Metra Electronics MPS-GEN02 Bedienungsanleitung

INSTALLATION INSTRUCTIONS

MPS-GEN02

Attention! Let the vehicle sit with the key

out of the ignition for a few minutes before

removing the factory radio. When testing the

aftermarket equipment, ensure that all factory

equipment is connected before cycling the

key to ignition.

KIT FEATURES

• Universal design for gauge-mount radios

• Replaces upper pocket

• Textured to match factory ﬁnish

KIT COMPONENTS

• A) Blank plate • B) Phillips screws (8)

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• 1/8” drill bit

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Assembly ..........................................................3

A B

Polaris General 2016-Up

Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle

speciﬁc applications

MetraOnline.com

DASH DISASSEMBLY

1. Remove the storage pocket from the

upper dashboard. (Figure A)

Continue to Kit Assembly

(Figure A)

REV. 2/12/2020 INSTMPS-GEN02 3

KIT ASSEMBLY

1. Install the radio to the blank panel

following instructions provided with

the radio.

2. Complete all necessary connections to

the radio, then test the radio for proper

operation. Use Metra part number 44-

UA20 (sold separately) for an antenna.

3. Slide the radio assembly into the dash.

Pre-drill (8) pilot holes in the dash

using a 1/8” drill bit. Using a manual

screwdriver, secure the radio assembly

to the dash using (8) Phillips screws

provided. Do not overtighten! (Figure A)

(Figure C)

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

Metra recommends MECP

certiﬁed technicians

INSTALLATION INSTRUCTIONS

MPS-GEN02

If you are having difﬁculties with the installation

of this product, contact our Tech Support line

either by phone at 386-257-1186, or email at

techsupport@metra-autosound.com. Before

doing so, look over the instruction booklet a

second time and ensure that the installation was

performed exactly as the instruction booklet

is stated. Have the vehicle apart and ready to

perform troubleshooting steps before contacting

Metra/Axxess Tech Support.

Andere Metra Electronics Rack & Stand Handbücher

Metra Electronics

Metra Electronics 99-5839CH Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung