LinkPoint 9000 Montageanleitung

LinkPoint 9000 Tips

The LinkPoint 9000 uses a rechargeable nickel cadmium battery as its main

power source. Please note that a new nickel cadmium battery’s full performance

is achieved only after two complete charge and discharge cycles. After you

charge a battery for the first time, please use that battery completely before

recharging it. Then, use the battery completely before recharging it again. For

maximum performance, please continue to use battery fully before recharging in

the future.

To charge the LinkPoint 9000 battery:

1. Unpack the charging dock and place on a table or

counter top as shown in Figure 1.

Figure 1

2. Plug the adapter pin into the back of the unit as shown

in Figure 2. Plug the adapter cord into either a surge

protector or a wall power outlet.

Figure 2 Figure 3

3. Charge the battery by either:

♦Placing the battery into the small charger slot on the

base as shown in Figure 4 (when battery is charged,

press the eject button to release battery); or

♦Turn the terminal over and slide the uncharged battery

into the terminal. Snap the battery into place as shown

in Figure 5.

♦Place the terminal on the large charger slot as shown in

Figure 6. Make sure terminal power is off or the unit will

not charge. Never operate terminal while it is on

charging dock, because it will shorten battery life!

Figure 4

Figure 5 Figure 6

4. No matter which method you choose, charge the battery

until the appropriate charge indicator light turns green

as shown in Figure 7.

Figure 7

Eject

Button

LinkPoint 9000 Tips

To Load Paper:

1. Open the paper cover by holding the paper cover tabs

and pulling them up towards you.

Figure 8

2. Drop in the paper roll. Note that the paper should rest

on top of the serrated tear bar as shown in Figure 10.

Figure 9 Figure 10

3. Close the paper cover until it snaps shut and tear off

any excess paper as shown in Figures 11 and 12.

Figure 11 Figure 12

4. Turn terminal on to test that paper roll was inserted

properly by pressing the [ON/OFF] button as shown in

Figure 13. When terminal is turned on you should hear

a beep and see the “SWIPE CARD” display. Once you

see the display, press the [FORM FEED] button and if a

blank portion of paper advances, it was loaded correctly.

Never operate terminal while it is on charging dock,

because it will shorten battery life!

Figure 13

Note: Thermal paper quality has a direct impact on the performance of thermal printers. The

LinkPoint 9000 has a thermal printer built into the unit. For best results, LinkPoint International

strongly recommends the use of Appleton 1012 or equivalent grade paper.

On/Off

Button

Form Feed

Button

Inhaltsverzeichnis

Andere LinkPoint Zahlungsterminal Handbücher

LinkPoint

LinkPoint AIO Bedienungsanleitung

LinkPoint

LinkPoint AIO Bedienungsanleitung

LinkPoint

LinkPoint 3000 Referenzhandbuch

LinkPoint

LinkPoint 9100 Bedienungs- und Wartungsanleitung

LinkPoint

LinkPoint 3000 Referenzhandbuch

LinkPoint

LinkPoint L3FRR30 Referenzhandbuch

LinkPoint

LinkPoint 3000 Bedienungsanleitung

LinkPoint

LinkPoint AIO Bedienungsanleitung

LinkPoint

LinkPoint 3000/AIO Bedienungsanleitung

LinkPoint

LinkPoint 3000 Bedienungsanleitung

LinkPoint

LinkPoint AIO Bedienungsanleitung

Beliebte Zahlungsterminal Handbücher anderer Marken

PAX

PAX D180SRF Bedienungsanleitung

Moneris

Moneris hispeed 6200 Bedienungsanleitung

Moneris

Moneris iWL220 Bedienungsanleitung

Ingenico

Ingenico iUC280 Bedienungsanleitung

Ingenico

Ingenico Tetra Move/5000 Bedienungsanleitung

Ingenico

Ingenico iWL250B Bedienungsanleitung

Optimum

Optimum M4230 Bedienungsanleitung

Triton

Triton RL5000 Bedienungsanleitung

Ingenico group

Ingenico group Lane/8000 Bedienungsanleitung

Gilbarco

Gilbarco FlexPay IV CRIND Installations- und Betriebshandbuch

Infinite Peripherals

Infinite Peripherals Infinea Tab Lite Bedienungsanleitung

PAX

PAX S920 Bedienungsanleitung

Ingenico

Ingenico iCT220, iCT250 Bedienungsanleitung

dejavoo

dejavoo Z Series Bedienungsanleitung

VeriFone

VeriFone VX 520 Series Bedienungsanleitung

Optomany

Optomany axept S900 Bedienungsanleitung

Skyzer

Skyzer iWL252 BLUETOOTH Bedienungsanleitung

Moneris

Moneris iWL220 Bedienungsanleitung