A. FUNCTIONS
1. The Sensor Switch detects motion and turns on lights for an adjustable duration of time. The
built-in photocell can be adjusted to turn off light automatically. It is ideal for home automa-
tion and energy saving purposes.
2. Detection angle is 120° and the maximum detection distance is up to 8 metres.
3. Selectable OFF, ON, AUTO modes for your convenience.
4. The Sensor Switch should be used with incandescent or halogen lights.
5. Installation is as easy as replacing a wall switch.
6. Some countries may require installation by a qualified electrician.
B. CONNECTIONS
1. Turn power off at the circuit breaker before wiring.
2. Remove the existing switch.
3. Note: The installation requires neutral.
4. Connect the Sensor Switch according to the wiring diagram in Diagram A.
5. Remove the surface cover of the Sensor Switch with a screwdriver (see Diagram B), and undo
the A-screws from the frame (see Diagram A).
6. Mount the Sensor Switch into the wall box with the existing screws. Replace the frame.
Instruction Manual Motion Sensor Wall Switch
Model: EFE700PIR 19 046 67(8)
7. For testing purposes, use a small screwdriver to set the time control at (-) position and set the
Lux control at ( ) position (see Diagram C).
8. Refit the surface cover by hand.
9. Set the mode switch to AUTO mode (see Diagram D).
10. Turn the power and the loading light(s) on. The Sensor Switch enters a warm-up period. After
about 40 seconds, the loading light(s) goes off and the Sensor Switch enters in AUTO mode.
11. If any motion is detected, the loading light(s) will be turned on. The light(s) will go off after
(10±5) seconds if no further motion is detected.
Surface
cover
A-screws
Motion sensor
Wiring diagram
Diagram A Diagram B
Screwdriver
Frame
TJ-JA/JZ-120926
