MacDon R85 Bedienungsanleitung
The harvesting specialists.
R85
16-Foot Rotary Disc Pull-Type Mower
Conditioner
Operator’s Manual
169456_SUPPLEMENT Revision D
Original Instruction
Purpose of Supplement
After your operator’s manual was printed, a decal was added to the R85 mower conditioner hitch to alert the Operator
that the transport lock pin must be in place before transport.
Replace the following pages of the R85 Operator’s Manual, MD #169456 Revision D, with the pages provided in this
supplement:
• Safety Decal Location - pages 9–12
• Understanding Safety Signs - pages 13–19
• Preparing Mower Conditioner for Transport - pages 74–75
1Safety
1.1 Safety Decal Locations
Figure 1.1
A - MD #194466 (2 Places) B - MD #194463 (2 Places) C - MD #194465 (2 Places) D - MD #166466
E - MD #113482 F - MD #184385 G - MD #184371
Figure 1.2: Safety Decals
169456_SUPPLEMENT 1Revision D
SAFETY
1.2 Understanding Safety Signs
MD #113482
General hazard pertaining to machine operation
and servicing
CAUTION
To avoid injury or death from improper or unsafe
machine operation:
• Read the operator’s manual and follow all safety
instructions. If you do not have a manual, obtain one
from your Dealer.
• Do not allow untrained persons to operate the machine.
• Review safety instructions with all Operators every year.
• Ensure that all safety signs are installed and legible.
• Make certain everyone is clear of machine before
starting engine and during operation.
• Keep riders off the machine.
• Keep all shields in place, and stay clear of moving parts.
• Disengage header drive, put transmission in Neutral,
and wait for all movement to stop before leaving
operator’s position.
• Shut down the engine and remove the key from ignition
before servicing, adjusting, lubricating, cleaning, or
unplugging machine.
• Engage safety props to prevent lowering of header or
reel before servicing in the raised position (refer to the
header operator’s manual).
• Use slow moving vehicle emblem and flashing warning
lights when operating on roadways unless prohibited
by law.
Figure 1.9: MD #113482
MD #166466
High pressure oil hazard
WARNING
• Do not go nearleaks.
•Highpress
ure oil easily punctures skin causing serious
injury, gangrene, or death.
• If injured, seek emergency medical help. Immediate
surgery is required to remove oil.
• Do not use finger or skin to check for leaks.
• Lower load or relieve hydraulic pressure before
looseningfittings. Figure 1.10: MD #166466
169456_SUPPLEMENT 5Revision D
SAFETY
MD #171281
Hot fluid under pressure
CAUTION
• Coolant is under pressure and may be hot. Never
remove radiator cap when engine is hot.
Figure 1.11: MD #171281
MD #171286
Lock pull-type hydraulic for transport
WARNING
• Charge cylinder with oil before towing.
• Rotate valve handle to lock in transport position.
• Maximum towing speed 20 mph (32 km/h).
• Failure to comply could result in death or serious injury.
Figure 1.12: MD #171286
MD #171298
PT transport lock pin
WARNING
• Transport lock pin must be in place before transport.
• Failure to comply could result in death or serious injury.
Figure 1.13: MD #171298
169456_SUPPLEMENT 6Revision D
SAFETY
MD #174432
Reel hazard
WARNING
• To avoid injury from fall of raised reel; fully raise
reel, stop the engine, remove the key, and engage
mechanical lock on each reel support arm before
working on or under reel.
• Refer to operator’s manual.
Figure 1.14: MD #174432
MD #174434
Header hazard
DANGER
• Rest header on ground or engage mechanical locks
before going under unit.
Figure 1.15: MD #174434
MD #174436
High pressure oil hazard
WARNING
•Donotg
o near leaks
•Highp
ressure oil easily punctures skin causing serious
injury, gangrene, or death.
•Ifinj
ured, seek emergency medical help. Immediate
surgery is required to remove oil.
•Dono
tusefinger or skin to check for leaks.
• Lower load or relieve hydraulic pressure before
loosening fittings. Figure 1.16: MD #174436
169456_SUPPLEMENT 7Revision D
SAFETY
MD #184371
Open drive hazard
WARNING
• Guard missing. Do not operate.
• Keep all shields in place.
Figure 1.17: MD #184371
MD #184372
General hazard pertaining to machine operation
and servicing
CAUTION
To avoid injury or death from improper or unsafe
machine operation:
• Read the operator’s manual and follow all safety
instructions. If you do not have a manual, obtain one
from your Dealer.
• Do not allow untrained persons to operate the machine.
• Review safety instructions with all Operators annually.
• Ensure that all safety signs are installed and legible.
• Make certain everyone is clear of machine before
starting engine and during operation.
• Keep riders off the machine.
• Keep all shields in place and stay clear of moving parts.
• Disengage header drive, put transmission in Neutral,
and wait for all movement to stop before leaving
operator’s position.
• Shut off the engine and remove the key from ignition
before servicing, adjusting, lubricating, cleaning, or
unplugging machine.
• Engage safety props to prevent lowering of raised unit
before servicing in the raised position.
• Use slow moving vehicle emblem and flashing warning
lights when operating on roadways unless prohibited
by law.
Figure 1.18: MD #184372
169456_SUPPLEMENT 8Revision D
Andere Handbücher für R85
10
Inhaltsverzeichnis
Andere MacDon Landwirtschaftliche Geräte Handbücher
MacDon
MacDon C Series Bedienungsanleitung
MacDon
MacDon R113 Bedienungsanleitung
MacDon
MacDon M155 Bedienungsanleitung
MacDon
MacDon M1170 Stücklistenhandbuch
MacDon
MacDon A40-D Bedienungsanleitung
MacDon
MacDon D50 Bedienungsanleitung
MacDon
MacDon 5000 Bedienungsanleitung
MacDon
MacDon FlexDraper FD1 Series Stücklistenhandbuch
MacDon
MacDon M155 Bedienungsanleitung
MacDon
MacDon A40-D Bedienungsanleitung
MacDon
MacDon TM100 Bedienungsanleitung
MacDon
MacDon M100 Bedienungsanleitung
MacDon
MacDon FlexDraper FD1 Series Bedienungsanleitung
MacDon
MacDon D1X Series Bedienungsanleitung
MacDon
MacDon M2170NT Bedienungsanleitung
MacDon
MacDon R216 Bedienungsanleitung
MacDon
MacDon R113 SP Bedienungsanleitung
MacDon
MacDon M1170NT5 Bedienungsanleitung
MacDon
MacDon M105 Bedienungsanleitung
MacDon
MacDon DWA Leitfaden
