LEVENGER STACKABLE LATERAL DRAWER Bedienungsanleitung

STACKABLE LATERAL DRAWER

Taking inventory

Lay everything in front of you. Make sure you have the hardware listed (per

unit). You will need a 1⁄4" socket wrench or pliers and a Phillips screwdriver.

Each Stackable Lateral Drawer holds

26" of letter files in two rows. And you

can stack files two, three or four

drawers high. All cabinets have anti-

tip interlock (allowing only one drawer

to open at a time).

STACKABLE LATERAL DRAWER ASSEMBLY

mini-lock nut

w/base–4

w/unit–4

mini-lock screw

w/top–4

w/unit–4

splicer

bar–1

drawer unit

base

top

mini-lock screws

mini-lock nut

Prepping for the base

Lay the unit on its back

with the drawer handle

facing up. Insert a mini-lock

screw into each of the four

holes in the bottom frame

and tighten ﬁrmly with a

Phillips screwdriver until the

screws touch the shoulder.

Attaching the base

Align the screws with the holes on the ﬁle base and push until fully inserted

and the base is attached.

Insert a mini-lock nut into each of the four holes. Make sure the arrow on

each mini-lock nut faces out and lines up with its mini-lock screw. When fully

inserted, use the screwdriver and turn each mini-lock nut clockwise

approximately 1⁄2 turn, locking it into position. This assembly will now be

referred to as Unit 1.

MINI-LOCK

ASSEMBLY

Unit 1

unit

mini-lock screws

unit

base

Attaching the units

Locate the four holes on the top of

Unit 1. Pick up Unit 2 and set it on

top of Unit 1 with the mini-lock

screws extending into the holes of

Unit 1. Insert a mini-lock nut into

each of the four holes on the inside

of Unit 1. Make sure the arrow on

each mini-lock nut faces out and

lines up with its mini-lock screw.

When fully inserted, use the

screwdriver and turn each mini-lock nut

clockwise approximately 1⁄2turn, locking it

into position.

Unit 1

Unit 2

mini-lock screws

Unit 2

Removing the drawer

Lay Unit 1 on the ﬂoor on its base. Pull the drawer straight out until it will go no

farther. (If the drawer is locked into position and will not open, push down on

the lock bar located inside the unit to the left.) Locate the plastic tab or lever on

each side of the drawer glides. You will use these levers to release the drawer. If

your cabinet has tabs, push in on the tabs on both sides to release the drawer. If

your cabinet has levers, push the lever on the left side up

and the lever on the right side down and hold as you pull

the drawer completely out of the frame. There will be

some resistance, but it should ride smoothly.

lock bar

lever

tab

lever

Prepping Unit 2

The upper section of your file

will be referred to as Unit 2. Lay

Unit 2 on the ﬂoor on its base

and remove the drawer as you

did for Unit 1. Lay the unit’s

frame on its back and insert a

mini-lock screw into each of the

four holes on the bottom.

Attaching the splicers

Find the lock bars located on the left interior of each unit. Make sure all lock bars

are in the up position before attaching the splicer.

Locate and examine the splicer. The splicer allows only one drawer to be opened at

a time. On the back of each splicer bolt are two small protrusions or wings. Loosen

the nuts until they are halfway undone.

Align the splicers with the lock

bars, and be sure the wings start

out in a vertical position.

Align the splicer and its

wings with the slot of the

lock bar. Slide it down so

the center hole in

between the drawers

cannot be seen. Hold

the splicer in place.

Tighten both the upper

and lower nuts with a

1⁄4" socket wrench or

pliers until both clips

disappear, but do not

overtighten. They will not fit

flush with the bars until you

tighten the nuts; the wings will

disappear within the lock bar when they are

fully tightened. (The diagrams below show the two positions; left shows the upper

clip in the unlocked position; right shows the locked position.) Make sure it is snug

and does not slip. Test by moving the lock bar up and down. If the splicer wings do

not disappear, loosen the nuts more and try again. Do not be discouraged if it takes

you a few trials to lock the splicer in place.

splicer

center

hole

black bar

glide

anti-tip

interlock

lock bar

unlocked position

center

hole

splicer

wing

locked position

center

hole

lock bar

Inserting the drawers

Now you are ready to reinsert the drawers.

Align the side rails of the drawer with the

glide of the frame. Carefully insert the

drawer. Make sure not to force the rail into

the glider. There will be resistance, but if

aligned properly, it should be smooth. Test

by pulling the drawer in and out.

Movement should be smooth and even. If

not, carefully remove and reinsert.

Using legal files

To use legal files, you must

remove one of the middle bars.

Files will then reach from one

side to the remaining bar.

Attaching the top

Lay the top on a clean surface with the holes facing up. Insert a mini-lock screw

into each of the four holes and tighten. Turn the top over and align the mini-lock

screws with the corresponding holes of the top unit.

NOTE: Because the top is solid wood, it may bow

in shipment. This is not a defect. Solid wood

naturally expands and contracts due to

moisture in the air. The wood will straighten

once attached to the unit. You may need to

apply pressure on one side at a time as you

secure the mini-lock nuts.

Insert a mini-lock nut into each of the four

holes located inside the top unit. Make

sure the arrow on each mini-lock nut faces

out and lines up with the mini-lock screw.

When fully inserted, turn each mini-lock nut

clockwise approximately 1⁄2turn, locking

it into position.

middle bars

We hope you enjoy your Stackable Lateral Drawer. Email us at

productreview@Levenger.com and tell us how you use it. Questions?

Call us toll-free at 800-545-0242 and we will be happy to assist you.

To place an order, please call 800-544-0880. To join our Preferred

Customer E-list and be the first to see our new merchandise, please

Levenger Distribution Center 3530 E. Raines Road, Suite 101 Memphis, TN 38118

800-545-0242 or 901-375-9318 Fax: 800-544-6910 or 901-375-8346

levenger.com cservice@levenger.com

SPECIAL NOTE ON THE DARKENING

OF NATURAL CHERRY WOOD:

Natural cherry wood will gradually darken with exposure to light. This is a natural

process and enhances the beauty of the wood; however, you should be mindful of uneven

darkening. We recommend you not permanently rest objects on exposed surfaces during

the first two weeks. During this period, an object left in the same place for even a few

days will show a lighter color beneath. After the break-in period you can leave objects

in place since color development will be complete.

NOTE:

For safety purposes, stack no more than 4 units. If more stability is

required, please consult a construction or engineering professional

when anchoring your laterals to walls.

Inhaltsverzeichnis

Andere LEVENGER Inneneinrichtung Handbücher

LEVENGER

LEVENGER STACKABLE FILE CABINETS Bedienungsanleitung

LEVENGER

LEVENGER EURO DESK SYSTEM FD0180 Bedienungsanleitung

LEVENGER

LEVENGER Euro Desk System Bedienerhandbuch

LEVENGER

LEVENGER Stackable Lateral Drawer Bedienungsanleitung

LEVENGER

LEVENGER HOMER Bedienungsanleitung

LEVENGER

LEVENGER MORGAN CHARGER VALET Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

Furinno

Furinno 18089 Bedienungsanleitung

Munchkin

Munchkin Push to Close MK0001 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Anthro

Anthro GT03 Series Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung