LEGRAND CHIEF Koncis DMA1 Bedienungsanleitung

Quick Setup Guide

For complete installation instructions, refer to the

Installation Manual included with this product.

This Quick Setup Guide is meant to provide only an overview

of the various installation steps.

ALWAYS read the Installation Instructions in its entirety before

beginning the Installation.

DMA

DMA

desk

Option A

Step 1: Clamp Base to Desk Edge Option

Loosen clamp screw on base, place on desk

and tighten.

Reattach removed piece of clamp and

screws and tighten clamp screw.

8800-003249, Rev00 10/2020

Option B

Step 1: Clamp Base through Grommet Hole Option

Remove lower piece of clamp from assembly by removing two

button head cap screws and install remaining part of clamp

through grommet hole.

DMA1 Single Monitor Arm

DMA2 Dual Monitor Arm

Tools Required for Installation

Parts

5/32” (included)

A (1)

[Arm assembly]

(DMA1 shown)

B (1)

[Base assembly]

(DMA1 shown)

H (1)

5/32”

D (4/8)*

M4 x 20mm

E (4/8)*

M10 x 5.3 x 10

F (4/8)*

M4 x 4mm

G (12)*

#10-32-3/8

C (4/8)*

M4 x 10mm

DISCLAIMER

Legrand | AV and its ailiated corporations and subsidiaries (collectively “Legrand | AV”), intend

to make this manual accurate and complete. However, Legrand | AV makes no claim that the

information contained herein covers all details, conditions or variations, nor does it provide

for every possible contingency in connection with the installation or use of this product. The

information contained in this document is subject to change without notice or obligation of any

kind. Legrand | AV makes no representation of warranty, expressed or implied, regarding the

information contained herein. Legrand | AV assumes no responsibility for accuracy, completeness

or suiciency of the information contained in this document.

WEIGHT CAPACITY WARNING

Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is

the installer’s responsibility to make sure the combined weight of all components and accessories

attached to the DMA Series Monitor Arm up to (and including) the display is between the weight

ranges listed below. Use with products heavier than the maximum weight indicated may result in

collapse of the mount and its accessories causing possible injury. Use with products lighter than

the minimum weight indicated may result in the mount not functioning properly.

(A)

(B)

Reduce tension

Increase tension

(lighter display)

(heavier display)

Do NOT over-tension

adjustment tension

screw.

(underside)

(H)

quick release lever

Step 2: Add Arms to Base

Place mounting arms (A) onto base assembly pin (B) –

no additional fasteners or tightening needed.

Step 3: Display Installation

Remove quick release faceplate from mount by

pulling lever and sliding faceplate o mount. Connect

faceplate to display using Phillips screwdriver and

hardware from hardware bag (C or D).

Step 4: Arm Tension Adjustment

Adjust arm tension with tension adjustment screw located at

base of dynamic arm, using 5/32” hex key (H).

Step 5: Cable Management

Tuck cables into channels located

on underside of mounting arms.

Step 6: Tool Storage

The adjustment key can be

conveniently stored with the Koncis

Series mount if

desired. Slide 5/32” hex

key (H) into channel located at the back

of the base assembly.

Position display with faceplate

attached above mount, and

slide faceplate onto mounting

head until quick release tab

clicks into place.

Note: See full Installation Manual

for setting rotational stop screw

to prevent arm from rotating more

than 90º.

Note: See full Installation

Manual for allowable

display weight ranges and

additional mounting details.

USA/International A

6436 City West Parkway

Eden Prairie, MN 55344

P800.582.6480 / 952.225.6000

F877.894.6918 / 952.894.6918

Europe A

Franklinstraat 14

6003 DK Weert, Netherlands

P+31 (0) 495 580 852

F+31 (0) 495 580 845

All other brand names or marks are used for identification purposes and are trademarks of their

COMMERCIAL AV BRANDS

INSTALLER INSPIRED | legrandav.com

Asia Pacific A Oice No. 918 on 9/F

Shatin Galleria

18-24 Shan Mei Street

Fotan, Shatin, Hong Kong

P852 2145 4099

F852 2145 4477

8800-003249, Rev00 10/2020

Dieses Handbuch passt für folgende Modelle

Andere LEGRAND Rack & Stand Handbücher

LEGRAND

LEGRAND CHIEF XSD1U Bedienungsanleitung

LEGRAND

LEGRAND Sanus VDSF16 Bedienungsanleitung

LEGRAND

LEGRAND CHIEF HTSTS Bedienungsanleitung

LEGRAND

LEGRAND CHIEF Fusion FCALRB1 Bedienungsanleitung

LEGRAND

LEGRAND SANUS VSTV2-B2 Bedienungsanleitung

LEGRAND

LEGRAND Chief PAC800HS Bedienungsanleitung

LEGRAND

LEGRAND CHIEF IntelliSHOT PAC800E Bedienungsanleitung

LEGRAND

LEGRAND bticino MyHOME 3487AP Bedienungsanleitung

LEGRAND

LEGRAND Chief LFE1U Bedienungsanleitung

LEGRAND

LEGRAND Kenall LOW PROFILE SCONCE LPS Series Bedienungsanleitung

LEGRAND

LEGRAND SANUS VMT5-B2 Bedienungsanleitung

LEGRAND

LEGRAND CHIEF FCAVCU20 Bedienungsanleitung

LEGRAND

LEGRAND Sanus LMF219 Bedienungsanleitung

LEGRAND

LEGRAND SANUS WSBWM1-B2 Bedienungsanleitung

LEGRAND

LEGRAND CHIEF FSB4442 Bedienungsanleitung

LEGRAND

LEGRAND Chief PAC811 Bedienungsanleitung

LEGRAND

LEGRAND CHIEF TILD1 XNE1 Series Bedienungsanleitung

LEGRAND

LEGRAND SANUS ELITE BSWME2 Bedienungsanleitung

LEGRAND

LEGRAND CHIEF PRSU Bedienungsanleitung

LEGRAND

LEGRAND 0 570 18 Bedienungsanleitung

LEGRAND

LEGRAND CHIEF Fusion FCA801 Bedienungsanleitung

LEGRAND

LEGRAND VADDIO 535-2000-280 Bedienungsanleitung

LEGRAND

LEGRAND CHIEF PSMHO2089 Bedienungsanleitung

LEGRAND

LEGRAND CHIEF CSSMP15X10 Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung