Lippert Components Happijac Bedienungsanleitung

Rev: 07.15.19 Page 1 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

Purpose

The purpose of this document is to provide instructions on:

• the installation of support legs (Fig. 1) on the sofa unit attached to the HappiJac Bedlift.

• the removal and installation of the HappiJac Bedlift support brackets (Fig. 2).

Fig. 1

Resources Required

• Cordless or electric drill or screw gun

• Appropriate drive bit

• Non-permanent marking method

• Sharp cutting instrument

• 1 ¼" self-tapping screws

Fig. 2

Rev: 07.15.19 Page 2 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

Support Leg Installation

1. Remove the sofa unit from the HappiJac Bedlift and lay it flat face-down in a clean area.

2. The support legs can be adjusted, if needed. The 14-inch legs are normally are installed on the seat

cushion and the backrest uses the 15-inch. The legs can be adjusted by removing the two nuts and bolts

(Fig. 3A) and sliding the bottom part of the leg (Fig. 3B) in or out. Replace nuts and bolts after adjustment.

3. Measure about 12 inches from the outside edge of the cushion portion of the unit (Fig. 4). Feel for

strapping under the fabric and make a small mark between two straps that is close to both the 12-inch

measurement and to the inside edge of the steel frame. Repeat for the other side.

Fig. 4

12"

4. Fold one of the cushion support legs flat by pressing the adjustment button (Fig. 5A) and moving the

leg to one of the side holes (Fig. 5B) in the bracket.

5. Place the tab on the bracket end of the leg (Fig. 5C) on the measurement mark (step 3) with the leg

pointing towards center.

12"

inside edge

of frame

Seatback

Cushion

Fig. 3

Fig. 5

Rev: 07.15.19 Page 3 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

6. Repeat steps 4 and 5 on the other side and make sure the end of the legs do not overlap one over the other.

7. Keeping the brackets in the same position, press the adjustment button (Fig. 5A) and rotate one of the

legs to make sure it does not stick out beyond the seat cushion hinge when in the stored position. Repeat

for the other leg.

8. Make a small cut into the fabric, just beyond the inside edge the frame. The hole should be large

enough to accommodate the bracket tab (Fig. 5C). Slide the tab into the cut slot so that support leg

bracket is upright and the arms of the bracket (Fig. 6A) are resting on the seat frame.

Fig. 6

9. Secure the bracket to the frame with two 1 1/4" self-tapping screws.

10. Repeat steps 8 and 9 for the other cushion leg.

11. Find a centerpoint on the seatback between the two cushion leg brackets (Fig. 7A). Make a mark at that

point that is between the straps under the fabric and is close to the inside edge of the frame.

Seatback

inside edge

of frame

Fig. 7

cushion leg

brackets

Rev: 07.15.19 Page 4 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

Fig. 8

12. Make a small cut into the fabric, just beyond the inside edge the frame. The hole should be large

enough to accommodate the bracket tab. Slide the tab into the cut slot so that support leg bracket is

upright and the arms of the bracket are resting on the seat frame.

13. Secure the bracket to the frame with two 1 1/4" self-tapping screws.

14. Fold all three legs down and reinstall the sofa on the HappiJac support brackets.

15. After the sofa is installed, lower the sofa until it is stopped by the microswitch. Make sure the legs gently

rest on the floor. Adjust the legs, if necessary.

Support Bracket Removal

1. Remove the sofa/dinette configuration or bed platform from the support brackets.

2. Remove the locking pin (Fig. 8A) from the bracket, then lower the bracket arm (Fig. 8B).

Rev: 07.15.19 Page 5 CCD-0002704

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

3. Remove the stop screw (Fig. 9A) from securing the support bracket, then remove the screw (Fig. 9B)

securing the trolley stop lock bracket (Fig. 9C) and remove the bracket. Set screws aside for later use.

4. Grasp the base of the sofa bracket (Fig. 10A) and pull up until the hooks are even with travel trolley

slots (Fig. 10B), then pull the sofa bracket away from the travel trolley.

5. Repeat for other brackets, if necessary.

Support Bracket Installation

1. Line up the hooks (Fig. 11A) on the end edge of the support bracket with the slots in the lower trolley

(Fig. 11B) then insert the bracket in to the trolley slots.

Fig. 10

Fig. 9

Fig. 11

Rev: 07.15.19 Page 6 CCD-0002704

As a supplier of components to the RV industry, safety, education and customer satisfaction are our primary concerns. Should you

have any questions, please do not hesitate to contact us at (574) 537-8900 or by email at [email protected]. Self-help tips,

technical documents, product videos and a training class schedule are available at lci1.com or by downloading the MyLCI app.

HAPPIJAC®BED LIFT SUPPORT LEG AND BRACKET INSTALLATION

TI-322

POWER AND MOTION

2. Pull down on the bracket to secure it in the trolley.

3. Line up the holes in the trolley stop lock bracket (Fig. 12A) with the top two holes in the lower trolley

(Fig. 12B). Secure the trolley stop lock bracket with the previously removed screw (Fig. 12C).

4. Secure the support bracket with the previously removed stop screw (Fig. 12D).

5. Repeat steps 2-4 for other support brackets, if necessary.

Fig. 12

Andere Handbücher für Happijac

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Lippert Components Autozubehör Handbücher

Lippert Components

Lippert Components Sliding Swivel Seat Base Bedienungsanleitung

Lippert Components

Lippert Components Solera Bedienungsanleitung

Lippert Components

Lippert Components ground control 3.0 Bedienungsanleitung

Lippert Components

Lippert Components X-Trek Bedienungsanleitung

Lippert Components

Lippert Components Curt Rota-Flex Pin Box Bedienungsanleitung

Lippert Components

Lippert Components SolidStep XF Bedienungsanleitung

Lippert Components

Lippert Components SolidStep XF Bedienungsanleitung

Lippert Components

Lippert Components Innolight Sliding Montageanleitung

Lippert Components

Lippert Components In-Wall Slide-Out Bedienungsanleitung

Lippert Components

Lippert Components Edge Bedienungsanleitung

Lippert Components

Lippert Components Ground Control 3.0 Landing Gear Bedienungsanleitung

Lippert Components

Lippert Components Solera Power Awning Gebrauchs- und Pflegehandbuch

Lippert Components

Lippert Components Kwikee Revolution Step Series Bedienungsanleitung

Lippert Components

Lippert Components Solera Classic Montageanleitung

Lippert Components

Lippert Components COACH STEP Einrichtungshandbuch

Lippert Components

Lippert Components Solera Slide Topper Bedienungsanleitung

Lippert Components

Lippert Components Tire Linc Bedienungsanleitung

Lippert Components

Lippert Components Alumi-Tread series Bedienungsanleitung

Lippert Components

Lippert Components ground control 3.0 Leitfaden

Lippert Components

Lippert Components SolidStep Montageanleitung

Lippert Components

Lippert Components Jack-It Bedienungsanleitung

Lippert Components

Lippert Components Solera Montageanleitung

Lippert Components

Lippert Components Ground Control 2.0 Bedienungsanleitung

Lippert Components

Lippert Components 432223 Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Renault

Renault 77 11 423 180 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung