Monoprice 9744 Bedienungsanleitung

Maintenance

• Check that the bracket is secure and safe to use at regular intervals(at least every three months).

• Please contact your dealer if you have any questions.

PID 9744

NOTE: Read the entire instruction manual before you start installation and assembly.

WARNING

• Do not begin the installation until you have read and understood the instructions

and warnings contained in this installation sheet. If you have any question

regarding any of the instruction or warning, please contact your local distributor.

• This mounting bracket was designed to be installed and utilized ONLY as

specified in this manual. Improper installation of this product may cause damage

or serious injury.

• This product should only be installed by someone of good mechanical ability,

with basic building experience and fully understanding of this manual.

• Make sure that the supporting surface will safely support the combined load of

the equipment and all attached hardware and components.

• If mounting to wood wall studs, make sure that mounting screws are anchored

into the center of the studs. The use of a stud finder is highly recommended.

• Always use assistant or mechanical lifting equipment to safely lift and position

equipment.

• Tighten screws firmly, but do not over tighten. Over tightening can damage the

items, greatly reducing their holding power.

• This product is intended for indoor use only. Using this product outdoors could

lead to product failure and personal injury.

Component Checklist

IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installing. If

any parts are missing or faulty, telephone your local distributor for a replacement.

Package M

Package W

ST6.3x55 (x3)

W-A

concrete anchor (x3)

W-B

D8 washer (x4)

M-F

D5 washer (x4)

M-E

small spacer (x8)

M-G

M5x14 (x4)

M-B

M6x14 (x4)

M-C

M8x20 (x4)

M-D

M4x14 (x4)

M-A

articulated arm assembly

4mm Allen key (x1)

6mm Allen key (x1)

wrench (x1)

2. Remove the Decorative Covers

1. Separate VESA Plate from Wall Mount

ø 4.5mm

(ø 3/16")

55mm

(2.2")

55mm

(2.2")

WARNING

• Make sure that mounting screws are anchored into the center of the studs. The use of a stud

finder is highly recommended.

• Installers are responsible to provide hardware for other types of mounting situations.

• Installers must verify that the supporting surface will safely support the combined load of the

equipment and all attached hardware and components.

3a. Mount on Wood Stud Wall

Drill pilot holes

Screw the wall

mount onto

the wall

X X

√

W-A

Find and mark the

exact location of

mounting holes

· Loosen the upper nut.

· Then remove the lower flat nut.

Remove the VESA plate.

4. Install Decorative Covers

5. Install VESA Plate

X X

√

3b. Mount on Solid Brick and Concrete Block

Drill pilot holes

Screw the wall

mount onto

the wall

60mm

(2.4")

60mm

(2.4")

ø 10mm

(ø 3/8")

Mark the exact

location of

mounting holes

Mark the exact

location of

mounting holes

Mark the exact

location of

mounting holes

Top of the TV

W-B

W-A

Installers must verify that the supporting surface will safely support the combined weight of

the equipment and all attached hardware and components.

WARNING

Tighten all screws but do not over tighten.

Screw VESA plate onto the TV.

6. Hooking the TV onto the Wall Mount

· Level the TV.

· Place the lower flat nut and tighten both nuts.

Loosen the upper nut leaving

a 4mm space to the VESA plate.

Hooking the TV onto the wall mount

4mm

M-A/M-B

M-C/M-D

M-E

M-F

M-D

M-F

M-G

M-D

M-F

M-G

FOLD 3

DUST

CHER

7. Tension Adjust

Please keep the arm level during tension adjustment. Use a proper Allen key to slightly loosen or tighten the

adjustment screw according to the display weight.

If display settles on its own, rotate adjustment screw towards the "+" symbol.

If display rises on its own, rotate adjustment screw towards the "-" symbol.

8. Cable Management

Connect the cables to the display, and press cable cover inward to route

the cables through the space.

Note: Leave slack in the cable for cantilever arm movement. Adjust to the desired position or tilt.

9. Adjustment

height adjustable

max335mm

+15°

-15°

180°

+3° -3°

Please tighten the socket set screw if the

joints make popping sounds during use.

Tighten the screws untill the display angle is fixed.

Inhaltsverzeichnis

Andere Monoprice Rack & Stand Handbücher

Monoprice

Monoprice 9744 Bedienungsanleitung

Monoprice

Monoprice 39497 Bedienungsanleitung

Monoprice

Monoprice 27773 Bedienungsanleitung

Monoprice

Monoprice 11410 Bedienungsanleitung

Monoprice

Monoprice 34539 Bedienungsanleitung

Monoprice

Monoprice 34540 Bedienungsanleitung

Monoprice

Monoprice MLB-108B Bedienungsanleitung

Monoprice

Monoprice 34542 Bedienungsanleitung

Monoprice

Monoprice Adjustable Tilt/Flat Panel Bedienungsanleitung

Monoprice

Monoprice MLB-110B Bedienungsanleitung

Monoprice

Monoprice 16355 Bedienungsanleitung

Monoprice

Monoprice 5754 Bedienungsanleitung

Monoprice

Monoprice 39305 Bedienungsanleitung

Monoprice

Monoprice MHA-800 Bedienungsanleitung

Monoprice

Monoprice 21648 Bedienungsanleitung

Monoprice

Monoprice PID 3874 Bedienungsanleitung

Monoprice

Monoprice 44896 Bedienungsanleitung

Monoprice

Monoprice 24588 Bedienungsanleitung

Monoprice

Monoprice WorkStream 36083 Bedienungsanleitung

Monoprice

Monoprice 13815 Bedienungsanleitung

Monoprice

Monoprice 16102 Bedienungsanleitung

Monoprice

Monoprice 13816 Bedienungsanleitung

Monoprice

Monoprice Commercial Series Bedienungsanleitung

Monoprice

Monoprice 34303 Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung