Linear DXS-32 Bedienungsanleitung

INSTR,INSTL,DXS-32

LINEAR P/N: 216314 B

MATERIAL: 20 LB. MEAD BOND

SIZE: 8.500" X 11.000"

INK: BLACK

SCALE: 1-1

SIDE 1 OF 2

DXS-32

MINIATURE

SUPERVISED

DOOR/WINDOW

TRANSMITTER

Installation Instructions

PRODUCT DESCRIPTION

The DXS-32 is a battery powered stationary transmitter designed for use with Linear’s DXS and DX

format receivers. This transmitter can be used in a variety of wireless remote control applications.

Triggering the transmitter with its built-in magnetic switch sends a digitally coded wireless signal to

its companion receiver.

The digital DXS code format features over a million possible codes. The DXS transmitters are

precoded at the factory to unique codes, so no field coding is required. The DXS-32 can send four

different codes: alarm, restore, low battery and status.

Receivers must be programmed to the transmitter’s code before system testing and operation. Refer

to the receiver’s instructions for details on programming.

In a typical installation, the magnet is mounted on a door or window and the transmitter is mounted

on the frame. When the magnet moves more than 1/2" away from the transmitter, an alarm signal is

sent. When the magnet returns next to the unit, a restore signal is sent. The magnet is adjustable

with four height positions. A 1/4" high magnet spacer is also supplied to snap on to the base of the

magnet.

The transmitter is powered from two 3-Volt #2032 lithium batteries with an expected battery life of

up to 4 years. Every hour, the DXS-32 will send a status transmission to the receiver. The hourly

signal updates the receiver to the transmitter’s condition. By monitoring status transmissions, the

receiver can determine if a transmitter has a low battery or has been removed from the system. DXS

format receivers can monitor status signals, DX format receivers cannot.

Normally, the transmitter sends an exit/entry delay transmission code. Cutting an internal jumper

selects an instant transmission code. Cutting this jumper doesn’t change the time of the actual

transmissions, but changes the code of the signal sent so the receiver can determine the transmitter’s

function.

(760) 438-7000 • FAX (760) 438-7043

USA & Canada (800) 421-1587 & (800) 392-0123

Toll Free FAX (800) 468-1340

www.linearcorp.com

DXS-32 FEATURES & ACCESSORIES OPENING CASE

REMOVE BATTERY PROTECTION STRIP COMPONENT LOCATIONS

MAGNET

SCREWS AND

DOUBLE STICK TAPE

ADJUSTABLE

MAGNET

SQUEEZE MAGNET TABS TO

ADJUST MAGNET HEIGHT (4 POSITIONS)

MAGNET

ADJUSTMENT

TAB (EACH SIDE)

TRANSMITTER

SCREWS AND

DOUBLE STICK TAPE

MAGNET CAN BE MOUNTED UP TO

1/2" FROM LEFT SIDE OF

TRANSMITTER

MAGNET

SIDE

MARK

TRANSMITTER

MAGNET

ALIGNMENT

MARKS

MAGNET

ALIGNMENT

MARKS

REMOVE THE CASE TOP BY TWISTING A

SMALL FLAT BLADE SCREWDRIVER IN

THE SLOT ON EITHER END OF THE TRANSMITTER

TWIST

PULL OUT & DISCARD

BATTERY PROTECTION

STRIP TO ACTIVATE

TRANSMITTER

TWO TYPE 2032

BATTERIES

ANTENNA

DELAY/INSTANT JUMPER

(CUT JUMPER FOR INSTANT)

INSTR,INSTL,DXS-32

LINEAR P/N: 216314 B

MATERIAL: 20 LB. MEAD BOND

SIZE: 8.500" X 11.000"

INK: BLACK

SCALE: 1-1

SIDE 2 OF 2

EXAMPLE INSTALLATIONS TRANSMITTER MOUNTING

ADJUSTING MAGNET HEIGHT PROGRAMMING RECEIVER

CHANGING BATTERIES LINEAR LIMITED WARRANTY

This Linear product is warranted against defects in material and workmanship for twelve (12) months. The Warranty

Expiration Date is labeled on the product. This warranty extends only to wholesale customers who buy direct

from Linear or through Linear’s normal distribution channels. Linear does not warrant this product to

consumers. Consumers should inquire from their selling dealer as to the nature of the dealer’s warranty, if any.

There are no obligations or liabilities on the part of Linear corporation for consequential damages arising out

of or in connection with use or performance of this product or other indirect damages with respect to loss of

property, revenue, or profit, or cost of removal, installation, or reinstallation. All implied warranties, including

implied warranties for merchantability and implied warranties for fitness, are valid only until Warranty Expiration Date

as labeled on the product. This Linear Corporation Warranty is in lieu of all other warranties express or implied.

All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Linear

Technical Services at 1-800-421-1587 for an RPA# and other important details.

FCC NOTE:

This device complies with FCC Part 15 and IC Canada Rules and Regulations. Operation is subject the following

two conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference

received, including interference that may cause undesired operation.

IMPORTANT !!!

Linear radio controls provide a reliable communications link and fill an important need in portable wireless

signalling. However, there are some limitations which must be observed.

✶

For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15

devices. As such, they have limited transmitter power and therefore limited range.

✶

A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio

signals that occur on or near their operating frequencies, regardless of code settings.

✶

Changes or modifications to the device may void FCC compliance.

✶

Infrequently used radio links should be tested regularly to protect against undetected interference or fault.

✶

A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or

dealer, and these facts should be communicated to the ultimate users.

TRANSMITTER

MOUNTED ON

DOOR JAMB

(NOTE: SMALL END

OF TRANSMITTER UP)

(NOTE: SMALL END

OF TRANSMITTER DOWN)

MAGNET

MOUNTED

ON DOOR

MAGNET MOUNTED

ON DOOR

TRANSMITTER

MOUNTED ON

WINDOW SILL

MAGNET MOUNTED

ON WINDOW FRAME

SLIDING WINDOW

LEFT OPENING DOOR

RIGHT OPENING DOOR

TRANSMITTER

MOUNTED ON

DOOR JAMB

TRANSMITTER

MOUNTED ON

WINDOW FRAME

MAGNET

MOUNTED

ON WINDOW

SASH STILE

DOUBLE-HUNG WINDOW

ATTACH BOTTOM CASE

USING THE SCREWS OR

DOUBLE-STICK TAPE PROVIDED

NOTE: ATTACHING THE TRANSMITTER WITH DOUBLE-STICK

TAPE IS NOT ALLOWED IN UL INSTALLATIONS

ADJUST MAGNET

HEIGHT UNTIL

CASE LEVELS

ARE ABOUT EQUAL

TRANSMITTER

MAGNET

THE SNAP-ON MAGNET SPACER

CAN BE USED TO ADD 1/4" HEIGHT

TO THE MAGNET (SPACERS CAN ALSO

BE SNAPPED TOGETHER FOR MORE LIFT)

PROGRAMMING:

1. PLACE RECEIVER INTO PROGRAM

OR "LEARNING" MODE

2. ACTIVATE TRANSMITTER BY

OPENING DOOR OR WINDOW

3. VERIFY THAT THE RECEIVER

ACCEPTED THE SIGNAL

TESTING:

1. PLACE RECEIVER INTO TEST MODE

2. OPEN DOOR, VERIFY THAT THE

RECEIVER INDICATES AN OPEN DOOR

3. CLOSE DOOR, VERIFY THAT THE

RECEIVER RECOGNIZED THAT THE

DOOR IS CLOSED

OPEN

DOOR

SLIDE OLD BATTERIES

OUT OF BATTERY

HOLDERS

3 4

DISCARD OLD

BATTERIES

PROPERLY

INSERT TWO DURACELL DL2032

BATTERIES

PLUS (+) SIDE UP

INTO BATTERY HOLDERS

SEAT BATTERIES COMPLETELY

INTO HOLDERS

BE SURE BATTERIES ARE

NOT TOUCHING EACH

OTHER

Inhaltsverzeichnis

Andere Linear Sender Handbücher

Linear

Linear AT71-250 Bedienungsanleitung

Linear

Linear DXT-21/EC Bedienungsanleitung

Linear

Linear 1094 Bedienungsanleitung

Linear

Linear Supervised Emergency Alarm Transmitter... Bedienungsanleitung

Linear

Linear MULTI-CODE 3083 Bedienungsanleitung

Linear

Linear Mini-Code 3083 Bedienungsanleitung

Linear

Linear ADVANCED AT7200 Bedienungsanleitung

Linear

Linear DIGITAL TRANSMITTER GT-30 Bedienungsanleitung

Linear

Linear 3022 Bedienungsanleitung

Linear

Linear MegaCode ACT-21 Bedienungsanleitung

Linear

Linear Multi-Code 3022 Bedienungsanleitung

Linear

Linear miniTransmitter Delta-3 Series Administratorhandbuch

Linear

Linear DT-2A Administratorhandbuch

Linear

Linear XT-1H Bedienungsanleitung

Linear

Linear Multi-Code MCS1082 Bedienungsanleitung

Linear

Linear MDTK Bedienungsanleitung

Linear

Linear DXS-64 Bedienungsanleitung

Linear

Linear DXS-31 Bedienungsanleitung

Linear

Linear DX DXT-41 Bedienungsanleitung

Linear

Linear DOOR/WINDOW TRANSMITTER DXT-31 Bedienungsanleitung

Linear

Linear LINEARCOM3000 Bedienungsanleitung

Linear

Linear DXT-61/EC Bedienungsanleitung

Linear

Linear DXS-32/EC Bedienungsanleitung

Linear

Linear D-22D Administratorhandbuch

Beliebte Sender Handbücher anderer Marken

NIVELCO

NIVELCO EasyTREK SCA-300 Series Betriebsanleitung

Honeywell

Honeywell 5816WMBR Bedienungsanleitung

Kamstrup

Kamstrup READy MTU Betriebsanleitung

Omega

Omega ZW Series Bedienungsanleitung

ABB

ABB Field 264H Leitfaden

Alinco

Alinco DJ-V17T Bedienungsanleitung

Dejero

Dejero EnGo 3x Bedienungsanleitung

Rosemount

Rosemount 4600 Bedienungsanleitung

Speaka Professional

Speaka Professional 2342740 Bedienungsanleitung

trubomat

trubomat GAB 1000 Bedienungsanleitung

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Bedienungsanleitung

Rondish

Rondish UT-11 Bedienungsanleitung

MG 10JRE Bedienungsanleitung

Burkert

Burkert 8177 Bedienungsanleitung

Firetide

Firetide HotPort 3203 Handbuch

Tele Radio

Tele Radio T9-02 Bedienungsanleitung

Rotronic

Rotronic HygroFlex HF3 Series Bedienungsanleitung

Jamara

Jamara FCX6 Pro Tel Bedienungsanleitung