Midland XT-70 Handbuch

* Depending on terrain

12Km*

up to

XT·70

DUAL BAND (PMR446/LPD)WALKIE-TALKIE

›Instruction Guide

XT70 user’s manual | 1

Content of the package

• 2 transceivers with belt clip

• 1 USB cable

• 1 double fast desktop charger

• 2 rechargeable battery packs 1000mAh

• 2 earphone mikes MA21L

Coverage (referred to PMR frequency band)

The maximum range depends on terrain condition and is obtained during use

in an open space.

The only limitation to maximum possible range are environmental factors such

as blockage caused by trees, buildings, or other obstructions. Inside a car or a

metallic constructions, the range can be reduced. Normally the coverage in

the city, with buidings or other obstructions is about 1 or 2 Km. In open space

but with obstructions like trees, leafs or houses the maximum possible range is

about 4-6 Km. In open space, without obstructions and in sight, like for exam-

ple in mountain, the coverage can be 12 Km.

2 | XT70 user’s manual

Main functions

• Dual Band LPD/PMR transceiver

Channels: 24 PMR446 (8+16 pre-programmed) + 69 LPD

• Side Tone: end transmission noise muer

• Wide LCD display with backlight

• Low battery indicator

• Auto power save: automatic current economy circuit

• 38 CTCSS and 83 DCS tones in TX and RX

• CALL button with 5 tones selectable

• Battery life up to 17 hours

• Fast charger (4h)

• Monitor function

• BAby Sitter function

• Buttons for the channel selection

• Knob for volume adjustement

• Out of range function (automatic or manual)

• SCAN function

• Keypad lock

• Hi/low power selection (PMR band)

• Roger Beep on/o

• VOX for hands-free communications with 9 selectable levels

• 2 Pin jack for ext. mike / ext. speaker

• USB port to recharge the radio

The manufacturer, with its eort to constantly improve product quality, reserves

the right to change characteristics and features without prior notice.

XT70 user’s manual | 3

Above all….Safety!

Warnings

! Do not open the radio for any reason! The radio’s precision mechanics and

electronics require experience and specialized equipment; for the same reason,

the radio should under no circumstances be realigned as it has already been

calibrated for maximum performance. Unauthorized opening of the transcei-

ver will void the warranty.

! Do not use detergents, alcohol, solvents, or abrasives to clean the equipment.

Just use a soft, clean cloth. If the radio is very dirty, slightly dampen the cloth

with a mixture of water and a neutral soap.

Batteries

! Do not try to charge alkaline batteries or non rechargeable batteries. Make

sure that when you charge the radio, only rechargeable NI-MH batteries

should be contained in the battery compartment! It is very dangerous at-

tempting to recharge other types of batteries (for example alkaline or man-

ganese batteries). Batteries which are not suitable to be recharged may leak,

explode or even burn and cause damage!

! Using a dierent battery charger other than the one speciﬁed can cause da-

mage to your device or may even cause explosions and personal injuries.

! Do not throw batteries into ﬁre or place them near heat as this may cause ex-

plosions or personal injuries. Dispose of the batteries according to procedures

set out by local regulations.

! Do not mix old and new batteries or batteries of dierent types or batteries

which have been used in dierent manners.

4 | XT70 user’s manual

Identifying the parts

CALL MENU MON

SCAN

XT70

DCSCTCSS

CALL MENU MON

SCAN

XT70

DCSCTCSS

CALL MENU MON

SCAN

XT70

DCSCTCSS

3 4 5

CALL MENU MON

SCAN

XT70

DCSCTCSS

XT70 user’s manual | 5

LCD Display

1. Selected channel (P1-P8/9P-24P: PMR446 /1-69:LPD)

2. VOX - Function activated

3. - Keypad lock activated

4. H/L - Indicates the high / low power selection in transmission (only in

PMR band)

5. - Battery status indicator

6. RX - Radio in rx mode (busy channel)

7. TX - Radio in transmission (PTT pressed)

8. - It appears when you are operating with the Out of range function

9. DCS/CTCSS - Type of sub-audio tone selected

10. Code of the selected CTCSS or DCS tone

(CTCSS: 1-38; DCS: 1-83)

11. - It is shown when the Baby Sitter function is active

Transceiver

12. Antenna

13. OFF/VOLUME knob - To switch on/othe radio and to adjust the vol-

ume.

14. MENU - Press this control to enter the radios menu

15. CALL/ – to send a call to the selected channel. If you keep it pressed for

about 3 seconds, the keypad lock is activated.

16. ▲/ -▼ controls - To change the settings in the menu. If you keep pres-

sed ▲/ you manually verify if there are some radios within the range

(manual Out of range function).

17. MIC - Built-in microphone

18. Built-in Speaker.

19. MON/SCAN - Press this button once to activate SCAN. Keep it pres-

sed for about 2 seconds to activate the Monitor function, that tempora-

rily cuts othe squelch (for weak signals)

20. PTT - Press to transmit.

21. USB port for the recharge of the radio

22. SPK | MIC (under the protective cover) - To connect to external audio

devices such as microphones, headphones, etc

23. Battery compartment: insert the rechargeable battery pack supplied in

the package or 3 x AA batteries (alkaline or rechargeable).

6 | XT70 user’s manual

Preparing the transceiver

The radio can be recharged with dierent type of batteries: here below the

possibilities.

Note: To optimize the recharge process, we suggest you switch othe radio to

recharge it.

Recharging the NIMH batteries (3 x AA)

Place your transceiver into the cradle of the desktop charger or connect the

USB cable to the proper jack of the radio.

This type of batteries is recharged with a constant current, either you use a

desktop charger or a USB cable; therefore the recharge time depends from

the recharge status and from the batteries capacity.

There’s no evidence when the recharge is ﬁnished, therefore we suggest you

detach the USB cable from the radio or remove XT70 from the desktop char-

ger cradle once the recharge is complete.

Recharging the NIMH battery pack PB-X7

1000mAh

Place your transceiver into the cradle of the desktop charger or connect the

USB cable to the proper jack of the radio.

This type of batteries is recharged with a constant current, therefore a comple-

te recharge takes about 4 hours.

There’s no evidence when the recharge is ﬁnished, therefore we suggest you

detach the USB cable from the radio or remove XT70 from the desktop char-

ger cradle after 4 hours.

XT70 user’s manual | 7

Installing/removing the battery pack

1. Remove the belt clip;

2. Open the battery compartment as shown in picture 1;

3. Remove or insert the battery pack;

4. Close the battery cover and ﬁx the belt clip.

PICTURE 1

8 | XT70 user’s manual

Basic operations

Turning on/o

To turn on the transceiver, turn the VOLUME knob clockwise until you hear it

clicks: the LCD display will light up and do an Auto-Test. Subsequently you will

hear 2 beeps of dierent tones.

To turn othe transceiver, turn the knob counter-clockwise until you hear

another click.

Volume control

Turn the knob VOLUME to about half way and adjust it to a comfortable level

as soon as you receive a signal. If you do not receive a signal you can use the

button MON/SCAN described in par. “MON button”.

Displaying the channel/sub audio tone

To momentarily display the PMR446 channel and the subadio tone used in the

pre-set channels, go to the desired channel (from 9p to 24p) and keep pressed

the ▼for 3 seconds.

Transmission and reception

When you press the PTT the transceiver transmits with high or low power (de-

pending on the setting of the MENU: Hor L).

To transmit:

1. Make sure that no one else is currently talking on the selected channel;

2. Keep button PTT ﬁrmly pressed: TX and To will appear on the display (if

you have set a CTCSS tone, To wan’t be displayed;

3. Before you start talking wait for a fraction of a second then speak normal-

ly, in the direction of the microphone.

4. When you have ﬁnished, release the PTT: TX and To will disappear from

the display;

5. When the radio is in reception mode (PTT not pressed) you will automa-

tically receive any communication (RX displayed).

During transmission and reception try, as far as possible, to keep the antenna in

vertical position and to avoid obstacles towards the direction of the other party.

XT70 user’s manual | 9

Transmitting TOT Setting

The TOT function is used to prevent a too long transmission. This function

temporarily blocks transmissions if the radio has been used beyond the

maximum time permitted. Once reached the preset timer (1 minute), the radio

will be forced in reception mode.

MON button (Monitor)

The Monitor button is for temporarily excluding (opening) the squelch, in order

to listen to signals that are too weak to keep the squelch permanently opened.

By excluding the squelch you will avoid listening the communication “chopped”

by the squelch. In order to activate the Monitor function, so as to listen to

all trac on the selected channel, keep pressed the MON/SCAN button for

about 3 seconds. Keep pressed the button MON/SCAN for about 3 seconds

to disable this function.

Scanning all channels

XT70 can automatically search for signals throughout the PMR/LPD bands by

scanning, i.e. selecting the channels in rapid sequence.

Press brieﬂy the button MON/SCAN to start scanning.

When a signal is detected, the scanning pauses on that channel and you can

transmit by pushing PTT . The scroll buttons ▲/▼ allow you to change the

direction of scanning (from lower channels to higher ones or vice versa) and

therefore to skip communications which are of no interest.

If you want to stop it, press again MON/SCAN. Your transceiver will go back

to the channel from which the scanning originally started.

Display backlight

If there is insucient light to read the display you can press the MENU button

to switch the display back light on for about 5 seconds.

Switching the backlight on the display adds an additional drain on the batteries.

Try to make a moderate use of this.

Keypad lock

Keep pressed CALL/ for about 3 seconds and will be displayed as conﬁr-

mation. Only PTT and CALL/ remain active. To disable this function, keep

pressed again CALL/ for 3 seconds approx.

Andere Handbücher für XT-70

Inhaltsverzeichnis

Andere Midland Zwei-Wege-Funkgerät Handbücher

Midland

Midland ALAN 95 D80 PLUS Bedienungsanleitung

Midland

Midland 210 DS Bedienungsanleitung

Midland

Midland X-TRA TALK LXT110 Series Bedienungsanleitung

Midland

Midland ProLine PL5161 Bedienungsanleitung

Midland

Midland x-talker t70 series Bedienungsanleitung

Midland

Midland LXT114 Series Bedienungsanleitung

Midland

Midland BIZTALK BR200 Bedienungsanleitung

Midland

Midland GXT300 Series Bedienungsanleitung

Midland

Midland X-Talker ALR2 Series Bedienungsanleitung

Midland

Midland GXT895 series Bedienungsanleitung

Midland

Midland PMR446/LPD Bedienungsanleitung

Midland

Midland K-10 Bedienungsanleitung

Midland

Midland SP-400 Series Bedienungsanleitung

Midland

Midland 777 Bedienungsanleitung

Midland

Midland ML3215 Bedienungsanleitung

Midland

Midland LXT114VP Bedienungsanleitung

Midland

Midland MICRO MOBILE MXT115V Bedienungsanleitung

Midland

Midland HP108 Bedienungsanleitung

Midland

Midland X-Talker T10 Bedienungsanleitung

Midland

Midland NAUTICO 1 Bedienungsanleitung

Midland

Midland ALAN 255 ESP E40 Bedienungsanleitung

Midland

Midland Micro Mobile MXT105 Bedienungsanleitung

Midland

Midland C1179 Handbuch

Midland

Midland ALAN 235 ESP D80 Bedienungsanleitung

Beliebte Zwei-Wege-Funkgerät Handbücher anderer Marken

HYT

HYT TC700 Bedienungsanleitung

DNT

DNT Space100 Bedienungsanleitung

Legacy

Legacy ProLine Series Bedienungsanleitung

Evolveo

Evolveo FreeTalk XM2-2 Bedienungsanleitung

AWC

AWC AWR1688+ Bedienungsanleitung

Motorola

Motorola XT665d Bedienungsanleitung

Cobra

Cobra 2-Way Radio Bedienungsanleitung

Klutch

Klutch KR-400 Bedienungsanleitung

Garmin

Garmin Rino 655t Bedienungsanleitung

Motorola

Motorola TLK 150 Bedienungsanleitung

Titan

Titan TR200 Bedienungsanleitung

Cobra

Cobra CXT645 Bedienungsanleitung

Tait

Tait TM9100 Bedienungsanleitung

Yaesu

Yaesu FT-65R Bedienungsanleitung

Motorola

Motorola ASTRO SRX 2200 Series Bedienungsanleitung

Motorola

Motorola T5583 Bedienungsanleitung

Motorola

Motorola DTR410 - On-Site Digital Radio Betriebsanleitung

Motorola

Motorola PRO7550 Bedienungsanleitung