuration

Upload/Download

Supports text configuration file for system quick installation;

Support factory reset button to restore all settings back to

factory default.

Inhaltsverzeichnis

Andere Lantech Schalten Handbücher

Lantech

Lantech IPES-5208T-X Series Bedienungsanleitung

Lantech

Lantech IPWMR-3006 Bedienungsanleitung

Lantech

Lantech IPGS-0005T-4 Bedienungsanleitung

Lantech

Lantech IPES-0104GT-4 Bedienungsanleitung

Lantech

Lantech IPES/IES-5416T Series Bedienungsanleitung

Lantech

Lantech IES-5216DF Bedienungsanleitung

Lantech

Lantech IPES-5408T-X-IGN Series Bedienungsanleitung

Lantech

Lantech IES-2208CA Bedienungsanleitung

Lantech

Lantech IES-0008B Series Bedienungsanleitung

Lantech

Lantech IPES-0208 Series Bedienungsanleitung

Lantech

Lantech IPES-0008B Series Bedienungsanleitung

Lantech

Lantech mini Switch 800 Bedienungsanleitung

Lantech

Lantech IPES-3424DSFP-2P-PT Bedienungsanleitung

Lantech

Lantech LGS-2424C Bedienungsanleitung

Lantech

Lantech IES-2008B-DNV Bedienungsanleitung

Lantech

Lantech IGS-L5408MGSFPR-AC Bedienungsanleitung

Lantech

Lantech IES-3208C Bedienungsanleitung

Lantech

Lantech IPGS-5 Series Bedienungsanleitung

Lantech

Lantech LGS-2816C-RPS Bedienungsanleitung

Lantech

Lantech LPES-2224C Bedienungsanleitung

Lantech

Lantech IES-0008-M12 Bedienungsanleitung

Lantech

Lantech IPES-3408 Series Bedienungsanleitung

Lantech

Lantech IPES-0204DFT-4 Bedienungsanleitung

Lantech

Lantech IES-2008 Bedienungsanleitung

Beliebte Schalten Handbücher anderer Marken

URC

URC Total Control MFS-8 Bedienungsanleitung

Azbil

Azbil HPQ-D11 Bedienungsanleitung

Sony

Sony DFS-900M Bedienungsanleitung

SICK

SICK i17S Bedienungsanleitung

F&F

F&F SZR-277 Bedienungsanleitung

Shure

Shure UAMS/BK Bedienungsanleitung

Dräger

Dräger X-zone Switch Off Bedienungsanleitung

Asco

Asco Joucomatic 349 Series Bedienungsanleitung

BT Mini Hub Bedienungsanleitung

D-Link

D-Link DES-1226G Bedienungsanleitung

Johnson Controls

Johnson Controls FS80-C Bedienungsanleitung

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Bedienungsanleitung

MicroNet

MicroNet SP1200A Bedienungsanleitung

Ruijie

Ruijie RG-PF2920 Series Installations- und Betriebsanleitung

Altinex

Altinex DA1914SX Bedienungsanleitung

MiLAN

MiLAN MIL-SM2401M Bedienungsanleitung

RJM

RJM MASTERMIND PBC/6X Bedienungsanleitung

Atlas

Atlas MMK-KVM8 Bedienungsanleitung