Miele CS 1212 Bedienungsanleitung

Installation Instructions

CS 1212 I, CS 1221 I en - CA

Installation, repair and maintenance work should be performed by

a Miele authorized service technician in accordance with national

and local safety regulations and the provided installation instructions.

Note to the installer:

Please leave this instruction book

with the consumer for the local

electrical inspector’s use.

The minimum distances given in

these Installation Instructions must

be observed in order to ensure safe

operation. Failure to do so increases

the risk of fire.

The cabinetry and venting hood

should be installed first to prevent

damage to the appliance.

~The countertop must be bonded

with heat resistant (212 °F/100 °C)

adhesive to prevent distortion or

dissolving.

Any back splashes must be

heat-resistant as well.

~The appliance must not be installed

over a dishwasher, washer, dryer,

refrigerator or freezer. Heat radiated by

the appliance may damage them.

~To eliminate the risk of burns or fire

by reaching over heated surfaces

cabinet storage space above the

appliance should be avoided. If cabinet

storage is necessary, the risk can be

reduced by installing a venting hood to

project horizontally a minimum of 5"

(127 mm) beyond the bottom of the

cabinets.

~This appliance has not been

designed for maritime use or for use in

mobile installations such as recreational

vehicles or aircraft. However, under

certain conditions it may be possible for

installation in these applications. Please

contact the Miele Technical Service

Department with specific requirements.

~You must ensure the power cord for

the appliance will not be subject to any

mechanical strain after installation.

~If a protective base is installed

beneath the appliance, a minimum

distance of 1 9/16" (40 mm) between the

top of the protective base and the

bottom of the appliance must be

maintained.

~The appliance must not be

permanently sealed into the countertop

when installed. The sealing strip under

the edge of the appliance provides a

sufficient seal for the countertop. See

"Sealing".

Keep this instruction book in a safe

place for reference and pass it on to

any future user.

SAFETY INSTRUCTIONS FOR INSTALLATION

Safety distances above the

appliance

The minimum safety distance given by

the hood manufacturer must be

maintained between the combiset and

the hood above it. See the installation

instructions of the hood for these safety

measurements.

If the hood manufacturers instructions

are not available or if flammable objects

are installed over the combiset (e.g.

cabinets, utensil rail, etc.), a minimum

safety distance of 30" (760 mm) must

be maintained.

If there is more than one appliance

beneath a hood (e.g. wok burner

and electric combiset), and they

have different minimum safety

distances always observe the

greater distance.

SAFETY INSTRUCTIONS FOR INSTALLATION

Safety distances to the sides

of the appliance

The appliance should only be installed

as shown in the illustrations, while

maintaining the required safety

distances shown. Do not install the

appliance between two tall cabinets,

this is a fire hazard.

A distance of at least 2" (50 mm) must

be kept between the countertop cut-out

and the rear wall because of the high

temperatures radiated.

The minimum distance abetween the

worktop cut-out and a wall or tall unit to

the right or left of it is:

2" (50 mm) for CS 1112

CS 1122

CS 1212

CS 1221

CS 1223

CS 1326

CS 1411

6" (150 mm) for CS 1312

CS 1322

CS 1421

10" (250 mm) for CS 1011

CS 1012

CS 1028

recommended

not recommended

not permitted

SAFETY INSTRUCTIONS FOR INSTALLATION

2 " (50 mm)

(50mm)

Safety distance from the wall covering

If a wall covering is installed, a minimum safety distance must be maintained

between the countertop cut-out and the covering, since high temperatures can

damage these materials.

If the covering is made of a combustible material (such as wood), the distance

between the countertop cut-out and the wall covering must be a minimum of

2" (50 mm).

For coverings made of non-combustible materials (such as metal, marble,

granite, ceramic tiles) the minimum safety distance ebetween the countertop

cut-out and the wall covering must be 2" (50 mm) minus the thickness of the

covering.

For example: thickness of wall covering 9/16" (15 mm)

2" (50 mm) - 9/16" (15 mm) = minimum safety distance 1 3/8" (35 mm).

aWall frame

bWall covering

x= thickness of the wall covering

cCountertop

dCountertop cut-out

eMinimum safety distance

with flammable materials 2" (50 mm)

with non-flammable materials 2" (50 mm) minus x

Installation

Installation dimensions

CS 1212

aSpring clips

bAppliance front

cInstallation height

dPower supply cable (encased in flexible metal conduit),

L=783/4" (2000 mm)

eData plate

Installation

CS 1221

aSpring clips

bAppliance front

cInstallation height

dPower supply cable (encased in flexible metal conduit),

L=783/4" (2000 mm)

eData plate

Installation

Cut out

^Make the worktop cut-out for one or

more appliances as applicable.

Remember to maintain a minimum

safety distance from the back wall,

as well as from any tall unit or side

wall to the right or left of the

appliance(s).

See also "SAFETY INSTRUCTIONS

FOR INSTALLATION".

^Seal the cut surfaces with a suitable

sealant to avoid swelling caused by

moisture.

The materials used must be heat

resistant.

If during installation the seal around

the frame does not sit flush with the

countertop in the corners, the corner

radius, maximum 3/16" (4 mm), can

be carefully filed down to fit.

Installation

Installation of multiple

appliances

When installing more than one combiset appliance, a support bar bmust be

installed between the appliances.

Countertop cut-out

two appliances

For the installation of two appliances

the width of the countertop cut-out D is

the sum of A and C.

A,Band C= appliance widths

11 5/16", 15" or 22 11/16"

(288 mm, 380 mm or 576 mm)

minus 5/16"(8mm)to allow for the

overhang

D= width of the countertop cut-out

Countertop cut-out

three appliances

For the installation of three appliances

the width of the countertop cut-out D is

the sum of A and B and C.

If more than three appliances are

being installed, you will need to add,

A, B or C for each additional

appliance.

Installation

Sample calculations for a countertop cut-out for three appliances

appliance width

minus 5/16"(8mm)

appliance width

minus 5/16"(8mm)

Countertop

cut-out

11"

(280 mm)

11 5/16"

(288 mm)

11"

(280 mm)

33 3/8"

(848 mm)

11"

(280 mm)

15"

(380 mm)

14 5/8"

(372 mm)

40 5/8"

(1032 mm)

11"

(280 mm)

22 11/16"

(576 mm)

22 3/8"

(568 mm)

56 1/16"

(1424 mm)

14 5/8"

(372 mm)

11 5/16"

(288 mm)

11"

(280 mm)

37"

(940 mm)

14 5/8"

(372 mm)

15"

(380 mm)

14 5/8"

(372 mm)

44 1/4"

(1124 mm)

14 5/8"

(372 mm)

22 11/16"

(576 mm)

22 3/8'

(568 mm)

59 11/16"

(1516 mm)

22 3/8"

(568 mm)

11 5/16"

(288 mm)

11"

(280 mm)

44 3/4"

(1136 mm)

22 3/8"

(568 mm)

15"

(380 mm)

14 5/8"

(372 mm)

52"

(1320 mm)

22 3/8"

(568 mm)

-22

3/8"

(568 mm)

44 3/4"

(1136 mm)

Installation

Andere Handbücher für CS 1212

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Miele Kochfeld Handbücher

Miele

Miele KM 2357 Bedienungsanleitung

Miele

Miele CS 1112 Bedienungsanleitung

Miele

Miele KM 6118 Bedienungsanleitung

Miele

Miele KM 6520 FR Bedienungsanleitung

Miele

Miele KM 371 G Bedienungsanleitung

Miele

Miele KM 454 Bedienungsanleitung

Miele

Miele KM 2014 Bedienungsanleitung

Miele

Miele KM 3054-1 Bedienungsanleitung

Miele

Miele KM 7564 FR Bedienungsanleitung

Miele

Miele KM 3054 Bedienungsanleitung

Miele

Miele KM 523 Technisches Datenblatt

Miele

Miele KM 456 Bedienungsanleitung

Miele

Miele KM 5987 Bedienungsanleitung

Miele

Miele KM 5864 Bedienungsanleitung

Miele

Miele KM 3014 Bedienungsanleitung

Miele

Miele KM 6113 Bedienungsanleitung

Miele

Miele KM 360 G Bedienungsanleitung

Miele

Miele KM 6389 Bedienungsanleitung

Miele

Miele KM 6389 Bedienungsanleitung

Miele

Miele GAS COMBISET CS 1012 Bedienungsanleitung

Miele

Miele KM 371 G Bedienungsanleitung

Miele

Miele KM 417 Bedienungsanleitung

Miele

Miele CS 1326 Technisches Datenblatt

Miele

Miele CS 1134 Bedienungsanleitung

Beliebte Kochfeld Handbücher anderer Marken

Siemens

Siemens EX875KYV1E Technisches Datenblatt

AEG

AEG CERAMIC HOB 6010 K Bedienungsanleitung

VALERA

VALERA CT 70A Bedienungsanleitung

Zanussi

Zanussi ZGF 6420 Bedienungsanleitung

Gaggenau

Gaggenau CI 273 Bedienungsanleitung

G3 Ferrari

G3 Ferrari Energy Bedienungsanleitung

Pkm

Pkm IN4B Bedienungsanleitung

Award

Award H903BG Bedienungsanleitung

Zanussi

Zanussi VCH 5005 RZ Bedienungsanleitung

Hotpoint

Hotpoint IS67V8CCXT/E Bedienungsanleitung

AEG

AEG HK854870XB Bedienungsanleitung

Cookology

Cookology SEP600BK Bedienungsanleitung

Bauknecht

Bauknecht Hob Bedienungsanleitung

Zanussi

Zanussi ZGM 782 Bedienungsanleitung

dipo INDUCTION

dipo INDUCTION DIBK218S Bedienungsanleitung

Blomberg

Blomberg MKN 24201 W Bedienungsanleitung

Progress

Progress PAI3101F Bedienungsanleitung

Hotpoint Ariston

Hotpoint Ariston PKL 641 IX/HA Bedienungsanleitung