LeapFrog Busy Learning Bot Montageanleitung
Parent’s Guide
This guide contains important information. Please keep it for future reference.
91-003772-000 UK
Busy Learning Bot
Busy Learning BotBusy Learning Bot
Busy Learning Bot
2
INTRODUCTION
Thank you for purchasing the Busy Learning Bot!
Push, spin, twist, slide, giggle and learn as you play with this
silly, sensory sweetheart!
Spinner
Face
Button
Music
Button
Slider
On/Off/
Volume
Selector
Play
Button
Wheel
Colour
Gears
3
INCLUDED IN THIS PACKAGE
• One Busy Learning Bot
• One parent’s guide
WARNING:
All packing materials such as tape, plastic sheets, packaging
locks, removable tags, cable ties and packaging screws are not
part of this toy and should be discarded for your child’s safety.
NOTE:
Please keep this parent’s guide as it contains important
information.
Unlock the Packaging Locks:
Rotate the packaging locks 90 degrees anticlockwise.
Pull out the packaging locks and discard.
4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the bottom of the unit and use a
screwdriver to loosen the screw and open the battery cover.
3. Remove old batteries by pulling up on one end of each
battery.
4. Install 2 new AAA (AM-4/LR03) batteries following the
diagram inside the battery box. (The use of new alkaline
batteries is recommended for maximum performance).
5. Replace the battery cover and tighten the screw to secure.
5
BATTERY NOTICE
• Use new alkaline batteries or fully charged NI-MH (Nickel
Metal-hydride) rechargeable batteries for best performance.
• Use only batteries of the same or equivalent type as
recommended.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging
(if removable).
• Rechargeable batteries are only to be charged under adult
supervision.
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates
they must not be disposed of in domestic waste as
they contain substances that can be damaging to the
environment and human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicate that the battery contains more than the
specified value of mercury (Hg), cadmium (Cd) or lead
(Pb) set out in Battery Directive (2006/66/EC). The
solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product or
batteries responsibly.
For more information, please visit:
www.recycle-more.co.uk
www.recyclenow.com
6
PRODUCT FEATURES
1. On/Off/Volume Selector
To turn the unit On, slide the On/Off/
Volume Selector to the Low or High
volume setting.
2. Spinner
Twist to hear the ABC song and to count
from one to five. Twist again to hear Busy
Learning Bot make silly pretend voices.
3. Face Button
Press to hear silly and sweet responses
from Busy Learning Bot.
4. Music Button
Press to hear the ABC song, the musical
scale and three fun dance tracks.
5. Play Button
Press to receive silly requests from Busy
Learning Bot. He may ask you to count,
play or even dance with him!
7
6. Slider
Slide back and forth to hear cool
sounds and to learn opposites and other
vocabulary words.
7. Colour Gears
Spin to hear colour and number phrases,
the musical scale and even DJ dance
sounds.
8. Wheels
Develop motor skills by pushing Busy
Learning Bot and watching him roll.
NOTE:
This product is in Try-Me mode in the packaging. After opening
the package, turn the Busy Learning Bot off and on again to
proceed with normal play. If the unit repeatedly powers down
while playing, please install a new set of batteries.
8
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct
heat sources.
3. Remove the batteries when the unit will not be not in use
for an extended period of time.
4. Do not drop the unit on hard surfaces and do not expose
the unit to water or moisture.
TROUBLESHOOTING
If for some reason the unit stops working, please follow these
steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace
the batteries.
4. Turn the unit back On. The unit should now be ready to use
again.
5. If the unit still does not work, install a new set of batteries.
Environmental Phenomena
The unit may malfunction if subjected to radio-frequency
interference. It should revert to normal operation when the
interference stops. If not, it may become necessary to turn the
power Off and back On, or remove and reinstall the batteries.
In the unlikely event of an electrostatic discharge, the unit may
malfunction and lose memory, requiring the user to reset the
device by removing and reinstalling the batteries.
9
10
CONSUMER SERVICES
Creating and developing LeapFrog®products is
accompanied by a responsibility that we at LeapFrog®take
very seriously. We make every effort to ensure the accuracy
of the information, which forms the value of our products.
However, errors sometimes can occur. It is important for you
to know that we stand behind our products and encourage
you to call our Consumer Services Department with any
problems and/or suggestions that you might have. A service
representative will be happy to help you.
UK Customers:
Phone: 01702 200244 (from UK) or +44 1702 200244 (outside UK)
Website: www.leapfrog.co.uk/support
Australian Customers:
Phone: 1800 862 155
Website: support.leapfrog.com.au
NZ Customers:
Phone: 0800 400 785
Website: support.leapfrog.com.au
PRODUCT WARRANTY/
CONSUMER GUARANTEES
UK Customers:
Read our complete warranty policy online at leapfrog.com/warranty.
Australian Customers:
VTECH ELECTRONICS (AUSTRALIA) PTY LIMITED –
CONSUMER GUARANTEES
Under the Australian Consumer Law, a number of consumer
guarantees apply to goods and services supplied by VTech
Electronics (Australia) Pty Limited. Please refer to
leapfrog.com/en-au/legal/warranty for further information.
Inhaltsverzeichnis
Andere LeapFrog Spielzeug Handbücher
LeapFrog
LeapFrog 605-11835-A Bedienungsanleitung
LeapFrog
LeapFrog Ironing Time Learning Set Bedienungsanleitung
LeapFrog
LeapFrog Baby Counting Pal Bedienungsanleitung
LeapFrog
LeapFrog Scribble & Write Bedienungsanleitung
LeapFrog
LeapFrog Tad's Get Ready for School Book Montageanleitung
LeapFrog
LeapFrog Step & Learn Scout Montageanleitung
LeapFrog
LeapFrog Farm Mash-Up Bedienungsanleitung
LeapFrog
LeapFrog Lettersavrus Bedienungsanleitung
LeapFrog
LeapFrog Learn&Groove Caterpillar Drums 6102 Montageanleitung
LeapFrog
LeapFrog leapland Adventures Bedienungsanleitung
LeapFrog
LeapFrog LeapBuilders ABC Smart House Montageanleitung
LeapFrog
LeapFrog AlphaPup Bedienungsanleitung
LeapFrog
LeapFrog Letter Band Phonics Jam Montageanleitung
LeapFrog
LeapFrog Water & Count Veggie Garden Montageanleitung
LeapFrog
LeapFrog 100 Words About Places I Go Montageanleitung
LeapFrog
LeapFrog Alphanet Pal Bedienungsanleitung
LeapFrog
LeapFrog Learn & Groove Music Wand Bedienungsanleitung
LeapFrog
LeapFrog Twist & Shout Bedienungsanleitung
LeapFrog
LeapFrog Nicklodeon Blue's Clues & You! Tickety Tock Play & Learn... Montageanleitung
LeapFrog
LeapFrog 100 Words About Places I Go Montageanleitung
