RESEARCH AND DEVELOPMENT
5
DISPLAY STATUS AND PROBE TESTS
You can reach this status by pressing the “CAVITY TEMPERATURE” key for long while in the OFF
status. The display shows the chamber probe code “SCA”. By pressing the UP and DOWN keys,
you pass to the heating element probe “SrE” and to the core probe “SSP” Pressing START/STOP
displays the value read by the indicated probe; if the probe is in error, “Err” will appear. By pressing
START/STOP you exit the viewing of the value. You may return to the OFF status by pressing the
START/STOP key or after a 5 second timeout.
FIRMWARE REV DISPLAY STATUS
You can reach this status by pressing the “HOLD” key for long while in the OFF status. The display
alternately shows the firmware version and revision code. You may return to the OFF status by
pressing the ON/OFF key or after a 5 second timeout.
DIAGNOSTICS
CAVITY PROBE MALFUNCTION
The display shows the code Er1.
The cycle in progress is blocked and the buzzer switches on (it can be silenced by pressing a key).
It can be caused by an incorrect connection of the probe or by a failure of the same.
HEATING ELEMENT PROBE MALFUNCTION
The Display shows the code Er2.
The cycle in progress is blocked and the buzzer switches on (it can be silenced by pressing a key).
It can be caused by an incorrect connection of the probe or by a failure of the same.
CORE PROBE MALFUNCTION
The Display shows the code Er3.
The cycle in progress is blocked and the buzzer switches on (it can be silenced by pressing a key).
It can be caused by an incorrect connection of the probe or by a failure of the same.
