LEGRAND 2U Bedienungsanleitung

2U Rackmount Rail Slider

Rail Slider for 2U Components

Instruction Sheet

I-00888 Rev A

•Heed all warnings.

•Follow all instructions.

•

Respectez tous les

avertissements.

•Suivez toutes les instructions.

•

Nettoyer uniquement avec un chiffon sec.

•N'utilisez que des accessoires spécifiés par le

fabricant.

Important Safety Instructions

WARNING: A warning alerts you to a situation that could result in serious personal injury or death.

WARNING: Middle Atlantic Products, Inc. electrical systems conform to and should be properly

grounded in compliance with requirements of the current National Electrical Code or codes administered by

local authorities.

All electrical products may present a possible shock or fire hazard if improperly installed or used. Middle

Atlantic Products, Inc. electrical products may bear the mark of a Nationally Recognized Testing Laboratory

(NRTL) and should be installed in conformance with current local and/or the National Electrical Code.

WARNING: Failure to read, understand and follow the following information can result in serious

personal injury, damage to the equipment or voiding of the warranty. It is the responsibility of the

Installer/User to ensure that this product is loaded according to specifications.

Instructions importantes sur la sécurité

AVERTISSEMENT: Un avertissement vous avertit d'une situation pouvant entraîner des blessures

graves ou la mort.

AVERTISSEMENT: Middle Atlantic Products, Inc. électrique systèmes conformes à devraient être

mis à la terre dans conformité avec les exigences de la National actuelle ou comme les codes électrique

administré par les autorités locales autorités.

Tous les produits électriques peuvent présenter un choc ou un incendie danger si elle est mal installé ou

utilisé. Middle Atlantic Products, Inc. produits électriques peuvent porter la marque d'un Nationally

Recognized Testing Laboratory (NRTL) et doit être installé en conformité avec courant local et/ou le National

Electrical Code.

AVERTISSEMENT: Refus de lire, comprendre et suivre la renseignements suivants peut traduire par

de graves blessures, des dommages à l'équipement ou invalider la garantie. Il est la responsabilité de

l'installateur / utilisateur de s'assurer que ce produit est chargé conformément aux spécifications.

•

Read these instructions.

•Keep these instructions.

•

Clean only with dry cloth.

•Only use attachments/accessories specified by the

manufacturer.

•

Lire ces instructions.

•Conservez ces

instructions.

Introduction

NOTE: Before installation, please inspect the contents. Be sure that nothing inside the package is damaged.

Please keep the original package in a safe place for future use.

Unpacking and Inspection

Unpack your products and inspect the contents. The contents should include the following supplied

components and hardware.

(4x) Fixing Stud

Left and Right Rail Slider

(12x) M6 Rack

Screws

(6x) M6 Cage Nut

Installing the Mounting Brackets

CAUTION: Do not use the mounting brackets to lift the unit. Use the mounting brackets only for

securing the unit to the rack.

ATTENTION: N'utilisez pas les supports de montage pour soulever l'appareil. Utilisez les supports de

montage uniquement pour fixer l'unité au rack.

Step 1

Use mounting brackets and screws (provided in UPS packaging) to assemble the ears onto the sides of your

UPS as shown.

Installing 2U Rail Sliders Using Cage Nuts and Screws

Step 1

Firmly insert fixing studs (A) on top set of holes on the rail sliders (B) as shown. Pull apart the ends of the rail

sliders (B) to meet the depth of the rack chassis and force fixing studs (A) into the corresponding holes on

the rack chassis columns. The rail sliders align with the inside of the rack chassis columns.

FRONT

REAR

Step 2

Use (4x) M6 rack screws (C) through the lower set of holes on the rail sliders (B) and into the rack chassis

columns as shown.

Step 3

Use (6x) cage nuts (D) in the proper location on the rack chassis columns based on your UPS height as

shown.

Step 4

Place your UPS (with the mounting brackets already assembled) onto the rail sliders (B) as shown.

Step 5

Use (4x) rack screws (C) through the mounting brackets, front rack chassis columns, and into the cage nuts

(D) as shown.

Mounting

Brackets

Installing 2U Rail Sliders Using Rack Screws

Step 1

Pull apart the ends of the rail sliders (B) so they align with the outside of the rack chassis columns.

Step 2

Use (8x) M6 rack screws (C) through the holes on the rail sliders (B) and into the rack chassis columns as

shown.

Step 3

Place your UPS (with the mounting brackets already assembled) onto the rail sliders (B) as shown.

Step 4

Use (4x) rack screws (C) through the mounting brackets and into the front rack chassis columns as shown.

Mounting

Brackets

Inhaltsverzeichnis

Andere LEGRAND Rack & Stand Handbücher

LEGRAND

LEGRAND CHIEF CMS440N Bedienungsanleitung

LEGRAND

LEGRAND CHIEF PSMHO2089 Bedienungsanleitung

LEGRAND

LEGRAND SANUS ACCENTS ALT2 Bedienungsanleitung

LEGRAND

LEGRAND Ekinoxe 329 10 Bedienungsanleitung

LEGRAND

LEGRAND CHIEF HTSTS Bedienungsanleitung

LEGRAND

LEGRAND CHIEF Fusion FCALRB1 Bedienungsanleitung

LEGRAND

LEGRAND CHIEF TILD1 XNE1 Series Bedienungsanleitung

LEGRAND

LEGRAND CHIEF ODA330 Bedienungsanleitung

LEGRAND

LEGRAND Sanus WSWME31 Bedienungsanleitung

LEGRAND

LEGRAND SANUS WSWME11-W2 Bedienungsanleitung

LEGRAND

LEGRAND SANUS VSTV2-B2 Bedienungsanleitung

LEGRAND

LEGRAND SANUS VDLF28 Bedienungsanleitung

LEGRAND

LEGRAND Chief FCA850 Bedienungsanleitung

LEGRAND

LEGRAND CHIEF FCS1U Bedienungsanleitung

LEGRAND

LEGRAND CHIEF CSPS Bedienungsanleitung

LEGRAND

LEGRAND CHIEF Fusion FCA812 Bedienungsanleitung

LEGRAND

LEGRAND bticino MyHOME 3487AP Bedienungsanleitung

LEGRAND

LEGRAND PX2 Bedienungsanleitung

LEGRAND

LEGRAND SANUS WSBWM1-B2 Bedienungsanleitung

LEGRAND

LEGRAND SANUS WSSE1A1 Bedienungsanleitung

LEGRAND

LEGRAND CHIEF PRSU Bedienungsanleitung

LEGRAND

LEGRAND Sanus VDMF20 Bedienungsanleitung

LEGRAND

LEGRAND CHIEF Koncis DMA1 Bedienungsanleitung

LEGRAND

LEGRAND CP330017 Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung